Providing 50 No of LED Street Light (3parks) and 1No of 5HP Motor at Sekkadu VGN Park in ward no 37.

Amount

Earth work excavation for foundation in Hard stiff clay, stiff black cotton, hard red earth, shales murram, gravel,stoney earth and earth mixed with small size boulders SS.20B and Sand,silt or other loose soil, wet sand,or silt not under water, light black cotton soil, sandy loam ordinary soil and initial lead of 10m initial lift of 2 mto full depth as may be directed except in hardrock requiring blasting inclusive of shoring shuttering etc.,complete

Supplying and filling in foundation and basement with Crushed Stone Sand (M- Sand) in layers of not more than 15cm thick well rammed watered and compacted etc., complete complying with standard specification.

Plain Cement concrete 1:4:8 (one cement, four sand, eight aggregate) using 40mm gauge hand broken granite stone jelly for foundation including dewatering if found necessary and laid in layers of not more than 15 cm thick and compacted,etc., complete complying with standard specfication.

Supplying and laying Rubberised interlocking Paver block M40 grade Providing and laying of 83mm thick high strength type conforming IS 15658-2006 of rubberized interlocking paver lock in size of minimum compressive strength of 40N/mm2 in uniform shape of approved make to be laid in flurring bone pattern with sand cushion below the uniform shap of approved non skitting surface in the top and the rate including levelling the base preparation of pavers as sub base, sand cushion 150mm thick laying out of pavement cut the pieces to fix the edge vibring the pavers,sweeping tranporting loading unloading of laying paver block as per standard specification,.

Plastering with cement mortar 1:5 (One part of Cement and Five part of Plastering Sand (P- Sand)) 12mm, thick in all floors including cost and conveyance of all materilas to site and labour charges etc,complete as per standard specifications

Painting two coats for Exterior surface with approved Exterior Plastic Emulsion paint approved quality and colour over a priming coat, including thorough scrapping, clean removal of dirt, etc complete and including necessary plaster of paris, putty, wherever required etc, complete as per standard specification.

Paving the floor with design Antiskirt ceramic tiles (colour and shade as directed) of size 305 mm x 305mm x 6 mm in all floors over a base layer of cement mortar 1:3 (One part of Cement and Three part of Plastering Sand (P- Sand)), 20mm thick laid in-situ and pointed with same coloured cement

Supply and fixing of 6m Ornamental light fittings with tubular pole 50mm dia MS pipe,integrated with a specially protected stainless steel top layer, acrylic diffuser, translucent top,bottom clear with built in control box with MS base plate and foundation hardwares.The luminarie is designed for single 11W CFL & single 36W CFLL, with built in control box,prewired and suitable fir 240V, single phase, AC.etc,complete as per standard specification.

Supply and fixing of CCTV camera with 8 units with following specifications as instructed by the departmental officers, cost including all cost and conveyance of all materials to site, labour charges and other incidental charges taxes etc., complete A. 1.3 MP HD Bullet camera HD sensor 3.6mm 1080 lens 36 IR high sensivive LED, 25M distance IR with heat absorbing filter & day/ night sensor. B. 1080P-8 channel HD DVR 8 channel video, 4 channel audio 1 VGA output, 1 HDMI output, USB mouse and remote / mobile view and maximum 4 TB HDD connectivity with 1 SATA port (without hard disk). C. 4 TB WD SATA purple surveilance hard disk. D. 8 channel SMPS. E.NC & DC Connector. F.LG Monitor 22 inches G.Service Charges. H. 8 U mounted rack with glass door with two year warranty for camera, DVT, hard disk monitor.

Towards cost of Geophysical investigation survey charges.

Supply and delivery of 200mm dia of (Casing medium) PVC casing plain pipe including cost and conveyance at site etc., complete as per standard specification (Twad S no 1.1 pg.no 22)

Supply and delivery of 150mm dia of (Casing medium) PVC casing Slotted pipe ( Company Slots) including cost and conveyance at site etc., complete as per standard specification ISI make (Twad S no 1.1 pg.no 22)

Supply and delivery of 150mm dia of (Casing medium) PVC casing plain pipe including cost and conveyance at site etc., complete as per standard specification `(Twad S no 1.1 pg.no 22)

Drilling of 200mm dia bore wells any where is chengalpattur district including tranportion from one place to aother place with in this district in alluvial soil or sedimentrary starata using rotary rig by first drilling a pilot bore of 150 mm dia by direct rotary mud circulation method using contractors rig tool fuel, labour drillng bentonite mud and water required for drilling,

Drilling 150mm dia pilot bore to the required depth Below ground level.(Twad S no 12 pg.no 302)

Drilling 150mm dia pilot bore up to 60 m to 90 m from Ground level.(Twad S no 12 pg.no 302)

Drilling 150mm dia pilot bore up to 90 m to 120 m from Ground level.(Twad S no 12 pg.no 302)

Drilling 150mm dia pilot bore up to 120m to 150 m from Ground level.(Twad S no 12 pg.no 302)

