Addn/Altn to covered shed, aluminium dooors/windows/ventilators at Bunglow No P-01 (Mall rd) and other sanctioned works under GE (West) JRC

Amount

Taking down chowkhats or frame with shutter w/o taking off shutter from the frame area not exc 1.5 Sqm each all as specified.

Taking down chowkhats or frame with shutter w/o taking off shutter from the frame area exc 1.5 Sqm but n exc 4.00 sqm each all as specified.

S&F powder coated aluminium frame for doors, windows, partitions ,ventilators with one or more rebates including joining cleat for fixing etc complete all as specified.

S&F powder aluminium window and ventilator shutters (Sliding type) without sash bar, aluminium section weighing 0.55 kg/m including necessary joining cleats, glazing clips, rubber packing, anodised aluminium snap beading, screws etc complete all as specified.

S&F powder coated (off white) aluminium door shutters, aluminium section weighing 0.55 kg/ m including necessary joining cleats, glazing clips, ruber neoprene packing, handles 2 Nos in each door, hinges, anodised aluminum snap beading screws etc. complete all as specified.

S&F sheet glass 4.8 mm thick ordinary quality to be fixed in Al frame work in square exc 0.5 sqm in each pane

S&F galvanized mild steel wire cloth 0.56mm nominal dia of wire and average width of aperture 1.18mm, fixed with tinned tacks or galvanized wire staples complete all as specified as directed.

S&F Framed work such as grills, gratings, etc with ends of bars shouldered and/or riveted, or forged into spikes; framed guard bars; barred iron doors; ladders; framed balusters; walk ways; railings; framework of water tanks and similar work conforming to Fe.290 Gde-E-165

M&L Excavating in post holes (or similar holes) each n exc 0.5 cum, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm, in hard dense soil

M&L for Cutting holes in brick walls in cement mortar exc half brick but not exc one brick wall for inserting holdfasts and making good dismantled portion in cement mortar 1:3 or cement concrete 1:2:4 Type B-1 as required

M&L Cutting chases in brickwork, pinning in making good to facings where required and pointing in cement mortar 1:3 to ends or edges of landings, steps, cills, sunshades, shelves, lintels, etc and cutting chases for concealed water tubing or concealed conduit wiring, etc, and making good, cutting not exc 10 cm girth complete

M & L for PCC (1:2:4) type B-0 (using 12.50 mm graded crushed stone aggregates) lean concrete as in foundation, filling and mass concrete of post complete all as specified.

S&F rolled sections as in main and cross beams, hip and jack rafters, purlins where connected to common rafters and running rails and guides for sliding doors fixed with angle cleats or other connecting plates confirming to grade Fe-410-W complete all as specified and directed.

S&F pre-painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of an colour having tensile strength of 550 Mpa as in roof covering / cladding to wall, fixed with self tapping screws as specified.

S&F pre-painted galvalume aluminum zinc coating GI based corrugated steel sheet curved downwards 300 mm at the end, 0.50mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws as specified.

M&L for preparing and applying one coat of red oxide primer and two coats of synthetic enamel paint over new steel surfaces of any description, over 10cm in width or girth

M& L Cement concrete type D-2, 1:4:8 using 40mm graded aggregate in foundations filling and mass concrete complete

M&L for Exterior grade coloured designer Full body tiles 600 x 600 x 10 mm thick (square/rectangular) polished as in floors etc, set and jointed in neat cement slurry and pointed with white or coloured cement to match with colour of the tiles over and including screed bed of 15 thick cement mortar (1:6) complete all as specified and as directed and as per sample approved.

M&L brickwork with subclass `B' bricks straight or curved on plan exc 6 m mean radius built in CM 1:6

M&L for rendering 15mm thick on fair faces of brick work or concrete surfaces in CM 1:4 finished even and smooth w/o using extra cement all as specified and directed.

M&L for 25 mm thick granite machine cut as incooking platform bedded and jointed with grey cement slurry and pointed with white cement with admixture of pigment to match the shade of granite stone laid over bedding layer or screed 15 mm thick screed bed in cement mortar 1:4 including cutting , grinding, rounding edges, rubbing and polishing complete all as complete all as specified and directed by Engr-in-Charge.

Dismantling of old damage/unserviceable window type air conditioner removing from site of work and shifting to RAC yard complete all as specified and directed by Engr-in-Charge

Dismantling of old damage/unserviceable desert cooler/water cooler removing from site of work and shifting to RAC yard complete all as specified and directed by Engr-in-Charge

Supply, installation, comissioning of Desert Coolers electric driven (single phase) 50Hz, 230 Volts of nominal capacity 4000CFM/Hrs with copper winding motor incl galvnised steel sheet body with Zinc coated complete all as specidied and directed by Engr-in-Charge.

