REPAIR/ REPLACEMENT OF TILING, SANITARY FITTINGS AND OTHER CONNECTED WORK IN OFFICER ENCLAVE AREA AND NEW PROJECT AREA AT AF STN MANAURI.

Amount

Demolition of Brick works, built in cement mortar or cement lime mortar including all quoins, arches, pillars etc but excluding ashlar facing, dressed stone work and pre-cast concrete articles complete all as specified and directed.

M & L brick work with sub class 'B' old size brick, designation 75, straight or curved on plan exc 6M mean radius built in cement mortar 1:6 complete all as specified and as directed.

M & L for brick work with subclass “B” [Except bricks] Old size bricks, straight or curved on plan exceeding 6 m mean radius built in cement sand mortar in 1:6 complete all as specified & directed. Note: Old Bricks shall be used obtained from serial Item No. 01 above.

M & L for brick work with subclass “B” old size bricks, straight or curved on plan to any radius in half brick thick walls, built in cement sand mortar in 1:4 complete all as specified & directed.

Taking down existing cement plaster on wall existing surface complete all as specified and directed.

M & L 15 mm thick rendering on brick work or concrete surface in cement mortar 1:6, surface finished even and smooth without using extra cement complete all as specified

M & L 15 mm thick rendering on brick work or concrete surface in cement mortar 1:4, surface finished even and smooth without using extra cement complete all as specified

M & L preparation of new plastered surfaces on walls and applying two coats of cement base paints over a coat of primer complete all as specified and directed by Engineer-in-Charge.

M & L preparation of new plastered surfaces on walls including cornices and applying three coats of white wash complete all as specified and directed by Engineer-in-Charge.

Dismantling floor, hearth or wall tilling including cement mortar bedding(but not backing), and rubbish off premises etc complete all as specified and directed.

M&L for Vitrified Ceramic tiles 10 mm thick (Square/ rectangular) polished, "light shade' area of each tiles not exceeding 0.36 sqm, in floors etc. set and jointed in neat cement slurry and pointed in white or coloured cement to match over and including 15mm thick screed bed or bedding layer in CM 1:6 complete.

M&L for Vitrified Ceramic tiles 10 mm thick (square/rectangular) polished, "light shade" area of each tiles not exceeding 0.36 sqm, in verticle surface such as in skirting etc. set and jointed in neat cement slurry and pointed in white or coloured cement to match over and including 10mm thick screed bed or bedding layer in CM 1:3.

M & L for 7 to 8 mm thick joint free non-skid ceramic coloured tiles (square / rectangular) area of each tile exceeding 0.11 sqm but not exceeding 0.18 sqm in floors etc set and jointed in neat cement slurry and pointed in coloured cement to match over and including 15 mm thick screed bed in cement mortar 1:6 complete all as specified and directed.

M & L for glazed ceramic coloured tiles size 350x 250x 7 mm / 450X 350X 7mm thick as in vertical surface and jointed in neat cement slurry and pointed in white cement mixed with colour pigment over & including screed bed in 10 mm thick cement sand mortar 1:3 complete

Taking down chowkhat with shutter without taking off shutter from chowkhat area exc 1.5 Sqm but not exceeding 4.00 Sqm each complete all as specified and directed

S & F PVC door frame of size 50x47mm made out of 5mm plain colour PVC sheet reinforced with MS square tube, and fixing in opening as specified and shown on drawing made on section 8 of SSR 2020 Part II and all as directed .

S&F factory made solid panel PVC door shutter, 28-30mm thick (styles) consisting of frame mad out of MS tube for top & bottom rails MS frame shall be covered with heat moulded plain colour PVC "C" channel strip of 20 mm width stuck Inside with solvent cement for stiles and plain colour PVC sheets for top rail; Panelling of plain colour PVC sheet to be fitted in the MS frame welded sealed to the stiles & rails with suitable PVC sheet beading and joined to gether with solvant cement fixing in the frame at the site and as shown on drawing on Section 8 of SSR 2020 Part II complete as directed by Engineer-in-Charge.

