RENOVATION WORK WITH GENERAL REPAIRS ON THE FBANK ROAD FROM CHAINAGE 59.00 TO 60.00 70.00 TO 79.00 AND 80.00 TO 86.700

Providing and laying dense graded bituminous macadam with higher capacity batch type HMP using crushed aggregates of specified grading, premixed with bituminous binder @4.5 Percent by weight of total mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the required grade, level and alignment, rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per MoRTH specification clause No. 505 complete in all respects.

Providing and applying tack coat with bitumen VG-10 bitumen pressure distributor at the rate of 0.20 kg per sum on the prepared bituminous surface cleaned with mechanical broom. As per MORT&H Clause 503

Providing and laying bituminous concreate with batch type 120 TPH hot mix plant producing an average outpur of 75 tonne per hour using crushed aggregates of specified grading, premixed with bituminous binder @ 5.4 percent of mix and filler transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the required grade, level and alignment, rolling with smooth wheeled vibratory and tandem rollers to achieve the desired compaction as Morth Specification clause 507(B) complete in all respects.

Construction of embankment with approved material obtained from borrow pits with all lifts and leads, transporting to site, spreading, grading to required slope and compacting to meet requirement of table 300-2.

Providing and laying of hot applied thermoplastic compound 2.5 mm thick including reflectorising glass beads @ 250gms per sqm area, thickness of 2.5 mm is exclusive of surface applied glass beads as per IRC:35 the finished surface to the level uniform and free streaks and holes.

Thermoplastic Marking of 300 mm wide and 15 mm height at 1000 mm apart (One set is of 6 strips) 5 mm height is achieve through two applications of thermoplastic, applied at an interval not less than 1 hour after the previous layer gets solidified 9Repeted Bars) MORTH-803(1.130)-Base