Fabrication, Erection, Commissioning and Installation of two oil tank for reclaim Oil/Fresh oil of Capacity 10 K.L. along with Oil Pump and Control Panel at Workshop Talkatora.

Amount

Fabrication, Erection and Commissioning of Transformer Oil Tanker of 10 KL capacity made pf 5.0 mm M.S. plate of 1676 mm dia and 4572 mm height duly welded properly with welding electrodes resist the weight of oil and jerk during loading/unloading with following other arrangement .

provision of proper main-hole with its cover and with proper size of bolts and nuts .

Two nos. Gate valve of 50mm of good quality with proper protection device.

Suitable stand for climbing device on the tank

Suitable stand for oil tank duly welded to keep the tanker 400mm high from ground level.

Painting inside the tank with heat resistant paint(zinc chromate) which will bear high temperature and will not melt with oil.

Painting outside of tanker with red oxide paint one coat and two coats of grey enamel paint ISI mark.

Capacity charts/marking in K.L has to be provided on the tank.

Providing and installation of heavy duty mono block Oil motor pump(1.5 HP single phase) .

Providing and installation of Electrical control panel for operation of motor, heaters, float switches with appropiate size Cu. Cables, switches in all respect confirming to ISS

Providing and installation of pipe line using heavy duty c class pipe along with valves and t- joints connector , l bow and digging of nali (15cm wide and 30 cm deep )on the floor (30cm wide and 15 cm deep) for laying of pipe line , fixing pipe line and filling the nali back by cc ratio 1:2 complete job .

40 mm gi pipe conforming to IS 1239 part 1 2004 (OD-48.3 mm )

brass valves 40 mm (gate type) conforming to IS 1239

nitrile rubber hosepipe (steel wire braided) 25 mm (oil withstanding temp 1000C).

T -connector 40 mm of GI confirming to IS 1239 part -1 2004.

L-bow of 40 mm GI confirming to IS 1239.

MS JANTA ELECTRIC WORKS