Supply, installation, comissioning of window type air conditioner electric drivne (single phase) cooling capacity 4500K cal per hour 1.5 Ton (Hot & Cold) , BEE 5 Star Rates complete all as specified and as directed by Engr-in-C

Supply, installation, comissioning of water cooler fully stainless steel,electric driven (single phase), having approx storage capacity of 80 ltr and nominal cooling capacity of 40 Ltr per hour complete all as specified and directed by Engr-in-Charge.

M&L for concealed point wiring complete with 2.5 sqmm single core multistranded copper conductor FRLS, PVC insulated and unsheathed cable 650 /1100 volts grade drawn through & including PVC conduit ,medium grade with accessories like bends, tees, junction boxes etc fix on wall or ceiling surfaces all as specified including 2.5 sqmm , FRLS type , copper multistranded cable as earth wire including mounting of switch/sockets and regulator and including type cover plate white colour all as specified and directed

Supply and fixing flush/piano type switch 1 way 16A,

Supply and fixing flush/piano type socket 1 way 16 amp

M & L for concealed point wiring complete with 1.5 sqmm single core multistranded copper conductor FRLS, PVC insulated and unsheathed cable 650 /1100 volts grade drawn through & including PVC conduit ,medium grade with accessories like bends, tees, junction boxes etc fix on wall or ceiling surfaces all as specified including 1.5 sqmm , FRLS type , copper multistranded cable as earth wire including switch/sockets and regulator and including cover plate white colour all as specified and directed for : (a) One light /fan/cell bell/holder point controlled by one one way switch as directed engineer-in-charge.

(b) One 3 pin socket outlet, 5Amps, independent with other switch

(c) One 3 pin socket outlet 5 amps on same board with other switches.

Supply and fixing piano/flush type 1 switch for fan /tube light/bell/ as directed engineer-in-charge

Supply and fixing flush/piano socket 1 way 6 amp

S&F Factory made sheet metal enclosures double door type made out of CRCA 1.2 mm thick M.S. sheet, powder coated, partly embedded in wall, IP-43 protection, VTPN DB with 200 Amps rated bus bar,And MCCB 63 AMP, 4 way, 415 volts, vertical type, dust and vermin proof, suitable for incorporation of MCCBs/ MCBs, factory made, including thermal based release adjustable type 4 pole 63 Amps, 50 Hz, 415 Volts with rupturing capacity 16 KA and making good distrubbed surfaces with matching colour, complete all as specified.

M & L ceiling rose surface bakelite 65 x 50 mm three terminals complete all as specified.

M & L for earthing complete with galvanised earth plate electrode 600 X 600 X 6 mm thick buried directly in ground (earth pit not less than 2.25 m below ground level) with top edge of earth plate not less than 1.5 m below normal ground level, connected to galvanised earth lead wire 4 mm dia by means of nuts, bolts, check nuts & washers of galvanised iron or steel all as shown on electrical plate No. 3 of MES schedule 2009, Part – I (Specifications) and connected to main switch board / main DB’s / earthing test point including all necessary excavation and earth work in any type of soil, adequate quantity of charcoal dust & common salt all around the earth plate minimum 150 mm in all directions with & including watering pipe 20 mm dia GI medium grade, GI funnel made out of 0.63 mm thick GI sheet, wire gauge, 50 mm thick RCC cover in PCC 1:2:4, type B-1, duly reinforced with 6 mm dia mild steel round bars @ 150 mm both ways center to center with suitable lifting handle to cover, earth pit of PCC 1:3:6 type C-1, GI protection pipe light grade 15 mm bore up to 7.5 m length from earth electrode & engraving of earth marking on nearby building with CM 1:4 plate size 200 X 150 X 15 mm & painting of earth result etc. including testing on complete all as specified and directed. Note : (i) Earth lead and protection pipe beyond 7.5 m shall be measured and paid separately. (ii) On testing after completion of job, if desired earth resistance is not obtained, the earthing shall be redone by the contractor without any extra cost to Govt.

Supply and fixing M & L Lamp holder, PVC/Polycarbonate type with back plate suitable for batten fittings

S&F LED tube light fitting 20W (Double side) including LED lamp 20W with 2100 lumen output with internal surge protection device of 4KV with voltage band of 140-280V CRI-6500K (White light) fixtures box type and connecting electrically to ceiling rose using PVC insulated and overall sheathed flexible copper conductor of size 0.50mm 3 core complete all as specified and directed.

