JJM 2020-2021- Bodinayakkanr Block - Package No. JJM/BOD-33

Amount

Costruction of 1.00 laks Litre Sump

Earthwork excavation in hard stiff clay,black cotton, hard red earth, shales,murrams, ordinary gravel stoney earthmixed with 50% fair sized boulders etc.,with an initial lead of 10m and lift of 2m. and as directed

For HSC HRE

For SDR

For DMR not requiring blastering

Cement concrete 1:4:8 (one cement,four sand and eight aggregate) using 40mm hard broken stone for foundation and leveling coarse including cost of all materials, mixing,placing, ramming, curing, finishing etc., complete and as directed by Departmental Officers.

Reinforced Cement Concrete with M30 Design Mix for the following members excluding the cost of reinforcement and fabricating, centering, shuttering and strutting charges but including the cost of all materials, mixing, placing in position, lifting, vibrating, finishing & curing, etc. complete.and as directed .

Beyond 1.50 m & upto 4.50 m below GL

Up to1.50 m below GL

Up to 4.50 m above GL

Supplying and erecting centering for sides Centering for soffits of RCC slabs of plane surface like lintels, beams ,etc.,including strutting 3m high using mild steel sheets of size 90cm X 60cm X and B.G 10 stiffened with M.S angles of size 25mm X 25mm X

For 0.00 to 3.30 M (Plane Surface)

For 0.00 to 3.30 M (Curved Surface)

For 0.00 to 3.30 M (FOR ROUND COLUMN)

For 3.30 M- 4.3 M (Plane Surface)

For 3.30 M TO 4.30M (Curved Surface)

Supplying fabricating and placing in position of ribbed steel rods for reinforcement to all RCC works as per the design given including cost of steel and binding wire also in all floors etc., complete

Providing and fixing of cut stone (Roughdressed) set in CM 1:3 of size 0.45 X0.45 X 0.15M at site including cost of all materials, labour charges, curing etc., complete and as directed etc., complete

Providing RCC Ventilator of 0.15 m dia using 20mm HBG stone including cost of all materials, centering, shuttering, stutting, reinforcement, placing of concrete, finishing, curing, and fixing in position on the roof slab with mosquito proof net arrangement and etc., complete and as directed

Supply, delivery and fixing of CI manhole frame with cover of following size including cost of all materials , fixing of MS clamps, bolt, and nuts etc., complete and as directed

Painting two coats with ready mixed Exterior Emulsion paint of approved qualityand colour over a priming coat, including through scrapping,clean removel of dirt etc complete .

Supplying and fixing in position of RCC in side access ladder of following size using 20mm size HBS jelly including cost of all materials, centering, shuttering, strutting, fabrication and placing in position of reinforcement,finishing, curing etc., complete and as directed

Provision for supply and fixing of MS Ladder including painting etc., complete

Pipe line

Supply and cost of 75mm dia 6KSC PVC pipe with ISI mark etc complete

Labour for cutting Concrete Roads for laying water mains or sewer.including all cost etc..,

Cement concrete 1:4:8 mix using 40mm ISS metal including cost and conveyance of all materials to site and all labour charges for mixing, laying and curing etc complete for 10 cum.

Cement concrete 1:2:4 mix using 20mm ISS metal including cost and conveyance of all materials to site and all labour charges for mixing, laying and curing etc complete for bed blocks for 10 cum

Earth work excavation for in all clauses of soils and sub soils to full depth as may be directed except in hard rock requiring blasting but inclusive of shoring strutting and boiling out water whenever necessary etc complete complying with standard specification. SS20B

Laying and jointig of 75mm dia 6ksc PVC Pipe and G.I pipe into the trench with proper grading and alignment and all labour charges etc,,complete

Refilling the Pipe line trench with excavated earth other than sand complying the Standard specification etc,,complete

Supply and delivery and fixing charges of Woltman model with removal mechanism Water meters with filters and with confirming to ISO 4064 Part I,II,III class B specification, production box of size 20cm x 30cm for fixing of water meter, the box should be rectangular base the rate including required fittings for fixing and with all tools & tackles etc., complete

