SPECIAL REPAIR TO BLDG NO 05 AND CONSTR OF A VEH SHED NEAR BLDG NO T-21 AT AGE B/R-I UNDER GE BABINA

Amount

Excavation in trenches in any type of soil not exe 1.5 mtrs wide and not exe 1.5 mtr in depth and getting out etc complete all as specified and directed .

Returning, filling in, including spreading, watering and well ramming in layers n. exc 25 cm thick in any type of soil complete all as specified and as directed.

Removing excavated material to a distance n exc 50M and deposited where directed at a level n. exc 1.5M above the starting point complete all as specified and as directed.

M&L for moorum in floors ,laid in layers n exc 15 cm thickness spread ,levelled , rammed and watering etc complete and all as specified

M&L for brick work with Fly Ash bricks ( FASB) straight or curved on plan exc 6 M radius built in cement mortar (1 : 6) etc complete all as specified and as directed.

M&L for PCC 1:4:8 type D2 using 40mm graded stone agg as in filling and mass concrete, sub base/flooring complete all as specified and directed.

M&L for PCC 1:2:4 type B-2 using 40mm graded stone agg as in filling and mass concrete, sub base/flooring complete all as specified and directed.

M & L for PCC 1:1.5: 3 Type A-1 using 20 mm graded stone aggregate as in kerb stone /coping /Bed block etc complete all as specified and as directed.

M&L for M-25 ( Design Mix ) as in roof beams , lintel beams etc complete all as specified and directed. Note : Reinforcement to be measured separately and paid seperately

M&L Form work to soffits and sides of lintel beams /roof beams /roof slab and similar , surfaces of concrete fair finish etc complete all as specified and directed .

M&L for mild steel TMT bars 8 mm dia, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hookingends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips etc complete all as specified and directed

M&L for mild steel TMT bars 10 mm dia and over , cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hookingends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips etc complete all as specified and directed

S&F mild steel work as in fillets , wind tie , purlins , grills , gratings , guard bars etc incl distance pieces , cleats etc of 290gde - E-165 etc complete all as specified and as directed. Make : As specified in tender documents

S&F mild steel work as in Roof trusses ( framed ) trussed , purlins , crane gentries rails and fastenings and heavy brackets framing ( Beam,Tee,Angle, Channel or flat sections ) incl distance pieces ,cleats etc of 290gde - E-165 etc complete all as specified and as directed. Make : As specified in tender documents

S&F mild steel ( Plain) plates , square cut or notched (ordinary and counter sunk) forming holes of suitable dia if required and fixed to pipe by electric welding alround the neck of pipe etc complete and as directed.

S&F mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, n exc 10 cm length and 11 to 15 mm dia of both

Taking out /Dismantling of existing roof treatment of any description , any position over roof including taking out plain cement concrete of any description to the thckness as directed etc complete and including lowering down complete waste materials to the ground on a place where directed and including removal of the same to a distance exc 250 mtr but n exc 500 mtr as directed .Note : The cost of lowering down and removal deemed included in unit rtae quoted by the tenderer.

Cutting grooves in brick wall 75mm wide and 65mm deep and shaping horizontal face of groove sealed with cement mortar 1:3 complete and as directed.

M&L for P.C.C 1:2:4 type B-1 using 20 mm graded stone aggregate as in padding laid to slope over roof and surface finished even and fair etc complete all as specified and as directed. Note : The thickness of PCC shall not be exceeded more than 75 mm at any place

M&L for P.C.C 1:2:4 type B-1 using 20 mm graded stone aggregate as in coping and on roof etc complete all as specified and as directed.

M&L for 10 mm thick rendering in cement mortar 1:4 on concrete surfaces when concrete is still green including mixing of water proofing compound as per manufacturer instruction, surface finished even and fair enough to receive water proofing traetment etc complete all as specified and as directed.

S & F false ceiling ornamental type in two stages (( secondary ceiling ( second stage ) shall be 20 cm lower than main ceiling ( First stage ) ) using GI sections of manufacturer approved by the GE in writing , hanged with GI strips of suitable thickness and appropriate length and chicken GI wire mesh between runners and M&L for 9 mm thick casting ceiling with plaster of Paris ( Cast in situ ) surfaces of finish smooth and applying two coats of interior emulsion ROYAL SHINE of Asian Paint Ltd / Berger Sleek incl all accessories as required etc complete and as directed Make: M/S Saint Gobain Gyproc India Ltd / Indian gypsum Pvt ltd / Armstrong

Roughening of existing surfaces of roof by picking ,sweeping clean and washing down with water to remove dust etc and applying neat cement slurrry @ 3 Kg per sqm etc as directed

Supply only Liquid water proofing compound ( ISI marked ) as directed.

