REPAIR TO PATH, DRAIN, GATES, BOUNDARY WALL, PCC HARD STANDING AND OTHER MISC WORK AT VSN NAGPUR

Amount

Demolition of Reinforced cement concrete of any description and in any position not otherwise specifically provided for complete all as specified and directed.

M & L Pre-cast reinforced cement concrete 1:2:4 type B1 (Using 20mm graded stone aggregate) set in cement mortar 1:4 for man holes and drain cover slab all as specified and directed.

M&L for Mild steel TMT bars 10 mm dia., and over cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with mild steel wire (annealed) not less than 0.9 mm dia., or securing with clips all as specified and directed.

Demolition of cement concrete (unreinforced) in ground floors and pavings not exceeding 15 cm thickness.(below or above ground level) all as specified and directed.

M & L for hardcore of gauge not exceeding 63 mm of broken granite stone, deposited, spread and levelled in layers not exceeding 15 cm thick, watered and rammed to a true surface all as specified and directed.

M & L for Plain Cement Concrete Type E2 1:5:10 (using 40 mm graded granite stone aggregate) in foundations, filling and mass concrete complete all as specified and directed.

M & L 40 mm thick PCC 1:2:4 type B1 (using 20 mm graded granite stone aggregate) in floorings including finishing the surface even and smooth using extra cement all as specified and directed.

Demolition of brick work or stone/ boulder masonry, built in cement mortar or cement lime mortar including all quoins, pillars etc all as specified and directed.

M&L for Brick work with fly ash bricks, straight or curved on plan exceeding 6 M mean radius built in cement mortar 1:6 all as specified and directed.

Taking down cement or cement lime plaster on brick or stone walls, etc., including raking out joints, hacking for key, scrubbing down with water, etc. all as specified and directed.

M & L for rendering 15mm thick on fair faces of brick work or concrete surfaces in cement mortar 1:4, finished even and smooth without using extra cement all as specified and directed.

M&L for preparing new plastered surfaces and applying Two coats of cement base paint over a coat of alkali resistant primer on surfaces of walls all as specified and directed.

M & for Plain Cement Concrete Type B0 1:2:4 (using 12.5 mm graded granite stone aggregate) in lintels upto 1.5m clear span, copings, kneelers, including weathering, slightly rounded or chamfered angles and throating, all as specified and directed.

M & L for machine pressed precast concrete interlocking rubber moulded / PU moulded paver blocks of approved shape and size confirming to IS- 15658-2006 of 60 mm thick ( M-35 Grade) fixed with and including 25mm thick sand/ stone dust cushioning complete all as specified & directed.

M&L for Grubbing up tree trunk including cutting of trunk protruded over brick wall,chajja,roof digging out roots filling hole with concrete 1:2:4 type B 0 (using 12.5mm graded stone aggregate) girth of tree exc 30cm and n exc100cm and removing of unserviceable material to a distance n exc50m and clearing site complete all as directed .

M&L for welding in repairs n exc 2.5cm in length n exc 6mm thick all as specified NOTE-garage doors steel gates windows ventilators or, steel doors etc shall be repaired.

S & F Framed work as in doors or gates of angle or other section with gusset plates ,rails,braces,etc.,complete,drilled for fixing of steel sheeting or other covering. Doors ,etc.To be prepared for hanging or sliding with and including either hooks and hinges or steel hanging doors fittings(exclusive of steel sheeting or other covering, running rails and guides)and hanging, also fastening and fixing including all necessary taking down of old gates of any description complete all as specified and directed.

M&L for preparing new surfaces of steel of any description over 10cm width or girth and apply two coats of synthetic enamel paint over a coat of red oxide primer all as specified and as directed.

M & L for Providing precast cement concrete Type B0 1:2:4 (12.5mm graded aggregate)louvres and jallies, 40mm thick (mea-sured solid), including all mouldings but excluding frame Set in Cement Mortar 1:4 all as specified and directed.

Dismantling Asbestos Cement (Corrugated, Semi corrugated etc.) sheets in roof coverings all as specified and directed.

M&L Pre -painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of an colour having tensile strength of 550Mpa as in roof covering /cladding to wall ,fixed with self tapping screws as specified & directed.

M & L for repairs to ends of chajja by removing the old loose concrete material, cleaning the reinforcement and finishing the surface apply epoxy base resin of manufacturer Pidcrete and Chowkasi and make good with concrete 1:1.5:3 as required to existing broken surafce and fair and even in cement mortar 1:3 with epoxy coating and applying two coats of weather proof emulsion paint upto 600 mm depth and 100 mm thickness including nessasary scofolding as required at site etc all as specified and directed.

M & L for drilling hole of up to 10 mm dia and cleaning by air blowing and flushing with water and inserting 6 mm/8mm dia deformed bars upto depth of 200 mm and weld with existing bar and finished with using polyster resin grooves consisting of polister and filter and lokspit (pumpable grade) for columns beams and chajjas etc. all as per manufacture instruction and all as directed by Engg-in-charge.

M/s Prakash R. Verma

VIJ ASSOCIATES

Asha Enterprises

Meet Road Lines

Vishwakarma Engineering Works

dhanshree enterprises

M/s Prakash Agencies

S D WAGHAMSHI