Constt. of CSC near Primary health Centre

Amount

Earth work in excavation by manual means in trenches for foundations, drains, pipes, cables etc. (not exceeding 1.5m in width) and for shafts, wells, cesspits and the like not exceeding 10 sqm on plan, including dressing of sides and ramming of bottoms lift upto 1.5 m, including getting out excavated earth for 1 meter from cutting edge and disposal of surplus excavated earth as directed:

All kinds of soil

Providing and laying in position cement concrete of specified grade including curing but excluding the cost of centring and shuttering. All work upto plinth level with: 1:5:10 (1 cement : 5 coarse sand : 10 graded stone aggregate 40 mm nominal size) (Including all leads and lifts carriages of material by MT/HL)

Providing and laying in position cement concrete of specified grade including curing but excluding the cost of centring and shuttering. All work upto plinth level with:1:3:6 (1 cement : 3 coarse sand : 6 graded stone aggregate 20 mm nominal size) (Including all leads and lifts carriages of material by MT/HL)

Brick work with common burnt clay (non-modular) bricks of class designation 7.5 in foundation and plinth including curing in :Cement mortar 1:6 ( 1 cement : 6 coarse sand)(Including all leads and lifts carriages of material by MT/HL)

Extra for brick work with common burnt clay bricks/cement concrete bricks in superstructure above plinth level upto floor five level. (Including all leads and lifts carriages of material by MT/HL)

Brick work with common burnt clay (non-modular) bricks of class designation 7.5 in foundation and plinth including curing in :Cement mortar 1:4 ( 1 cement : 4 coarse sand)(Including all leads and lifts carriages of material by MT/HL)

Half brick masonry with common burnt clay (non-modular) bricks of class designation 7.5 in foundations and plinth including curing in :Cement mortar 1:4 ( 1 cement : 4 coarse sand)

Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundations etc. in layers not exceeding 20 cm in depth, consolidating each deposited layer by ramming and watering, lead upto 50 m and lift upto 1.5 m.

Reinforced cement concrete work in beams, suspended floors, roofs having slope upto 15°, landings, balconies, shelves, chajjas, lintels, bands, plain window sills, staircases and spiral stair cases upto five level including curing but excluding the cost of centring, shuttering, finishing and reinforcement with 1 1:1½:3 (1 cement : 1½ coarse sand : 3 graded stone aggregate 20 mm nominal size)(Including all leads and lifts carriages of material by MT/HL)

Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete upto plinth level , Thermo-Mechanically Treated bars of grade Fe-500D or more.

Centering and shuttering including strutting, propping etc. and removal of form work for:

Foundations, footings, bases for columns

Suspended floors, roofs, landings, balconies and access platforms.

Edges of slabs and breaks in floors and walls under 20 cm wide

15mm Cement plaster of mix: 1 : 4 ( 1 cement : 6 fine sand)

12mm Cement plaster of mix: 1 : 4 ( 1 cement : 4 fine sand)

12mm Cement plaster finished with a floating coat of neat cement of mix: 1 : 4 ( 1 cement : 4 fine sand)

6 mm cement plaster to ceiling of mix 1 : 3 (1 cement : 3 fine sand)

Cement concrete flooring 1:2:4 (1cement: 2 coarse sand: 4 graded stone aggregate) finished with a floating coat of neat cement including cement slurry and curing complete, but excluding the cost of nosing of steps etc. complete. 50 mm thick with 20mm nominal size stone aggregate.(Including all leads and lifts carriages of material by MT/HL)

Providing and fixing 1mm thick M.S. sheet door with frame of 40x40x6mm angle iron and 3mm M.S. gusset plates at the junctions and corners, all necessary fittings complete, including applying a priming coat of approved steel primer. Using M.S. angles 40x40x6mm for diagonal braces

Finishing walls with water proofing cement paint of required shade on New work (two or more coats applied @ 3.84 kg/10sqm)

Distempering with dry distemper of approved brand and manufacture (two or more coats) and of required shade on new work, over and including water thinnable priming coat to give an even shade

Providing and fixing Ist quality ceramic glazed wall tiles conforming to IS : 15622 (thickness to be specified by the manufacturer), of approved make, in all colours, shades except burgundy, bottle green, black of any size as approved by Engineer- in-Charge, in skirting, risers of steps and dados over 12 mm thick bed of cement mortar 1:3 ( 1 cement : 3 coarse sand) and jointing with grey cement slurry @ 3.3 kg per sqm, including pointing in white cement mixed with pigment of matching shade complete.

Providing and laying Ceramic glazed floor tiles 300x300 mm (thickness to be specified by the manufacturers) of 1st quality conforming to IS: 15622 of approved make, laid on 20 mm thick bed of cement mortar 1: 4 ( 1 cement : 4 coarse sand) including pointing the joints with white cement and matching pigment etc., complete. In colour such as White, Ivory, Grey, Fume Red Brown

Providing and fixing G.I. pipes complete with G.I. fittings and clamps, including cutting and making the walls etc.: Internal work-Exposed on wall

15 mm dia. nominal bore .