FHTC Connection

Providing suitable dia non corrosive engineering plastic moulded Clamp Saddle with SS 304 threaded metal inserted for tapping outlet suiting for ½”, 3/4” &1” clear bore and with wide plastic strap (Engineering Plastic) with SS 304 suitable bolts & nuts. Saddle to have sealing of Thermo plastic elastomeric (TPE) material around. 20mm (1/2”)

Supply, delivery and fixing of stainless steel flow control valve having stainless steel 202 Grade body and stainless steel ball in 304 Grade . The average flow rate of each model from 3 m to 12 m inlet pressure head to be tested and supplied with FCRI, Palakad and test certificate shall be furnished. The flow control valve shall have external threading and including packing, forwarding and transportation and as directed by the TWAD Board Officers. - 15mm size flow control valve with an average flow rate of 5-10 lpm.

Poly Propylene compression Female Threaded Adaptor with metal insert of SS 304 as per standards ISO 14236 and Tested as per BS 6920 in WRC-NSF LTD, UK for connecting 15mm, 20mm and 25mm outlet points of Brass ferrule of sizes 15mm, 20mm and 25mm respectively. (As Per Table 7.0 of TWAD SR 2017-18 For HSC items) - 20mm (1/2”)

MDPE PE 80 PN16 Blue pipe as per standards ISO 4427 and Tested as per BS 6920 in WRCNSF LTD, UK. (As Per Table 7.0 of TWAD SR 2017-18 For HSC items) - 20mm (1/2”)

Poly Propylene compression Male Threaded Adaptor with metal insert of SS 304 as per standards ISO 14236 and Tested as per BS 6920 in WRC-NSF LTD, UK suitable for 20mm, 25mm and 32mm OD MDPE pipes. (As Per Table 7.0 of TWAD SR 2017-18 For HSC items) - 20mm (1/2”)

Poly propylene 90 Degree Compression elbow with compression joint at both ends as per standards ISO 14236 and Tested as per BS 6920 in WRCNSF LTD, UK suitable for 20mm, 25mm and 32mm OD MDPE pipes. 20mm (1/2”)

Supply and delivery of U PVC ball valve with one side compression end and other side female end as per ISO 4422-4 and Tested as per BS 6920 in WRC-NSF LTD, UK,size : 20mmx1/2" suitable for 20mm OD MDPE pipes.

Earth work excavation Sand, silt or other loose soil, wet sand or silt not under water light black cotton soil, sandyand depositing on bank with initial lead of 10 m and lift of 2 M in narrow trenches for laying of pipes for water supply in the following type of soils as directed by Departmental officers (As per Revised data 2017-18)

Lowering, laying and jointing of MDPE pipes upto 40mm Dia etc., complete

Refilling the basement with excavated Soil (other than sand) in layers of not more than 15cm thick, watering, well ramming, consolidating, complying with standard specification

Labour Charges of House Hold Connection including All Charges

Construction of 1,00,000 Ltr OHT

Earth work excavation and depositing on bank with initial lead 10m and lift of 2.0m in the following classification of soils, bailing out water whereever neceessary including providing danger lights etc and as directed by TWAD Board officers as per spec

Hard stiff clay, stiff block cotton, hard red earth, shales, murrams, gravely stoney earth mixed with 50% small sized boulders and hard gravelly soil

I st Depth of 2.0m

2nd depth of 1.0m

Sand filling for foundation with river sand including consolidation ramming etc,.

Cement concrete 1:4:8 (one cement, four sand, and eight course aggregate of 40mm size hard blue granite broken stone ) for levelling course including the cost of mixing, placing the concrete in position, consolidating finishing and curing etc, complete Beyond 1.5 m below GL

RCC 1:1.5:3 concrete using 10 mm and 20 mm HBG sstone excluding steel, centering,chargesbut including mixing and curing etc complete.