Taking down chowkhat with shutter without taking off shutter from chowkhat area not exceeding 1.5 Sqm each complete all as specified & directed.

S & F Steel ventilator with top hung shutters including hinges, with steel handle and steel peg stay complete as specified & directed by Engineer-in-Charge.

Supply & Fixed sheet glass 3 mm thick ordinary quality in Square or rectangular in shape not exceeding 0.5 Sqm each pane and glazing with oil putty or steel pins complete all as specified & directed by Engineer-in-Charge.

S&F mild steel cold rolled butt hinges 100 mm 'medium weight' fixed with screws to PVC or wooden frames or with welding in steel frame, ISI marked complete as specified & directed.

S&F extruded aluminium alloy handles anodised 150mm long fabricated type, ISI marked complete all as specified & directed.

S&F aluminium anodised barrel tower bolts extruded section 200mm long, ISI marked complete all as directed.

Taking down 15mm bore GI tubing and connection fixture etc complete and S&F GI water tubing/pipe 15 mm bore with alll fittings fixed to wall or laid in floors or celings compete all as specified and directed.

Taking down 20mm bore GI tubing and connection fixture etc complete and S&F GI water tubing/pipe 20 mm bore with alll fittings fixed to wall or laid in floors or celings compete all as specified and directed.

S&F in repair angle valve of 15 mm bore cast copper alloy CP high pressure screwed for iron pipes or brass ferrule compete all as specified and directed.

S&F in repair Pillar taps, 15mm bore cast copper alloy CP with with capstan heads, long body screwed down, screwed for lron pipe high pressure with lettered "hot or Coled" with long shank compete all as specified and directed.

S&F in repair Stop valves, 15mm bore cast copper alloy, fancy type CP screwed down high pressure screwed both ends for iron pipes or for unions compete all as specified and directed.

S&F in repair chromium plated cast copper alloy bib taps 15 mm bore fancy type capstan head handles half turn or full turn compete all as specified and directed.

S & F repairs PVC valveless, syphonic action type, flushing cistern, low level, white colour capacity 10 liters with inlet and outlet, ball valve, handle including cast iron brackets & 32 mm bore PVC flush pipes, compete all as specified and directed.

S & F in repairs vitreous china WHB white colour of size 600X480 mm flat back or angle back type including angle iron bracket, waste coupling, PVC waste pipe 32 mm dia 60 cm long fixed pinning in ends of brackets, compete all as specified and directed.

S&F in repairs Vitreous china squatting pan, orissa pattern, size 580x440 mm white, with integral foot rests including connection to trap and to flushing pipe, anti syphonage pipe including making good to floor with PCC 1:2:4 or cement sand mortar 1:3 complete all as specified and directed by Engr - in - charge.

S&F in repairs Vitreous china wash down water closet pan (pedestal pattern) white colour excluding fixing bolts, flushing cistern & flush pipe) but including seat cover white colour & Chromium plated jet sprey with rubber tubing complete all as specified and directed by Engr - in - charge.

S & F in repairs looking mirror fancy type decorative pattern 5 to 6 mm thick and size not less than 450x600mm fixed on wall with stainless steel studs complete all a specified and directed.

S&F in repairs Chromium Plated Stainless steel towel rail 600 mm long D type fixed with CP screw & wooden/plastic cleats etc all as specified and directed by engr-in-charge.

S & F in PVC connections 15mm size with PTMT nuts and bolts of length 450mm etc complete all as specified and directed

S&F in repair PVC waste pipe 32/40mm dia 610mm long suitable for WHB or Sinks etc complete all as specified and directed. (Note :- This item willl be measured separately in repairs.)

S & F in repairs waste coupling CP 32mm for basins etc with long screwed shanks and fly nuts etc complete all as specified and directed.