Supply and fixing S/F MCB SP 6-32 Amps 240 volts

Supply and fixing LED street light fitting 35 Watt 230 V AC outdoor type with high pressure die cast aluminum hosing and heat resistant complete with driver, lamp bracket with impact and corrosion resistant including thermalmanagement in multiple optics complete withIP 65/66 protection complete

Excavation in trenches in soft/lose soil not exceeding 1.5 Mtr wide and not exc 1.5M depth for laying of UG cables and getting out all as specified and directed

Returning, filling, including spreading, levelling, watering and well ramming in layers not exc 25cms thick of soil complete all as specified and directed.

M & L river sand in trenches as cable cushioning 8 cm below the cables and 15cm above the cable which is to be punned down to 10m all as specified and directed.only punned thickness will be measured.

Removing the surplus excavated materisl/soil to a distance not exc 50Mtrs and depositing, where directed at a level not exceeding 1.5 Mtr above the starting point all as specified and directed.

Supply and lay burnt bricks sub class 'B' standard size laid across the cable in trenches as protection to the cable all as specified and directed.

Supply of Electrical Solid Waste Incinerator-05kg/batch Solid Waste Incinerator + Air Pollution Control Machine + Chimney Height 1mtr inclusive,POWER LOAD 15 kw 450 v material of (construction) mild steel with temp max 550 - deg, control pannel with on off and degital temp controller and chimney hight 1 mtr, number og heater 1 set, with all specified and directed Engr-in-charge.

Supply and fixing PVC insulated armoured heavy duty electric cable with aluminium conductor, 1100 volts grade, cross-sectional area 10 sqmm 4 core

Supply and fix Water Heater storage type, five star rated, electric operated, 25 Ltr capacity 230 Volt AC Supply with PVC Connection pipe Superior quality (Hot & Cold water) including Plug top 15 Amp, NRV, 15 Amp socket, stop valve cast copper alloy with crutch or butterfly handle, steel tube medium grade galvanized with all fitting and fixture or wall or ceiling down or laid in floor complete with necessary water connection and electrical connection complete all as specified and directed. Make : Havells and equivalent in Racold/CG

M&L for FRLS point wiring in concealed/surface conduit complete including necessary chasing, cutting with PVC insulated and unsheathed cable 2.5 sqmm (nominal area) multi stranded copper conductor single core and ISI marked including rigid PVC Conduit 'Medium grade not less than 20 mm dia with concealed in wall/surface pressed steel terminal boxes not less than 1.6 mm thick of reqd size (factory made) with top cover 3 mm thick of plastic laminated sheets of required colour painting terminal boxes inside and outside with two coats of black bituminous paint over a coat of red oxide primer complete with all accessories and all as specified including PVC insulated and unsheathed cable 2.5 sqmm (nominal area) stranded copper conductor single core of green col our as earth wire to common earth and connected to earth dolly drawn in same conduit incl making good disturbed surfaces complete all as specified and directed.

S & F Socket 5 Pin multipurpose piano, flush type single pole, one way 15 Amp

S & F Switch piano, flush type single pole, one way 15 Amp

S&F steel tubes medium grade galvanized with all fitting and fixtures on wall or ceiling or laid in floor of pipe 15 mm dia.

S & F Bib taps cast copper alloy with crutch or butterfly handle, screwed down , screwed for iron pipe or for brass ferrule, chromium plated fancy type of size 15 mm dia.

S & F Stop valves cast copper alloy with crutch or butterfly handle, screwed down, screwed for iron pipe or for brass ferrule of size 15 mm dia.

S & F MCB SPN 240 Volt 20 AMP all as specified and directed.

M&L for submain wiring with two RUNS of single core 4 sqmm for main wire and one run of single core 4 sqmm as earth wire of stranded FRLS copper conductor PVC insulated unsheathed cables drawn through and including concealed conduits in wall and necessary cutting and chassing for rigid PVC conduit ISI marked not less than 20 mm dia and all accessories complete all as specified & directed.

Supply & fixing MCB DB SPN single door suitable for MCBs 2 way all as specified and directed by Engr-in-Charge.

Supply and fixing exhaust fan, steel body AC single Phase 230V of size 300m sweep with blades, frame and louvers complete all as specified

M/s GURFATEH BUILDERS (BID ID -3481633)

M/S Kuldip Construction Co. (BID ID -3475942)