M&L for providing water proofing treatment over roof by applying the following operations :- (a) Preparation of plastered surface by cleaning with water and leave the sufaces till to become surface total dry . (b) Applying first coat of bitumen primer conforming to IS-3384 @ 0.4Kg / Sqm on plastered surface (c) Applying APP based polymeric membrane 3mm thick (Minimum thickness) and weight not less than 3kg/Sqm , reinforced with polyester non woven fabric (wt not less than 150 gms/sqm) over on primed surface laid with 100mm side lap/end lap on prepared surfaces as per manufacturers instructions and under strict supervision of manufacturer's tenchnical representative etc and applying two coats of bituminous based aluminum paint @ 100 ml/sqm each coat etc complete and as directed. Note : Testing of APP membrane is mandatory and contractor will not be allowed to carry out the work untill results are obtained and found satisfactory . No payment what so ever on this account shall be admissible . (ii) The cost of casting one cement plate of size 600 mm x 450 mm , 10 mm thick rendering in CM 1:3 in each building incl writing materials shall deemed to be included in the unit rate quoted by the tenderer. Make of APP Membrane : M/S IWL INDIA LTD , C&D LAKSHMI BHAWAN,609 ANNA SALAI CHENNAI / PIDILITE ( DR FIXIT TORCH SHIELD / M/S SHALIMAR TAR PRODUCTS STP HOUSE 570 PHASE V UDYOG VIHAR GURGAON /M/S TIKKI TAR DONASA ( INDIA) PVT LTD VILL ROAD BHANDUP Make of Bitumen: ISI Marked bearing IS-702 Make of bitumin primer : ISI Marked bearing IS-3384

S&F Pre painted Galvalume aluminium zinc coating GI based corrugated steel sheet 0.50mm thick coloured having tensile strength of 550 Mpa as in roof covering and fixed with self tapping screws and as directed . Make: TATA, ESSAR, M/S JSW Jindal

S&F Pre painted Galvalume aluminium zinc coating GI basedplain steel sheet 0.50mm thick coloured having tensile strength of 550 Mpa as in cladding / wall fixed with self tapping screws and as directed . Make: TATA, ESSAR, M/S JSW Jindal

M & L for 100 mm thick PCC 1:2:4 type B-1 using 20 mm graded stone aggregate as in floors laid in alter panel not exceeding 24 Sqm each or as Approved by the EIC keeping the panel size in equality as per site requirement , panel formed with steel form work , surfaces of concrete finish even and fair etc complete all as specified and as directed. Note : Cost of forming panel deemed to be included in the rate quoted by the tenderer.

M &L for Stone sett flooring with stone setts of size 200 to 250mm long, 150 to 200mm wide and 150mm deep and sides dressed; bedded in cement mortar 1:3, joints 20mm thick; grouted in cement mortar 1:2 with an admixture of metallic floor hardner 5% by weight of cement and struck flush etc complete all as directed.

M & L for 15 mm thick rendering in cement mortar 1: 6 on fair faces of brick work or concrete surfaces, surface finished even and smooth without using extra cement complete all as specified and as directed.

M&L for preparing new surfaces of steel of any description, over 10cm in width or girth not otherwise described and applying two coats of synthetic enamel paints over one coat of red oxide primer all as specified

Taking up or down existing steel tubing and connections including cleaning for refixing etc complete all as specified and as directed for 15 mm bore

Taking up or down existing steel tubing and connections including cleaning for refixing etc complete all as specified and as directed for 20 mm bore

Supplying, fixing, jointing and testing 15 mm dia galvanised iron tubing medium grade ISI Marked with all fitting such as bends, elbow, socket, reducer etc and fixed to wall or laid in floor complete all as specified and as directed Make: TATA, JINDAL, ZENITH

Supplying, fixing, jointing and testing 20 mm dia galvanised iron tubing medium grade ISI Marked with all fitting such as bends, elbow, socket, reducer etc and fixed to wall or laid in floor complete all as specified and as directed Make: TATA, JINDAL, ZENITH

Taking down old existing unserviceable tank ( RCC/PVC/Steel ) and of capacity exc 500 ltrs but n exc 1000 ltrs complete as direcetd

Taking down old existing unserviceable tank ( RCC/PVC/Steel ) and of capacity exc250 ltrs but n exc 500 ltrs complete as direcetd

S&F 500 ltr capacity or rotational moulded polyethylene water storage tank (cylindrical vertical with closed top) WHITE , ISI marked , Triple layered construction hoisted and fixed in position including S&F 20mm dia GI pipe medium grade washout pipe 450mm long with plug and 20mm dia GI pipe medium grade overflow pipe 600mm long with fitting etc complete all as specified in SSR Part -I 2009 complete all as specified and as directed. Make : VECTUS/SINTEX PURE anti bacterial /Polywell/Polywell /JS POLYPLAST

S&F 1000 ltr capacity or rotational moulded polyethylene water storage tank (cylindrical vertical with closed top) WHITE , ISI marked , Triple layered construction hoisted and fixed in position including S&F 20mm dia GI pipe medium grade washout pipe 450mm long with plug and 20mm dia GI pipe medium grade overflow pipe 600mm long with fitting etc complete all as specified in SSR Part -I 2009 complete all as specified and as directed. Make : VECTUS/SINTEX PURE anti bacterial /Polywell/Polywell /JS POLYPLAST

S & F ball valve high pressure of PTMT with epoxy coated aluminium rod & highdensity plastic ball screwed for iron pipe 20 mm dia and fixed in new tank (minimum weight 20mm 210 gm) complete all as specified. Make : Prayag/Polytuff/Symet

S&F 20 mm gun metal gate valve ( ISI Marked ) with iron wheel head screwed both ends for iron pipe etc complete as directed. Make : Leader/ SANT/Zoloto

M& L 15mm thick rendering in CM 1:6 on fair faces of brick work or concrete surfaces finished smooth and even without using extra cement complete all as specified and directed.

Excavation over areas n exc 1.5 mtr deep and getting out in any type of soils complete all as specified and direceted

M/s Ravi Traders

M/S M S Constructions