20 mm dia. nominal bore .

Providing and fixing G.I union in G.I pipes including cutting and threading the pipes and making long screws etc. complete (new work)

Providing and fixing wash basin with C.I /M.S brackets 15mm C.P bras pillar taps , 32mm C.P bras waste of standard pattern , including Painting of fittings and brackets , cutting and making the good walls wherever . white vitrerous China . size wash basin 630x450mm with pair of 15mm c.p brass pillar tap .(make cera/equivalent)

Providing and fixing white vitreous china pedestal for wash basin completely recessed at the back for the reception of pipe and fitting.(make cera/equivalent)

Providing and fixing 600x450mm beveled edge mirror of superior glass of approved quality complete with 6mm thick hard board .ground fixed to wo0den cleats with C.P bras screws and washer complete

Providing and fixing PTMT grating of approved grating of approved quality and colour . circular type 125mm nominal dia with 25mm waste hole(make jaquar/cera/equivalent)

Providing and fixing cp bib cock of approved quality 15mm nominal bore complete job (make jaquar/ cera /equivalent) Short nose

Long Nose

Providing and fixing C.P brass angle valve For basin mixer and gyser points of approved make confirming to IS:8931. 15mm nominal bore complete job .(make jaquar/cera/equivalent)

Providing and fixing 110mm dia. PVC waste water / sewerage pipe of 4 kg pressure per sqm of supreme / prince/ finoeix make prakash surya

Providing and fixing unplasticised PVC connection pipe with brass union 30cm length 15mm nominal bore

Providing and fixing of 600x120x5 mm glass shelf with edges round off supported on aluminium angle frame with cp brass brackets and guard rail complete fixed with 40 mm long screws etc make jaquar/cera

Providing and fixing ball valve ( brass) of approved quality complete high or low pressure with plastic floats 15mm dia nominal bore

Wiring for light point/ fan point/ exhaust fan point/ call bell point with 1.5 sq.mm FRLS PVC insulated copper conductor single core cable in surface / recessed medium class PVC conduit, with modular switch, modular plate, suitable GI box and earthing the point with 1.5 sq.mm FRLS PVC insulated copper conductor single core cable etc. as required. (Refer CPWD DSR E&M 2018 Item No. 1.10.1).

Group C

Wiring for circuit/ submain wiring alongwith earth wire with the following sizes of FRLS PVC insulated copper conductor, single core cable in surface/ recessed medium class PVC conduit as required.(Refer CPWD DSR E&M 2018 Item No. 1.14).

2 x 2.5sqmm + 1 x 2.5 sqmm earth wire

Supply and fixing suitable GI box with modular plate and cover in front on surface or in recess including providing and fixing 6 pin 5/6 and 15/16 A modular socket outlet 15/16 A modular switch connection etc as reqd

Suppling and fixing 5A to 32A rating, 240/415 V , 10 kA, "C" Curve , miniture circuit breaker suitable for inductive load of following poles in the existing MCB, DB complete with connection, testing and commissioning etc as reqd

Single Pole

Supply and fixing 9W LED lamp

Supply and fixing of main service line 16sqmm twin core aluminium cable unarmoured from the LT pole upto the MCV/DB including connection etc as reqd

Providing and placing on terrace on all floor levels polythene water storage tank ISI;12701 marked indicating the bis no with cover and suitable locking arrangements and making the necessary holes for inlet, outlet and overflow pipes including fitting and the base port for tanks syntax , electroplast , star , lotus, or equivalent having ISI make .

Providing and fixing Motor pump of ½ HP of sharp ,bajaj,or equivalent make including fittings (complete job)

Providing and fixing soap dish of approved quality

Providing and fixing PTMP towel ring trapezoidal shape 215mm long 200 mm wide with a minimum distance of 37mm from wall face with concealed fittings arrangements of approved quality and colour , weighing not less than 80 gram

Providing and fixing white vitrous china pedestal type water closet ( European type wc pan) with seat and lid ,10 litre low level pipe with PVC flushing cistern including flush type with manually controlled device conforming to IS:7231 with all fittings and fixures, complete including cutting and making good the walls and floors where ever required.(make cera/equivalent)

Providing and fixing P.V.C. waste pipe for sink or wash basin including P.V.C waste fittings complete: semi rigid pipe 32 mm dia

Providing and fixing 4" pvc floor trap of app make and manufacturers

Providing and fixing soil, waste and vent pipes :75 mm diameter. 75 mm diameter. 18.35.2.1 Sand cast iron S and S pipe as per IS:1729

Providing and fixing white vitreous china squatting plate urinal with integral rim longitudinal flush pipe.

Providing and making CIB of approved size by way of making another layer of 12 mm thick plaster with 1:4 cement mortar on front side outer plastered surface, painting and writings as per the direction of engineer in-charge including supply of materials, carriages all complete. L.M.R.

M/S RASANT SINGH

RAJIV SPOLIA

kulbir singh