Prov. LIS for horticulture land of GP Nerwa to village Rinjat Dhadhu Chayama Dayandli etc under Drip Irrigation and spray work Tehsil Nerwa District Shimla

Amount

Cutting in all kinds of earth such as pick work, blasting work, chiselling when blasting is prohibited in soft/hard rock or such mixed or other veriety of soil of rocks etc. stacking of servicable material to specified diamensions and disposed of unservicable material at the place specified by Engineer-in-Charge in earth work and disposal of excavted earth with in all leads and lifts as per the direction of the Engineer in charge

Excavation in foundation,trenches (for pipes & pits) up to all depths in all classification of earth work such as pick work, jumper work, saturated soil including bailing or pumping out water, blasting soft/hard rock or chiseling soft/hard rock where blasting is prohibited in all lifts including trimming & dressing of sides, levelling of beds to correct grade i/c shoring/strutting, planking,timbering & dewatering wherever required, stacking the usable & unusable material/soil separaterly & after laying, jointing & testing of pipes, returning the useable soil in trenches in 15 Cm layers including consolidating of such deposited layer by ramming & watering & then disposing of all surplus excavated soil/unusable material as directed with in all leads & lifts including restoration of unmetalled surfaces to its original condition & including cost of diversion for traffic,night signals, fixing caution boards, crossing over trenches for access to houses, fencing etc. complete in all respects with in all leads & lifts as per directions of Engineer - in - charge.

Providing and laying cement concrete 1:4:8 (1cement: 4 sand: 8 graded stone aggregate 40mm( Forty millimeter nominal size) and curing complete excluding cost of from work in foundation and plinth with in all leads & lifts as directed by Engineer in Charge.

Providing and laying cement concrete work 1:1:2 (1cement :1 sand: 2 graded crushed stone aggregate 20 mm nominal size) and curing complete excluding cost of form work and reinforcment for reinforced concrete work with in all leads and lifts as per the entire satisfaction & direction of the Engineer - in - Charge.in-Foundation and plinth

Walls (any thickness but not less than 0.1 m thickness) attached pillasters, buttresses, plinth and string courses etc. from top of foundation level up to floor two level:

Providing from work steel plates 3.15 mm thick welded with angle iron in frame 30x30x5 mm so as to give a fair finish i/c centering, shuttering, strutting and propping etc. with wooded battens & ballies, height of propping and centring below supporting floor to ceilling not exceeding 4 meters and removal of the same for in situ reinforced concrete and plain concrete work with in all leads and lifts as per the direction of the Engineer-in-charge-Vertical surfaces such as walls (any thickness) partitions and the like including attached pillasters, buttress, plinth and string couress and the like with in all leads and lifts as per the direction of the Engineer - in - Charge.

Providing mild steel/tor steel reinforcement for RCC work including bending, binding & placing in position complete upto floor two level with in all leads and lifts as per the direction of the Engineer - in - Charge.

Steel work in single sections including cutting, hoisting, fixing in position and applying a priming coat of red lead paint in R.S. Joists,channels, angles, tees etc. with in all leads and lifts as directed by the Engineer Incharge

Supplying and fixing woven plains G.I. wire (3mm2) fencing of mesh 50mm to 150mm to any type of standard rails, strainging bolts. etc. including provision of binding wire, staples etc. with in all leads and lifts as per the direction of the Engineer-in-charge.

Supply & fixing galvanised steel bar-bed wire (IS 278-1962 Type -1 ) weighing 9.38 kg per 100 mtr. Min. staining & fixing to any type of standard rails straining bolts i/c securing with & provision of gavanised mild steel wire staples or steel pins etc.

Laying , jointing and testing in trenches Galvanised Mild Steel tube of the following dia metres including smooth bending by necessary bends, or through pipe bending machine with necessary all pipe fittings such as Tees, Elbows, Union & Reducers etc. of ISI marked & testing for leakage complete with in all leads & lifts as per entire satisfication of Engineer - in - charge. (Earth work in trenches to be measured and paid for separately)80mm Dia

65 mm Dia

50 mm Dia.

40 mm Dia

32 mm Dia

Providing & fixing of Brass full way wheel valve of the following diametre including necessary all pipe fittings with in all leads & lifts as per entire satisfication of Engineer - in - charge. 80 mm Dia

65 mm Dia

50 mm Dia

40 mm Dia

32 mm Dia

HILL CONSTRUCTION AND ENGINEERING CO. SOLAN

HYDRAULIC ENGINEERING COMPANY