Repair to Ceiling plaster, Chajjas, Plinth Protection, Grouting water proofing treatment and other misc work under GE (North) Bikaner

Amount

Demoliton of brick work built in cement mortar including all quions arches pillars etc

Demolition of cement concrete reinforced as in roof slab , beams, chhajas and similar suspended work reinforcement cut as required to facilitate demolition.

Demolition of spalling concrete from soffits of slab to any thickness in controlled manner including cleaning of reinforcement as directed and approved by Eng-in-Charge.

Demolition of cement concrete in ground floor and paving not exc. 15cm thickness (below or above GL)

Raking out joints of stone slabs or precast rcc slabs any description laid flat as in roofs , slants etc built in cement mortar .

Dismantling timber scantling over 40 sqcm in section in any position.

Dismantling timber scantling under 40 sqcm in section.

Dismentling wrought iron or mild steel work of any description as in girders etc

Dimantling pipes of any desc.fixed to wall or laid under floor

Taking down cement plaster on brick or stone walls incl. raking out joints hacking for key scrubbing down with water etc.

M&L Brickwork with fly ash bricks, straight or curved on plan exc 6m mean radius,old sized bricks, built in built in CM 1:4.

M&L for TMT bars 10mm dia and over in reinforcement, cut to length, bent to shape required including cranking, bending spirally or hooping for columns, hooking ends and binding with Mild Steel wire (annealed) not less than 0.9mm dia complete all as specified.

M&L TMT bar 6mm to 8mm dia for reinforcement.

M&L for TMT bars 5 mm to 10 mm dia as in stirrups, spacers. and binders

M&L Reinforced cement concrte M-25 design mix in slabs using 20 mm graded crushed stone aggregate .

M&L Form work to soffits of suspended slabs such as roof slab floor slabs landings etc .

M&L Form work to edges of concrete flat floor and roofs n.exc 20cm wide to rough finished surface of concrete .

M&L Reinforced cement concrete 1:2:4 type B-1 ( using 20 mm graded crushed stone aggregate) as in chajjas,parapets and the like, all as specified and directed by Engr-in-Charge. (Note : Contractor shall shall have no claim on height of form work reqd )

M& L PCC 1:2:4 Type B0 (12.5 mm graded aggregate as in coloumns , bed plates,mud stops , copings , RCC lintels , rcc bands , kerbs incl weathering , slightly rounded or chamfered angles etc

M&l Formwork to chullah hoods, chajjas, troughs , stairs etc and similar items including edges

M&L for 75 mm thick cement concrete 1:3:6 type C-2 (using 40 mm graded stone aggregate) as in plinth protection laid to slope of 1 in 12 and finishing cement concrete surface even and smooth without using extra cement with and including all necessary form work to divide the area in panels, finishing exposed edges fair or rounding or chamfering of exposed edges where directed and providing 6 mm thick joints through the thickness of plinth protection duly filled with mastic filling of one part of hot bitumen 85/25 grade and three parts of fine sand (all by weight) complete.

M & L Mild steel Joist, channel , angles or tee sections fixed independentely , without connecting plates , etc cut in ordinary length all as specified and directed by Engineer- in -charg

M&l PVC(SWR)single socketed in any length with rubber ring joint fixed with wall of 110mm as in rain water pipe

M&L PVC(SWR) bends any radius 110mm.

M&L Mild steel work in stairs framed including stringers , treads , landings , balusters, hand rails , clamps for rain water pipes etc including cleats brackets etccomplete all as spfd conforfing to Gde 410 W (Gde E-250 ) quality B

M&L for Rendering 15mm thick cement plaster on fair faces of brick or conc. Surfaces in cement mortar 1:4,even and smooth w/o using extra cement ,incl mixing of water proofing compound .(Note WPC shall be measured and paid for seperately)

M&L for Rendering 15mm thick cement plaster on fair faces of brick or concrete. Surfaces in cement mortar 1:6,even and smooth w/o using extra cement .

M & L for Rendering 5mm thick cement plaster on concrete surfaces in ceiling in CM 1:3 finished even and smooth.

Supply only water proofing compound, ISI marked, complete all as specified and as directed by Engineer-in-Charge.

M&L Apply one coat of “Dr Fixit Rust Remover” (Rust removing chemical) or “Defroster” or equivalent chemical as approved to old rusted reinforcement after necessary preparation of surfaces by brush application

M&L hard drawn steel wire fabric cut to length bent to shape, fabric 3 mm dia, 50 mm mesh cover entire steel surface not exc. 4 kg per sq m

M&L Bonding the entire exposed surface with one coat of “Fosroc Ntobond SBR” as per manufacture instruction

M&L Apply one layer of Fosroc spray ser SL concrete 20 mm to 25 mm thick (comprises composition 1:2:1 plain cement concrete i.e. one part of cement two parts of fine aggregate and one part of 10 mm and down size trap stone aggregate) mixed with spray set SL 2 to 2.5% weight of cement and 12.5 to 16.5 liters of water mixed as per manufacture instructions and gunniting pressure nozzle with a delivery capacity of 2.5 kg per sq m over column, beam, roof slab and other similar work .(Note Contractor shall provide the even surface (with out any extra cost to govt ) duly floated and clearence from wall floor or site damaged due to splashing of cement grouts)

M&L for 10 mm thick rendering in cement mortar 1:4 over gunniting / concrete surface and finished the surfaces even and smooth without using extra cement.

M&L for 40-50mm thick sand stone slab not exc 2mtr in length, punched dressed self faced set and pointed in CM 1:4 as in plinth protection and chajjas complete ass as directed

S & F Mild steel framed work such as grills, framed guard bars barred iron doors, ladders framed balusters railing and similar works confirming to FE 410-0 0r Fe 310-0

M&L for flush pointing in cement mortar 1:3 on ceiling surfaces of stone patti roofs / soffits of slabs complete

M&L Preparation of surfaces of new surfaces including removal of old treatment and applying a thin layer of Birla white putty to give a uniform finish as app by Eng-in -charge and reqd at site

M&L Preparation of surfaces of old or new surfaces including removal of old treatment and applying a thin layer of plaster of parris to give a uniform finish as directed by Eng-in -charge.

Preparation of newly plastered surfaces of wall and applying two coats of distemper oil emulsion, white or tinted over a coat of primer as per manufacturer,s instructions complete all as specified and as directed by Engineer-in-Charge.

M&L for applying one coat of oil bound distamper on old decorated surfaces of desired finish as directed by Eng-in-charge in any position

Preparation of newly plastered surfaces of wall and applying two coats of cement based complete all as specified and directed by Engineer-in-charge.

M&L for one coat cement base paint on old plastered or un plastered surfaces including preparation of surfaces.

M&L Preparing surfaces of plastered or unplastered new and applying three coats of white wash on ceilings.

M&l Prerparing old decorated surfaces plastered/unplastered by brooming down etc and applying one coat of white wash on ceiling complete all as specified.

M&L preparation of new steel surfaces and applying two coats of synthetical enamel paid over a coat of red oxide zinc chrome primer .

Complete removal of white wash of old plastered surfaces of wall and applying two coats of distemper oil emulsion, white or tinted over a coat of chalk whiting and one coat of wall care putty complete all as specified and as directed by Engineer-in-Charge.

Complete removal of existing treatment of walls and applying two coat of cement base paint (Ist quality) in plain pattern on walls and over a coat of primer as per manufacturers instructions complete all as specified.

SHREE GURU NANAK CONSTRUCTION COMPANY

LOKESH AND CO.