LIS HL from Marathu Khad to Tharola Part 1 and Part 2 and Anti Kahd to Barthata and LIS to HL of various panchayats of Jubbal Rohru and Kotkhai in Tehsil Jubbal Distt Shimla SH L J T of GI Pipes of various dia 2815 Rmt and repair of storage tanks etc

Amount

Excavation in foundations , trenches etc., in earth work , lift up to 1.50 metres. Stacking the eacavated soil not more than 3 metres clear from the edge of the excavation and then returning the stacked soil in 15 cm. (fifteen centimetres) layers , when required in to plinth and sides of foundations etc., conslolidating each of the disposited layer by ramming and watering and then disposing off all excavated soil as directed with in the load of 20 mtrs. Pick and Jumper work etc. complete as per the direction of the Engineer - in - Charge.

Laying and jointing of G.M.S tubes (Light Class) in trenches including refilling & testing etc. complete (earth work to be measured and pais separately)

65 mm dia.

50 mm dia.

40 mm dia.

32 mm dia.

25 mm dia.

Providing and laying cement concrete 1:1:2 (1cement :1Sand: 2 graded stone aggregate 20 mm N/S) and curing complete excluding cost of form work and reinforcement for Rainforced concrete work in:- Foundation and plinth within all lead and lifts as directed by the Engineer-in-Charge.

Chipping of RCC/Stone masonary walls/ plastering.

Providing and fixing of MS wire mesh on RCC/ stone masonary wall.

20 mm thick cement plaster on rough sides of brick/stone masonery convrete walls for interior plastering upto floor two level including arises internal rounded angles not exceeding 80mm girth in cm 1:3 (1cement:3sand)

Steel work in single sections including cutting, hoisting, fixing in position and applying a priming coat of red lead paint in R.S. Joists,channels, angles, tees etc. with in all leads and lifts as directed by the Engineer Incharge

Supplying and fixing wovenplains G.I. wire (3mm2) fencing of mesh 50mm to 150mm to any type of standard rails, strainging bolts. etc. including provision of binding wire, staples etc. with in all leads and lifts as per the direction of the Engineer-in-charge.

Fabcriting/Making outlet/distribution junction i/e all required fitting/fixing per drawing i/e reducer, wheel valve, nipples, plug, socket, union etc all are generally 32mm to 25mm dia and welding wherever required and fixing the same at site of tank for future released/ distribution connection of water to the farmers, complete in all respects with in all leads and lifts and entire setisfection of Engineer-in-Charge.

M/s Pardeep Sublaik