Supply, Installation, Testing and Commissioning of Lab Equipment for the Department of Electrical Engineering

Calibration of ammeter and Wattmeter

Calibration of ammeter and Wattmeter

Demonstration of three phase transformer connections. Voltage and current relationship, phase shifts between the primary and secondary side

3 single ph transformer for Vector group testing Dy1,Dy11,YY0,Dz0,Dz6 connection

Demonstration of components of LT switch

1-10KW LT switchgear Panel mounted setup for handson practice of switchgear connection

Frequency meter,Ph Sequency meter ,power factor meter

Frequency meter,Ph Sequency meter ,power factor meter

Measurement of capacitance by Schering Bridge

Measurement of capacitance by Schering Bridge

Measurement of speed of DC series motor as a function of load torque

DC series motor drum controler setup with loading arrangment

V/F control of 3 ph induction motor

V/F control of 3 ph induction motor

parallel operation of two three ph Transformers

parallel operation of two three ph Transformers

determination of Xd,Xq of a salient pole 3 ph synchronous machine

determination of Xd,Xq of a salient pole 3 ph synchronous machine

Parallel operation of two three ph Alternator

Parallel operation of two three ph Alternator

Different parameter calculation by power cycle diagram

Different parameter calculation by power cycle diagram

study of different type of cable

a demonestration board with single core, 3 core stranded, nonstranded ACSR,Al,Cu, Conducters used for transmission and distribussion

Study of the characteristics of on- delay relay and off-delay relay

Study of the characteristics of on- delay relay and off-delay relay

Test to find out characteristics of (a) under voltage relay (b) earth fault relay

Test to find out characteristics of (a) under voltage relay (b) earth fault relay

Study of the characteristics of an SCR

SCR Trainer kit

Study of the characteristics of a TRIAC

TRIAC Trainer kit

Study of different triggering circuits of an SCR

Complete setup for SCR Triggering circuit Trainer kit (to perform i) Forward voltage triggering. ii) gate triggering iii) dv/dt triggering iv) temperature triggering v) light triggering)

Study of firing circuits suitable for triggering SCR in a single phase full controlled bridge

Complete setup for SCR Triggering circuit in a single phase full control bridge Trainer kit

Study of the operation of a single phase full controlled bridge converter with R and R-L load.

Complete setup for SCR Triggering circuit in a single phase full control bridge with R and R L load Trainer kit

Study of performance of single phase half controlled symmetrical and asymmetrical bridge converters

Complete setup for Study of performance of single phase half controlled symmetrical and asymmetrical bridge converters-Trainer kit

single ph Universal motor control using DIAC, TRIAC

single ph Universal motor control using DIAC, TRIAC

Study of performance of step down chopper with R and R-L load,motor speed control

Complete setup for Study of performance of step down chopper with R and R-L load

Tuning of P, PI and PID controller for first order plant with dead time using Z-N method. Process parameters (time constant and delay/lag) will be provided. The gain of the controller to be computed by using Z-N method. Steady state and transient performance of the closed loop plant to be noted with and without steady disturbances. The theoretical phase margin and gain margin to be calculated manually for each gain setting

Tuning of P, PI and PID controller for first order plant with dead time using Z-N method. Process parameters (time constant and delay/lag) will be provided. The gain of the controller to be computed by using Z-N method. Steady state and transient performance of the closed loop plant to be noted with and without steady disturbances. The theoretical phase margin and gain margin to be calculated manually for each gain setting

To plot the characteristics of UJT

To plot the characteristics of UJT

To measure Low resistance by Kelvin’s Double Bridge

To measure Low resistance by Kelvin’s Double Bridge

To measure power factor of single phase and three phase load by PF meter and verify the same through I, V and P measurement

To measure power factor of single phase and three phase load by PF meter and verify the same through I, V and P measurement

To measure current & voltages by low range ammeter & voltmeter respectively using CT and PT

To measure current & voltages by low range ammeter & voltmeter respectively using CT and PT

To Mount and wire up the main board by batten/conduit wiring and connect Energy Meter, MCB, ELCB, RCCB etc. as per IE rule

To Mount and wire up the main board by batten/conduit wiring and connect Energy Meter, MCB, ELCB, RCCB etc. as per IE rule

To test a battery for its charged and discharged condition and to make connections for charging and obtain its capacity

To test a battery for its charged and discharged condition and to make connections for charging and obtain its capacity

To start a 3-phase Slip-ring induction motor by rotor resistance starter and determine the effect of the rotor resistance on the torque-speed curves of an induction motor