S & F in repair PVC (SWR) pipes, single socketed, in any length, with rubber rings 110mm dia complete all as specified and directed

S & F in repair chromium plated brass shower roses with or without swivel joints, any size including steel pipe or union with arms complete all as specified and directed

S/F 110mm PVC (SWR) bends any radius. complete all as specified and directed.

S & F cast iron bends in (any radious) diminishing pieces or tapers( larger bore measured) in 100 mm dia complete all as specified and as directed.

S&F in repairs CI floor trap, with 125 mm dia SS grating including jointing to waste pipe fixed in cement concrete 1:2:4 type B-1 compete all as specified and directed.

S & F 100 mm bore cast iron vent cowl, complete all as specified and directed.

S & F in repair cast iron soil waste pipe in 100mm bore of any length with or without ears with cement glands and fixed to wall with suitable clamps on wall complete all as specified and directed

S & F ball brass valves, high pressure, with polythelne float and fly nut in 20mm dia bore complete all as specified and directed.

Demolation of cement concrete (reinforced ) of any description and in any position compete all as specified and directed.

M&L for precast RCC 1:2:4 type B1, using 20 mm graded stone aggregate as in cover Slab and the similar work complete all as specified and directed.

M&L mild steel TMT bar 6-8 mm dia and over cut to length, bend to shape required, including cranking, bending, spirally for hooping for columns, hooking and binding with and including mild steel wire (annealed) not less than 0.9mm dia complete all as specified and directed by the Engineer-in-Charge

S&F in repairs soap dish SS ISI mark complete all as specified and directed.

S & F in repair for health faucet (ABS body) mild steel CP suitable for 15 mm dia pipe with 1.25 mtr long flexible tube and ABS wall hook including making connection and in fixed in position complete in all respect as specified and directed.

Supply and fixed in repair stainless steel kitchen sink with drainage board made of 1.00mm (minimum) thick stainless steel (Grade S-304) sheet with plug washer including bedding in cement mortar to wall or including fixing on RCC platform connecting union to pipe overall (minimum ) size 915mm x 460mm with bowl (minimum) size 410mmx330mmx160mm complete including waste coupling CP, sink mixer wall mounted with 150mm long swivel spout connecting legs & wall flanges, and waste pipe of appropriate size complete all as specified .

S & F Rotational moulded polethelene water storage tanks in 500 litre capasity (cylinderical vertical with closed top) ISI marked, hoisted and fixed in position all as specified in SSR Pt-I including PTMT float valve 20 mm with alumium rod and dismantling of existing PVC tank & removed from site complete all as specified and directed.

S & F Rotational moulded polethelene water storage tanks in 1000 litre capasity (cylinderical vertical with closed top) ISI marked, hoisted and fixed in position all as specified in SSR Pt-I including PTMT float valve 20 mm with alumium rod and dismantling of existing PVC tank & removed from site complete all as specified and directed.

S & F in repairs Shelf of PTMT fixed with and including Chromium plated brass screws and wooden/plastic cleats (Minimum weight 300 gms) all as specified and directed.

S & F in repairs "White" EWC (Cascade type) size 730x370x845mm including all fittings such as seat cover, cistern set including dual flush fittings (floor mounted set) complete & as directed. Make:- Parryware cat Part No cascade NXT C0232/86 closet (S-110/p-190) or equivalent in make Jaguar/ Hindware/ Cera.

Note :- (i) Credit shown in credit schedule of tender document shall be considered by the tenderer while quoting the rates of various items. The same shall be recovered from various payment to contractor before handing over old material. The contract amount shall be arrived at after deduction of Schedule of Credit from the total quoted amount in BOQ. (ii) Make of material shall be as per mentioned in Particular specifications or Appendix 'B' to Particular specifications as approved by AGE (I) AF manauri

M/S SANJAY CONSTRUCTIONS

RK Enterprises

HIMANSHU TRADERS

swastik builders

M/s DKS Engineering Works

M/S SATISH KUMAR

Pleiad Complex On

GITANSH CONSTRUCTION CO.