SPL REPAIRS TO GUN SHED NO 98 AND 99 OF 1890 RKT REGT (PINAKA) AT NASIRABAD MIL STN

Amount

Dismantling Asbestos Cement (corrugated, semi corrugated, etc) sheets in roof covering complete all as specified & directed.

S&F Pre-painted galvatume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws complete all as specified & directed. Make: Tata blue scope/ Everest industries/ Jindal

S&F Pre-painted galvatume aluminum zinc coating GI based Plain steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws complete all as specified & directed. Make: Tata blue scope/ Everest industries/ Jindal

S&F framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc complete drilled for fixing of steel sheeting or other covering door etc complete all as specified.(Fe 290 Gde E-165) complete all as specified and directed. Note: Weight shall be verified by the GE

Ditto all as per item No. 4.00 above but fixing and erection only after necessary repairs complete all as specified and directed.

S&F in repair 1.25mm MS sheets plain black sheet cut to size,holes punched including rounded headed scarews, clout nails or rivets and fixed to steel framing with plain 40mm lap joints with riveted or welded seams including bending or as in covering to door shutters complete all as specified and directed.

Demolition of cement concrete (un-reinforced) of any description and in any position not otherwise specifically provided for complete all as specified and directed.

Racking out joints/ pointing to RR masonry or brought upto couse built in cement mortar complete all as specified and directed.

M&L for keyed pointing CM (1:4) to RR masonry uncoursed or brought upto course complete all as specified and directed.

M&L for preparation of new steel surface over 10cm width or girth & applying two coats of synthetic enamel paint of 1st quality over a coat of red oxide primer complete all as spd & directed.

M&L for preparation of old painted steel surfaces of any description not otherwise described over 10cm width or girth and applying one coats of synthetic enamel paint (Ist quality) of approved tint to achieve glossy finish complete all as specified and directed

Taking down cement or cement lime plaster on stone/brick wall, Raking out joints, hacking for key, scrubbing down with water etc complete all as specified and directed.

M&L for rendering in cement mortar (1:6),15mm thick on stone masonary surfaces finished smooth & even complete all as specified and directed

M&L for rendering 15mm thick in CM (1:4) on stone masonary, external surfaces finished fair & even complete all as specified and directed

M&L for preparation newly plastered surfaces of walls and applying three coat of white wash complete as specified and directed.

M&L for preparation new decorated surfaces of walls and applying two coat of cement base paint complete all as specified and directed.

M&L for preparation old decorated surfaces of walls and applying one coat of cement base paint complete all as specified and directed.

M&L for PCC (1:3:6) type C-1 (using 20mm graded crushed stone aggregate) 50mm thick as in plinth protection finished even and fair laid in alternate bays n.exc 2m in length complete all as specified and directed.

Demolition of stone/ brick masonary built in cement or cement lime mortar complete all as specified and directed.

M&L for walling of random rubble uncoursed well bonded bedded and solidly hearted built in cement mortar (1:6) complete all as specified and directed.

Ditto all as per item no 20.00 above except stone complete all as specified and directed.

Taking down carefully copper/aluminium point wiring (light, fan, socket or power) complete, including fittings such as switches, ceiling roses, holders, regulators, sockets etc.

Disconnecting unserviceable sub main wiring/service connection of any size and including steel conduit and accessories and removing from site and making good the disturbed surfaces.

Taking down MCB DB's complete with MCB's/Isolator etc removing materials from site and making good disturbed surface of walls, floors etc.

M&L for point wiring with 1.5 Sqmm, PVC insulated, unsheathed, stranded copper conductor single core FRLS cable, IS-694 marked, drawn through and including non metallic rigid PVC concealed conduit 20mm dia or higher complete with all PVC conduit accessories and sunk type pressed steel terminal switch box 1.2 mm thick with bakelite laminated sheet top cover 3mm thick, brass screws and cup washers including 1.5 Sqmm stranded copper conductor PVC insulated green in colour as continous earth conductor connected to common earth with all accessories for:-

One light point/bell point controlled by one, one way switch.

One three pin 5 Amp socket on same board with other switches.

One 3 pin 5 Amp socket on independent board.

S&F sub main wiring with two runs of single core PVC insulated and unsheathed multistranded (FRLS) copper conductor cable of size 4.00 Sqmm LT, 1100 volts grade, drawn through and including 25 mm dia or higher PVC non metallic surface conduit with accessories and one run of 4 sqmm single core multistranded copper conductor cable green colour as earth continuity conductor.

