vaduganthangal

Amount

Excavation and Erection of RCC, REC, PSC poles upto 8.00m length by using JCB/Manual with Base Plate.

Excavation and Erection of RCC, REC, PSC poles above 8.00m length by using JCB/Manual with base plate.

Excavation and Erection of RCC, REC, PSC poles above Upto/above 8.00m length by using JCB/Manual with base plate.(Hard Soil)

Excavation and Erection of RCC, REC, PSC poles upto/above 8.00m length by using JCB/Manual with base plate (In rocky area)

Excavation and Erection of stay set complete with fixing up stay wire Eye, Bow,Guy Shackle, Binding, Stay Plate etc.

Fixing of HT Tapping X arm

Fixing of HT V Cross arms 3 1/2, 4 1/2 & 5 feet

Fixing of LT 3 Phase cross arm

Fixing of HT / LT TI Fitting

Fixing of HT Pin Insulators (11/33KV)

Fixing of HT 11KV stain disc

Fixing of LT Shackle

Fixing of Aluminium knob

Paving and stringing of conductors of sizes upto 7/2.59 mm ACSR or other equivalent conductor/AB Cable. (route length)

Paving and stringing of conductors of sizes above 7/2.59 mm ACSR or other equivalent conductor /AB Cable upto 7/3.35mm ACSR. (route length)

Erection of Distribution transformer at structure above 25KVA to 100KVA DT.

ERECTION of Single Pole TRANSFORMER STRUCTURE COMPLETE inclusive of following works - Excavation of pole pits sizing 2' X 2' X 6', erection of poles, erection of base plate, erection of structure materials , erection of 11 KV GOS and HG Fuse, Structure Earthing complete , Pole concreting (2' x 2' x 6') for both base and sleeve including supply of jelly, sand and cement by the contractor in the ratio of concreting 1:2:4 , plinth erection with plastering ratio 1:2 including supply of cement and sand , Fixing of Open Type fuse units, HT/LT LAS fixing and LAS earthing through PVC Pipe 0.5" , Provision of bus-bar arrangement, Erection of Stay Set complete, Jumpering, erection of support angles and insulators if any , Alteration of materials in lathe works if any, provision of danger board, 3 Nos Earth pipe including erection of cement collar and painting of pole with Distember (paint and earth bit collar to be supplied by contractor) (without centre support)

Transporting of all types of poles by bullock cart or other vehicle (for all size of poles including loading and unloading) for a lead upto 5KM

Transporting of all types of poles by bullock cart or other vehicle (for all size of poles including loading and unloading) Above 5KM of lead of every KM

Transporting of Distribution Transformer / Line materials from Sub stores to office/ site upto 10KM distance by engaging 1 ton capacity Minidor(lorry)

Transporting of Distribution Transformer / Line materials from stores to office/ site above 10KM distance by engaging 1 ton capacity Minidor(lorry)

Loading/Unloading of DT upto 100KVA

Loading/Unloading of variouse size of REC, RCC,PSC Poles upto 8.0m length

Loading/Unloading of variouse size of REC, RCC,PSC Poles above 8.0m length

Loading/Unloading of line material

Dismandling of Cross arm clamps, TI fittings hardwares, insulators etc.

Earthing of poles with GI wires 4/ 6/8 SWG by coil earthing

Cement Concrete of ratio for individual poles shall be in the ratio of 1:2:4 (1 part Cement, 2 parts coarse sand and 4 parts 20mm aggregate stones chips)(material +labour) Mass concreting of poles

Releasing of Refizing of 1ph service wire connections

Releasing of Refizing of 3ph service wire connections

Manufacturing of earth pipe clamps for structure including drilling and welding of clamps.

Drilling of hole in channel only 3/4" & 1" per hole

Open type side arm stud, cutting, drilling holes

Alteration of clamp

Tree cutting

E.P.F. @13 % should be Entered by the Bidder

E.S.I. @3.25 % should be Entered by the Bidder

G.S.T. @18% should be Entered by the Bidder