Llaying HDPE pipe line for dewatering of flood water of village Muana from RD 17000 khanda minor outfalling RD 16200 / R Assandh Drain

Amount

Excavating trenches of required width for pipes, cables, etc including excavation for sockets, and dressing of sides, ramming of bottoms, depth up to 1.5 m, including getting out the excavated soil, and then returning the soil as required, in layers not exceeding 20 cm in depth, including consolidating each deposited layer by ramming, watering, etc. and disposing of surplus excavated soil as directed, within a lead of 50 m : Pipes, cables etc. exceeding 300 mm dia but not exceeding 600 mm (HSR 4.16.1.3)

Providing, lowering, laying, aligning, fixing in position and jointing at all level/ depths ISI marked HDPE pipe of PE-80 grade and PN- 4 for portable water application as per IS 4984:2016 (amended up to date) in trenches in complete including cost of HDPE Specials, labour, sectional hydro testing (including the cost and conveyance of water to site for testing) and commissioning as per Technical Specifications and as per direction of Engineer. Note: E/w to be measured and paid separately. Rate includes cost of all specials like bends, tees required during laying of pipe line along required alignment. 400 mm outer Dia NS item (derived rate)

Supplying erection testing and commissioning of Submersible motor pumping set non cling for sewerage having head 10.00 m OF 40 bhp as per the indicated requirements of discharge in LPM and power capacity in BHP Make ksb, CRI, KiRLOSKER ,Crompton ,Greeve Lubi. (HSR 21.105.72) nomeclature as per A&C slip NO 3 dated 6/8/2021

Supplying of fully automatic electric control 2.0 No. panel board for T/Wells in Pump Chamber consisting of MS sheet of thickness 14 gauge duly painted box type floor mounted made of angle Frame containing Min switch of suitable range with HRC tuse, 1 no. Fully autocratic air brake starter suitable for Motor of the following capacity Min switch of suitable range with HRC fuse, 1 no vott meter (o to 500 volts) 1 no amp Meter of 0 to 100 arnp .3 sets of indicating lamp capacitor of suitable capacity and suitable electing energy meter wing in Eluting Contro Panal Beard complete in all respect as per specification green in Schedule No,II. Including MCB. Suitable Capacitor. Wooden Box etc as per sit requirement complete in fat respect. Make L&T, SICMENS, BCH, SCHNEIDER ( 30 BHP) (HSR 20.114.5) nomenclature as per A&C slip NO.3 dated 06/08/2021

Supply of M.S pipe for delivery purposed with dia 300 mm dia as per HSR item no. code EL 265 Chapter 2 complete in all respect as directed by EIC

Providing and fixing cast iron double flanged swing check type reflux (Non return ) valves PN-1.6 marked with IS:5312 including nuts and bolts as per Hsr item no.20.11.8

Providing and fixing sluice valves socket or flanged include cartage as per HSR item no. 20.10.8

Earth work in excavation by mechanical means (hydraulic excavator) / manual over areas (exceeeding 30 cm in depth. 1,.5 mtr. in width as weel as 10 sqm in plan) including getting out and disposal of excavated earth lead of 50 mtr. And lift upto 1.5 mtr. As per HSR item no. 4.12

Dressing and preparation of sub grade in horizontal surface by machanical or manual means as per HSR item no. 14.1

Cement concrete of ratio 1:2:4 with 20 mm nominal size aggregate in foundation and plinth as per HSR item no 6.1.2

Laying brick work in C.M 1:4 with common burnt clay non modular bricks of class designation 10.5 in F & P as per HSR item no. 7.21.1 A&C slip No.6 dated 06/08/2021

providing and laying in position specified grade of RCC 1:1.5:3 inall work upto plinth level as per HSR item no 6.14.1

Supply of cold twisted deformed (ribbed/tor steel) bars for RCC works where not included in the complete rate of RCC i/c bending, binding and placing in position complete (HSR item No. 6.33.6)

Centering and shuttering of concrete including strutting, propping etc. and removal of form work for foundation, footing, bases for columns as per HSR Item No 6.29.1

Centering and shuttering of concrete including strutting, propping etc. and removal of form work for columns, piers, abutments, pillars, posts and struts as per HSR Item No 6.29.3

Centering and shuttering of concrete for suspanded floors, roofs, landing as per HSR item no. 6.30.3

Providing and fixing 1 mm thick sheet door and window with flame of 40x40x6 mm angle iron and 3 mm M.S.gusset plates at the junctions and corners, all necessary fittings complete, including appling a priming coat of approved steel primer.as per HSR item No.13.6.1

Suppling and fixing rolling shutters of approved make, made of required size M.S. laths, interlocked together through their entire length and jointed together at the end by end locks complete with all respect. As per HSR item no. 13.37.1

Laying 10 mm thick cement plaster 1:3 As per HSR Item No 11.4.2

Tile tracing brick masnory 5 cm thick with common brunt clay non-moduler tile bricks of class designation 10 in cement mortor 1:3 in super structure above plinth and up to floor four level.as per HSR item no. 7.35

Electricity fitting in structure complete in all respect as per site condition

Colour washing such as green ,blue or buff to give an even shade for new work with a base coat of whiteing.as per HSR item no.11.62.2 for interior surfaces

Finishing walls with water proofing cement cement paint of required shape as per HSR item no. 11.93 for exterior surfaces

Providing and laying 80 mm thick ISI marked interlocking pavers blocks as per HSR item no. 17.69.2

Demolishing brick work manually or by mechanical means including stacking of serviceable material and disposal of unservicable material with in 50 mtr. Lead as per HSR ite,m no. 5.7.4

credit of material

M/S SHREE BALAJI BUILDERS

The Tibba Dana Sher Co Op L and C Society Limited