Development of Parking on Patel Road Near Gurukripa Hotel

Description of Item

Surface excavation n.exc (not exceeding) 30 cm deep and averaging 15 cm deep and getting out in hard dense soil

Cement Concrete in floor, filling and mass concrete 1:4:8 (40 mm graded aggregates)

Cement Concrete 1:2:4 (20 mm graded) aggregates in floor

Mild steel bars 8mm and 10 mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooking for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips

Stone kerb of roughly squared stones of size 20 cm x 30 cm dressed so that the maximum depression from a straight edge held against the dressed surface shall not exceed 6 mm for top and exposed surfaces of sides and 20 mm for the rest of surface jointed in cement mortar 1:6 and struck flush M&L

Providing reinforced cement concrete type B-1, 1:2:4 (20mm graded aggregates) in precast posts, fencing posts, straining or terminal posts, struts etc. for fencing average sectional area n exc. 100 sq. cm with or without chamfered angles and flat, splayed, rounded or mitred tops as directed and fixed

Providing and fixing of iron grill on frame of 50 mm x 50 mm square pipe and framed with 10 mm Square Bar with 10 cm spacing centre to centre. Height of frame will be 1.20 meter including two coat primer with redoxide and painting two coat with synthetic enamel paint.

Providing and erection of 12 mt high Mast including civil work with 200 W LED flood light fitting and control gear with integral Power tool, weight 340 kg. comprising of 1 section of hot dipped galvanized materials as per BSEN 1SO 1461 thickness 3 mm, dia 100 mm & 360 mm for top and bottom respectively Lightning protection of GI single spike 800 mm at top and at base inside compartment with double internal lock with adequate size of MCB erected on PVC board complete with base plate of 25 mm thick 520 mm dia. and foundation bolts having 4 nos bolts of 24 mm dia, 750 mm long (ENB grade). Anchor plate 445 PCB, including accessories viz (1) Lantern carriage of 50 NB ERW class – B, MS pipe covered with PVC sleeve suitable to carry 250 kg load and up to 6 fittings symmetrically (2) Trailing Copper cable 5 x 2.5 sq mm, EPR insulated PCP Sheathed (3) Double Drum/ 350 kg Winch having gear 53.1, oil bath (SAE90/140) arrangement (4) 2 nos Stainless steel wire ropes 5 mm dia (7/19) breaking load capacity 1450 kg x 2, (5) Integral power tool 3-phase, 0.75 HP 2m/min single spped (6) Feeder pillar fabricated out of 14 SWG CRCA sheet and comprise of incoming MCB 32 A TPN switch, HRC fuses, single dial timer, suitable size of contactors for lighting and power tool 2 nos outgoing, reversing switch for motor (7). The erection of High Mash includes foundation civil work as per enclosed drawing

DEEPAK JAISWAL