Supply and delivery of 200mm dia(8”) PVC end cap including cost and conveyance etc., complete (Twad Sor 1.5 pg.no 27)

Reaming from 150mm dia pilot bore to 200mm dia size bore as directed by the Departmental Officer, to the required depth up to 60 from Ground level (Twad Sor 12.b pg.no 302)

Labor charges for inserting the P.V.C. casing pipes assembly with slots (or) without slots in the drilled holes including joining the pipes etc., complete, supply and packing the annular space with pebbles of size and quality as approved by the Municipal Engineer excluding cost of casing pipe etc., complete 200mm dia PVC casing pipe (Twad Sor 12.e pg.no 304)

Charges for developing the bore wells with Air Compressor 600cfm (Minimum 8 hours) including transportation labor and fuel charges for Compressor as directed by the Departmental Officer and conducting yield test by “V” notch method.(Twad Sor b pg.no 305)

Supply and Fixing of 5 HP Motor Submersible Pump set ISI mark IS 8034Without panel board 75LPM and 60M Head including Fixing Charges and all Charges etc. Complete.(Rate with TNVAT @4% on Basic cost Excise Duty)(Sor S no 408 pg.no 105)

Supply and delivery of suitable 3 phase panel board to 5HP with DOL Starter Auto On/Off Switch etc.,(Twad Sor S no 112 pg.no 115)

Supply and Delivery of 2.5 Sqmm PVC insulated and Sheathed 3 Core flat type copper cable confirming to IS 694/1990 Including all charges with excise duty and handling charges etc (Twad Sor S no 12.1 pg.no 120)

Towards Labour Charges for the errection of Submersible pump set in bore well including fixing and jointing submersible cable with proper clamps up to the starter to riser pipes to the required depth valves erection clamps, pressure gauge up to the exterior of panel board consisting of TPICN switches starter ,Volt meter, Ammeter, three pilot (indicating) Lamps capacitor single Phasing preventor,water level guard and laying and jointing the cables and twin earthing as per IE rules etc., Complete and testing the pump set and trail run for 10 days 2 HP Plat form All round (Twad Sor S no 17.3 pg.no 308)

Supply and run off 4 to 6 Sq.mm polythene insulator and PVC sheathed (Heavy Duty) service meter Aluminium cable of 1100 V grade on bearer wire for servive connection mains (SD 61).(320 Aluminim Wire)(Twad Sor S no 12.0 pg.no 120)

Supply, delivery and fixing of the following ISI make water supply materials including all labour charges etc., complete

2" dia Pipe clamp set (Twad s no 5.16 pg no 44)

2" dia pvc bend (Sor s no 395 c pg no 100)

2" dia G.I Elbow (Twad s no 5.16 pg no 44)

2" dia G.I Union (Twad s no 5.16 pg no 44)

2" dia gate valve (Twad s no 5.2 pg no 45)

2" U Pvc Pipe (Twad s.no3(6) pg no 24)

2" dia pvc pipe (Sor s no 394 pg no 99)

2" dia pvc Tee (Sor s no 395d pg no 100)

3/4" dia G.I Tee (Twad s no 5.2 5.16 pg no 44)

3/4" dia G.I Elbow (Twad s no 5.2 5.16 pg no 44)

3/4" dia Pvc Tap (Sor s no 160 pg no 68)

3/4" dia GI Coupler (Twad s no 5.2 5.16 pg no 44)

saddle piece (Twad s no 5.1 B 5.16 pg no 44)

Supply and delivery and fixing of HDPE tank 2000 litres capacity as per IS 12701 / 1996 including loading, unloading, transportation and labour charges for fixing of the GI pipes and specials for pipe connection works including cutting, threading and fixnig charges as directed by TWAD Board officers etc.,(Twad S no 17.0 p no 89)

Providing Construction of Brick work for HDPE tank with Pcc in 1:2:4 and Brick work CM:15 using II class ground moulded bricks of size 8 3/4 x 4/2 x 3/4 Earth Filling Plastering CM 1:5 20mm Thick painting etc Complete

Supply and fixing of 0.75 x 0.75 x 0.45 size made up with MS angle and plats of a kiosk erected on a masonary pedsal for protecting accessories etc., complete complying with standard specification.(Twad s no 18.0 pg no 89)

Providing painting and lettering over the PVC tank for the work details as per instrution given by the departmental officers etc., complete complying with standard specification.

Electrification charges for EB service connection

Supply and delivery of 25mm GI Pipe Service Pipe With Bend Including Coat and Coneyance etc,Complete as per Standard Specification as Directed by the Departmental Officers (Twad S no 50 Pg no 42

Earth work excavation in all classes of soils and sub soils to full depth as may be required except hard rock requring blasting etc., complete (Data S.No:1)

Laying & Lowering of Pipe line extn complete as per the standard specification (Twad 11b(i) Pg.No:268

Refilling with excavated soil (other than sand) complying with the standard specification for filling in foundation and basement (Twad S.No: 19.b Pg.No:286)

Providing Art painting and Lettering including all labour charges

AAF Construction (BID ID -1304620)