RM of WSS Kanam in GP Kanam under JSV SubDivision Pooh in Distt Kinnaur

Amount

Excavation in foundation trenches in all kinds of soils such as pick work, jumper work blasting hard or soft rock chiseling where blasting is prohibited slushy daldal or saturated soil within all leads and lifts , stacking the excavated soil not more than 3 mtrs clear from the edge of excavation and then returning the stacked soil in 15 cm layers when required into plinth and sides of foundations i/c consolidating each deposited layer by ramming and watering and then disposing of all surplus excavated earth within all leads and lifts as per the direction of the Engineer- in-charge

P/L cement concrete 1:4:8 (1 cement :4 sand : 8 graded stone agg. 40mm nominal size) and curring complete excluding the cost of form work in foundation & plinth within all leads and lifts.

50mm thick cement concrete flooring 1:2:4 (1 cement: 2 sand: 4 graded stone aggregate 20mm nominal size) laid in one layer finished with a floating coat of neat cement with in all leads and lifts.

Random rubble masonry/polygonal rubble masonry ( Uncoursed/brought to courses) with hard stone of approved quality in foundation and plinth including levelling up ) in cement mortar 1:6 (1 cement : 6 sand) in breast wall and retaining wall with in all leads and lifts.

20mm cement plaster in single coat on rough side of brick/stone masonry for interior plastering upto floor two level including arrises, internal rounded angles, chamfers, and /or rounded angles not exceeding 80mm in girth and finished even and smooth with in Cm. 1:6 with in all leads and lifts.

Wire crates of interlink chain fence filled with boulders with square cut faces against the interlink (Boulder filling to be measured and paid for separately) Interlink chain fence 4 mm thick corresponding to SWG-6. 15cm*15cm mesh.

wire crates of G.I Wire filled with boulders with squre cut faces aginst the wire (wire crates to be measured and paid separately)

Providing,Laying, jointing and commissioning of HDPE (High Density Polyethylene pipes) of following diameter and class confirming to IS 4984-1995 with fusion welding process including all fittings Tees, reducers & bends in all leads and lifts to the entire satisfaction of Engineer-in-charge. PE-63, PN-4.0 ( 40 mm dia)

Providing,Laying, jointing and commissioning of HDPE (High Density Polyethylene pipes) of following diameter and class confirming to IS 4984-1995 with fusion welding process including all fittings Tees, reducers & bends in all leads and lifts to the entire satisfaction of Engineer-in-charge. PE-63,PN-4.0( 90 mm dia)

Dismanteling /Relaying of old GMS pipes in existing distribution lines where changing is required of following diameters including stacking of material at site in all leads and lifts and as per the direction of the Engineer - in- Charge.-( 80 mm dia MG)

GOPAL KRISHAN (BID ID -516211)

DEV SINGH (BID ID -516605)