COMPREHENSIVE REPAIRS TO PATHWAY DRAIN AND OTHER MISC ITEMS UNDER AOR OF AGE BR DETT III OF GE 862 EWS

Amount

Excavating in trenches, n.exc 1.5m wide and n.exc 1.5m depth; for foundation etc,or for shafts n.exc 10 sqm on plan in any type of soil, complete all as specified and directed.

Removing excavated material (soil) n. exc 50m and depositing where directed at a level n.exc 1.5m above the starting point, complete all as specified and directed.

M&L for pre-cast cement concrete type C-1 (1:3:6), (using 20 mm graded crushed stone aggregate) blockmasonry with solid blocks, exc. 10 cm in width and setting in cement mortar 1:6, ,complete all as specified and directed.

M&L for pre-cast RCC (1:2:4) type B-1 (using 20mm graded stone aggregate) cover slabs (for man holes etc.) chullah hoods, chajjas, water troughs, mangers, shelves and similar articles with plain faces set in CM (1:6) & including demolition of old existing cover clabs, complete all as specified and directed.

M&L for mild steel TMT bars 6-8 mm dia cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends & binding with & including mild steel wire (annealed) not less than 0.9mmdia or securing with clips, complete all as specified and directed.

Demolition of unreinforced cement concrete in ground floors and pavings n exc 15 cm thickness (below or above ground level) & removal of demolition material out side MoD land complete all as spiecified and directed.

M&L for PCC 75 mm thick (1:4:8) type D-2 using 40 mm graded stone aggregate as in sub base of floor, paving etc, complete all as specified and directed.

Providing and laying 40mm thick coloured factory made chamfered edge cement concrete paver block of M-30 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc. of required strength, thickness & size/shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra complete all as specified and directed.

M&L for coloured chequred cement concrete tiles of size 30 cm X 30 cm x 25 mm thick set,jointed in neat cement slurry in floor and pointed with grey cement and no pigment laid over and including 15 mm thick screed bed in cement mortar 1:4,complete all as specified and directed.

M&L for PCC 100 mm thick (1:4:8) type D-2 using 40 mm graded stone agg as in sub base of floor paving etc, complete all as specified and directed.

Providing and laying 60mm thick coloured factory made chamfered edge cement concrete paver block of M-30 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc. of required strength, thickness & size/shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra complete all as specified and directed.

Providing and laying 80 mm thick coloured factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc. of required strength, thickness & size/shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra complete all as specified and directed.

Providing and laying 100 mm thick coloured factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc. of required strength, thickness & size/shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra complete all as specified and directed.

M&L for Providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5 mm), including making drainage opening wherever required complete all as specified and directed:

M&L for PCC (1:2:4) type B-O (using 12.5mm graded stone aggregate) Providing, roof kerbs or mud stops,levelling course,pedding rounded or chamfered on edges including demolitin of existing kerb stones, complete all as specified and directed.

M&L for prepration of newly surfaces of brick, stone, concrete, asbestos cement or plaster surfaces of any description over 10cm girth or width, not otherwise described and applying two coat of synthetic enamel paint over and including a coat of primer, complete all as specified and directed.

Demolition of unreinforced cement concrete of any description & in any portion not otherwise specifically provided for & removal of demolition material to out side MOD land complete all as spiecified and directed.

M&L for Cement concrete type B-0 (1:2:4) using 12.50 mm graded stone agg as in surface channels and drains including necessary formwork, complete all as specified and directed.

M&L for 40 mm thick, Plain Cement concrete type B-1 (1:2:4) (using 20 mm graded stone aggregate) as in floor finishes, laid in panels, finished surfaces even and smooth without using extra cement, complete all as specified and directed.

Supply only 38 mm wide Aluminium dividing strips, 1.5mm thick, inserted in position, conform to design, complete all as specified and directed. Note: Fixing charges or strips are included in rate of Item No 19 above.

M&L for providing 8 layered synthetic acrylic floor of outdoor badminton/ basket ball court with following specifications:- (a) 1st 2 layers - Synthetic flooring (re-surfacer) (600 micrometer thick each layer). (b) 04 layers - Cushion layer (600 micrometer thick each layer) (c) 02 layers - Top colour coat layer (400 micro meter thick each layer) (d) Line marking of the court shall be as per BWF norms. Make: Ebaco/Vector/Decoturf/Hacto/Frogg.

M&L for 150 mm bore HDPE DWC pipe SN 8 laid in trences for sewage & drainage including demoition of existing pipe of any type complete all as specified and directed

Demolition of brick work or stone masonry built in cement mortar including all quoins arches pillars etc excl ashlar facing dressed stone work and pre-cast concrete articles complete all as specified and directed.

M&L for walling of Random rubble brought upto courses well bonded, bedded and solidly hearted built CM 1:6, complete all as specified and directed.

M&L for walling (except Stone) of Random rubble uncoursed well bonded, bedded and solidly hearted built CM 1:6 by using stone retrived from demolition, complete all as specified and directed.

M&L for PCC (1:2:4), type B-0, using 12.5 mm graded crushed stone aggregates, in lintels upto 1.5m clear span, cills, steps; seismic and other similar bands, plinth courses, string courses, lacing courses, parapets and railings upto 60 cm in height, copings, kneelers, apex stones, bed plates, kerbs water troughs and the like including weathering, slightly rounded or chamfered angles and throating, complete all as specified and directed.

Extra over stone walling for hammer dressing to face stone and dressing of face beds with maximum depression on face from straight edge held against the dressed surface on sand stone n.exc 20mm, complete all as specified and directed.

M & L for 15 mm thick cement plaster on fair faces of brick work or concrete surfaces in CM 1:4 and finished fair even & smooth without using extra cement with water proofing comound, complete all as specified and directed.

M & L for 20 mm thick cement plaster on other than fair faces of brick work stone masonry surfaces in CM 1:4 and finished fair even & smooth without using extra cement with water proofing comound, complete all as specified and directed.

M&L for 100 mm thick, cement concrete type B-2 (1:2:4) (using 40mm graded stone aggregate) as in wearing surface for badminton court etc finished surfaces even and smooth without using extra cement including demolitoin of existing cement concrete not exc 150mm thick below or above ground level, complete all as specified and directed.

M&L for 15 mm thick Dura stone vitrified parking tiles, heavy duty(Acid and Alkali resisteance) for drive way,parking spaces etc area exc 0.09 Sqm but not exc 0.16 Sqm, laid over & including 20 mm thick screed bed in CM 1:4 inlcuding dismantling of existing tiles complete all as specified and directed. Note :- Size,design and pattern shall be approved by GE.

Spike rolling to surfaces or making impressions of expanded metal, whilst the concrete is green, complete all as specified and directed.

M&L for plain cement concrete type C-1 (1:3:6) (using 20mm graded crushed stone aggregate) in foundation filling and mass concrete, complete all as specified and directed

VIJAY KUMAR SURI AND SONS (BID ID -3481948)

M/s Anil Engineers & Builders (BID ID -3482525)

M/S IMRAN MAJID (BID ID -3479449)

NATIONAL TRADING COMPANY (BID ID -3487825)