To start a 3-phase Slip-ring induction motor by rotor resistance starter and determine the effect of the rotor resistance on the torque-speed curves of an induction motor

To measure temperature by pt-100, thermistor and thermocouple along with simple resistance bridge

To measure temperature by pt-100, thermistor and thermocouple along with simple resistance bridge

To plot characteristics of potentiometer and observe the loading effect on output of potentiometer

To plot characteristics of potentiometer and observe the loading effect on output of potentiometer

To study open loop control of any physical control system and study of closed loop control of the same system using P, PI and PID controller

To study open loop control of any physical control system and study of closed loop control of the same system using P, PI and PID controller

To study the position control system using servomotor

To study the position control system using servomotor

To demonstrate various system faults by D.C. network analyzer

To demonstrate various system faults by D.C. network analyzer

To study active and reactive power flow through transmission lines

To study active and reactive power flow through transmission lines

To measure Solar Radiation with the help of Pyranometer

To measure Solar Radiation with the help of Pyranometer

To study different kinds of insulators (Insulators are required to be available in laboratory

Demonstration board displaying available types of insulators (A,E,B,F,H,C class

To study PILC, PVC, FRLS and XLPE cables. (Cables are required to be available in laboratory)

To study PILC, PVC, FRLS and XLPE cables. (Cables are required to be available in laboratory)

To demonstrate the photo voltaic system used in street lighting – PV module, CCU, Battery, CFL

To demonstrate the photo voltaic system used in street lighting – PV module, CCU, Battery, CFL

To identify the terminals of Thyristor and plot V-I characteristics of Thyristor

To identify the terminals of Thyristor and plot V-I characteristics of Thyristor

To study fully controlled full wave rectifier using SCR

Kit Type Fully controlled Bridge rectifier using SCR

To study DC chopper circuit using SCR

To study DC chopper circuit using SCR

To study series inverter using SCR

Series Inverter using SCR Kit

To perform speed control of DC series motor using SCR

To perform speed control of DC series motor using SCR

To perform speed control of 3-phase Induction motor using PWM inverter. Interpret speed-torque characteristics. Use variable voltage variable frequency drive

To perform speed control of 3-phase Induction motor using PWM inverter. Interpret speed-torque characteristics. Use variable voltage variable frequency drive

To study the operation and circuit diagram of Uninterrupted Power Supply unit

To study the operation and circuit diagram of Uninterrupted Power Supply unit

Operation of a stepper motor with a fixed number of steps and to determine the angular displacement per step by measuring the total angular rotation

Operation of a stepper motor with a fixed number of steps and to determine the angular displacement per step by measuring the total angular rotation

To determine Illumination of a surface for a Drawing Room by means of lux meter

To determine Illumination of a surface for a Drawing Room by means of lux meter

To determine candle power of a lamp in comparison to standard C.P. of lamp by optical bench method.

To determine candle power of a lamp in comparison to standard C.P. of lamp by optical bench method.

To study of the principle of Induction Heating using an induction heater

Induction heating study kit

To make & test the control circuit for dynamic braking operation of induction motor using contactor control

To make & test the control circuit for dynamic braking operation of induction motor using contactor control

Kit type demonstration of Induction motor dynamic breaking

Kit type demonstration of Induction motor dynamic breaking

To make & test the control circuit operation of automatic star-delta starter of induction motor using PLC

PLC unit (Seimens)to demonstrate star delta starter operation

Digital Storage Oscilloscope

Digital Storage Oscilloscope

Multimeters

Multimeters

Universal Programmer

Universal Programmer

Pic microcontrollers

Pic microcontrollers

Arduino microcontrollers

Arduino microcontrollers

Relays

Relays

Solar Panels

Solar Panels

DC Motors

DC Motors

Demonestration kit of network therem for Thevenin's, Norton's, Maximum power transfer ans Super position theorem

Demonestration kit of network therem for Thevenin's, Norton's, Maximum power transfer ans Super position theorem

To measure active and reactive power in three phase balanced load by two wattmeter method and observe the effect of Power Factor variation on Wattmeter reading

To measure active and reactive power in three phase balanced load by two wattmeter method and observe the effect of Power Factor variation on Wattmeter reading

To measure an inductance by Maxwell’s bridge

To measure an inductance by Maxwell’s bridge

Mother Electric Works

ELCO SCIENTIFIC

SUSHAMA ELECTRONICS

PODDAR SYSTEM AND SERVICES

DELTA TECHNOLOGIES

Mother Electric Works

VIMICROSYSTEMSPVTLTD

ELCO SCIENTIFIC

SUSHAMA ELECTRONICS