S&F switch piano flush type 5 amps, single pole one way 240 volts.

S&F Socket outlet 3 Pin 5/6 Amp flush type.

S&F ceiling rose surface bakelite 3 terminals 63.5 x 17 mm.

S&F in repair LED tube light fitting in acrylic linear tube (1x 18 watt),230V for single LED tube light including 1 x 18 W LED retrofit bar professional CW 6500 K cover channel, bipin holders,LED power driver, connector block, etc complete with all accessories internally prewired and including connecting up with three core flexible copper conductor cable with suitable size for connection of fitting from ceiling rose complete all as specified and directed. Make: Bajaj Cat Part No BLRB 18W CW for tube , BLRB - DB 118 for batten, Havells Cat part No LHLDDBXEUL7Z018 (for tube) LHFYBWP1TB1W020 (for batten), Jaquar Cat Part no. LTBL01x018C ( for tube) LINDPATI 118X ( for batten), Syska Cat part No SSK -T8-18W (tube) SSK-TL-22 F (batten)

Supply, fixing and testing energy saving street light luminaire 15 watt LED , pressure die cast housing , polycarbonate diffuser, IP 65 protection complete with street light bracket made of 40 mm GI pipe , 1.2 mtr lenght with clamp, nut and bolts complete all as specified and directed. Make: Havells Cat Part no. LHEWEBP7PL6S015 or equivalent model of Syska/HPL/Bajaj

S&F MCB distribution board single pole & neutral with 200 Amps rated bus bar, double door IP-43 DB's, 4 way, 240 volts suitable for housing MCB's. Make: Legrand/Schneider/Seimens

S&F MCB SP, 240 volt, 6 Amp to 20 Amp capacity, 10 KA, . Make: Legrand/Schneider/Seimens

S&F MCB SPN, 240 volt, 20 Amp capacity, 10 KA, . Make: Legrand/Schneider/Seimens

S&F MCB SPN, 240 volt, 10 Amp capacity, 10 KA, . Make: Legrand/Schneider/Seimens

M&L for earthing complete with galvanised steel earth plate electrode 60cmx60cmx6 mm thick buried directly in ground vertically to a depth not less than 2.25m below ground level with top edge of the earth plate at a depth not less than 1.5m below ground level, connected to galvanised earth lead wire 4.00 mm dia by means of bolts, nuts, check nuts and washers of galvanised iron or steel and other end of earth wire connected to main switch board and protected by galvanised iron pipe light grade 15mm bore and water pipe 20 mm bore GI light grade with funnel and wire mesh PCC chamber in cement concrete 1:3:6 type C-2 and RCC cover with handle all as specified and shown in elect plate No 3 of SSR Part-I of 2009 incl dismantling of old unsv existing earthing .

Supply, laying and connecting 1100 volt grade heavy duty XLPE cable with PVC insulated aluminium conductor served with an inner sheathing of PVC tape, armoured with galvanised steel wire or tape and overall PVC sheathed 10 Sq mm 2 core nominal cross section.

Excavation in trenches in any type of soil not exceeding 1.5 Mtr wide and not exceeding 1.5 Mtr in depth and getting out complete all as specified and directed.

M&L for filling clean and dry sand cushioning for cable in trenches all as specified and directed. Note: Punned thickness shall be measured and paid.

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exceeding 25 cm thick in soft/loose soil complete all as specified and directed

Removal of surplus soil as obtained from excavation to a distance not exc. 50 Mtr and depositing where directed at a level not exc. 1.5 Mtr above the starting point all as specified and directed.

Supply and laying of bricks old class ‘B’ as protect on to UG cable laid flat adjoining to each other width wise all as specified.

Supply and fixing tubes light grade GI tubing 40 mm dia with all fitting laid in trenches for cable protection.

Note for all items: All items shall be executed as specified and directed by Engr-in-charge.

Pioneer Infrastructures

SHREE BALAJI TRADING CORPORATION

M/S SHIVA TRADERS

M/s SUNIL ENTERPRISES

ANAM BUILDCON

PD GUPTA AND COMPANY

M/S Nexus Projects

M/s Jai Jinendra Constructions

M/s Kishan Gopal Agarwal