Below 1.50m to 4.50m depth from G.L

Below G.L upto 1.50m depth

Above G.L upto 4.50 ht

Column 4.50m to 7.32m ht above G.L

column 7.32m to 10.98m ht above G.L

column 10.98m to 14.64m ht above G.L

column 14.64m to 18.63m ht above G.L

Centering for soffits of reinforced cement concrete slabs or plain surface including strutting upto 3m ht, using M.S sheet of size 90cm x 60cm and BG. 10 gauge stiffened with welded M.S angles of size 25mm x 2mm x 3mm laid over silver oak (country wood)

Plane surface

From G.l upto 3.3m ht

From 3.3m to 4.3m ht

From7.30m to 8.30m ht

From 11.30m to 12.30m ht

Curved Surfaces

Upto 3.30m ht from Floor Level

From 11.30m to 12.30m ht from floor level

Square column

Upto 3.30m ht

From 3.30m to 4.30m ht

From 4.30m to 5.30m ht

From 5.30m to 6.30m ht

From 6.30m to 7.30m ht

From 7.30m to 8.30m ht

From 8.30m to 9.30m ht

From 9.30m to10.30m ht

From10.30m to 11.30m ht

From 11.30m to 12.30m ht

Circular Column

Upto 3.30m ht

From 3.30m to 4.30m ht

From 4.30m to 5.30m ht

From 5.30m to 6.30m ht

From 6.30m to 7.30m ht

From 7.30m to 8.30m ht

From 8.30m to 9.30m ht

From 9.30m to10.30m ht

From10.30m to 11.30m ht

From 11.30m to 12.30m ht

Painting two coats with approved cement paint best quality over the outer wall surface including cost of Plastic Emulsion paint etc. complete complying with standard specification as directed byTWAD Board officers..

Supplying, fabricating and placing in position of RTS grills for reinforcement for various members including cost of steel for all RCC works as directed by TWAD Board officers. The rate to include the cost of binding wire also.

Upto 16 mm RTS rod

Above 16 mm RTS rod

Fabrication, supply, delivery and fixing of outside MS Ladder of 45cm clear wide made out of 50 mm x 50mm x 6mm MS angle for both sides and for steps at 30cm C/C welded jointed etc ., for I staging from GL to 1st level brace (weight 4.5kg/m) IInd and IIIrd staging upto floor slab and IVth staging from floor slab to roof top. Supply,delivery and fixing of 32 mm GI pipes medium for hand rails from I stage to IVth stage. RCC M30 Grade mix for Landing slab 5 nos. at Ground Level- 1No. and above Ground Level - 4Nos. supply and fixing of 32mm GI pipe medium for hand rails for the Landing slab. Supplying and fixing of MS Base plate of 100mm X 100mm X 6mm thick for fixing Anchore astener bolt for fixing of hand rails at Landing slab and MS Ladder providing locking arrangements with two coats of approved enamel paint over one coat of red oxide paint as per approved Type Design and as directed by TWAD board officers.

Providing RCC jolly works as hand rails at top of roof slab about 0.60m ht vide Separate Estimate

Supply and fixing in position of enamelled water level indicator with all accessories of approved pattern and design as directed by TWAD Board officers.

Supplying and fixing in position of 0.60 x 0.60 m water tight CI manhole frame and cover of approved pattern at the roof slab and as directed byTWAD Board officers. The manhole frame and cover should be of light duty and confirming to I.S. 1726 /1974

Cut stone set in C:M 1:3 ( one cement and three sand ) using well dressed cut stone supporting inlet pipe of size 0.30 x 0.30 x o.15m for service reservoir as directed by TWAD Board officers.

Providing and fixing of RCC 1:2:4 ( one cement, two sand and four course aggregate of 20mm size hard blue granite broken stone ) for ventilators of approved pattern including cost of cement, reinforce ment, centering, shuttering, strutting etc, complete a

Supplying and fixing in position of RCC 1:1.5:3 of 20mm size HBG inside access ladder of approved design and pattern inside tank including cost of cement,reinforcement,centering ,shuttering ,strutting etc., complete as generally shown in the plan and as d

GST Amount for providing Service to Government Contract Works for the above Construction Works. { GST Amount is the Total GST Amount for total overall quoted amount above this row in column "BB" for all works in this package}

KMC Associates, Theni