Provision of Partition Wall inside P.P. Store Office, dismantling of Unused Iron Ladder on the 1st Floor of 6th Unit Reserve Gear Bldg.(CESCON Bldg.) inside DPL Plant Premises and Renovation of Glazing Works at the Wagon Tippler Control Room at DPPS.

(A) Partition of commercial ply as per design fitted and fixed complete (excluding the supporting framework but including necessary teak wood battens of size 40mmx 25 mm): In Ground Floor (ii) 6mm thick.

Dressed wood work in post, plate, battens etc. fitted & fixed complete (excluding the cost of bolts only, but including the cost of nails, screws etc.) (The quantum should be corrected upto three decimals) (i) Sal: Local.

250 mm thick Brick work with Fly Ash Bricks (250 mm x 125 mm x 75 mm) as per IS 12894:2002 in cement mortar (1:4). a) In superstructure, ground floor.

Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary (Ground floor). (i) With 1:6 cement mortar. (b) 15 mm thick plaster.

Supplying solid flush type doors of commercial quality, the timber frame consisting of top and bottom rails and side styles of well-seasoned timber 65mm wide each and the entire frame fitted with 37.5mm wide battens places both ways in order to make the door of solid core and internal lipping with Garjan or similar wood veneers using phenol formaldehyde as glue etc. complete, including fitting, fixing shutters in position but excluding the cost of hinges and other fittings in ground floor. b) 32 mm thick shutters (single leaf).

Priming one coat on timber or plastered surface with synthetic oil bound primer of approved quality including smoothening surfaces by sand papering etc.

Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc. on the surface, if necessary : a) On timber or plastered surface :With other than hi-gloss of approved quality. iv) Two coats (with any shade except white).

Applying Interior grade Acrylic Primer of approved quality and brand on plastered or concrete surface old or new surface to receive Distemper/ Acrylic emulsion paint including scraping and preparing the surface thoroughly, complete as per manufacturer's specification and as per direction of the EIC. (In Ground Floor). (a) One Coat i) Water based interior grade Acrylic Primer.

Acrylic Distemper to interior wall, ceiling with a coat of solvent based interior grade acrylic primer (as per manufacturer's specification) including cleaning and smoothening of surface. Two Coats.

Iron hasp bolt of approved quality fitted and fixed complete (oxidised) with 16mm dia. rod with centre bolt and round fitting. (c) 300mm long.