Providing 2 Nos of Deep borewell with Submerssible Motor Arrangements and Main Pipe line at Indra Nagar South side ward No.27 in Thirunindravur Municipality

Upto 60 mt. Depth ending below ground level

Reaming 200 mm dia pilot bore to 350mm dia bore as directed by the Departmental Officer

Upto 60 mt. Depth ending below ground level

Supply of the following casing pipes of ISI approved quality with wall thickness not less than 7.5mm to 8.5mm with PVC couplers and cement Paste etc. Complete and including packing the annular space with pebbles quality and size of pebbles and the PVC pipe should be approved by the departmental officer.

200mm dia OD PVC Plain casing Pipe (CM)

200mm dia OD PVC slot casing Pipe (RS)

200mm dia OD PVC end cap

Labour Charges for inserting PVC Casing pipes assembly (with slots or without slots) in the drilled hole including jointing the pipes with PVC Couplers with Cement paste etc., complete supply and packing the annular space with pebbles of size and quality as approved by the executive engineers

Charges for developing the borewell with air compressor of 600 cfm capacity (Minimum 8 Hours) including transportation labour and fuel charges for compressor as directed by TWAD Board officers and conducting yield test by 'V' notch method.

supply and delivery of 7.50 HP Three phase Submersible pumpset of duty condition 250lpm x 125m as per IS 8034 without panel board etc complete as per standard specification.

Supply of Three phase Pannel board suitable for 7.50 HP with two level guard and auto start etc complete as per standard specification.

Supply and delivery of Flat cable suitable for submersible pumpset 6sq.mm

Labour charges for the errection of 7.50 HP submersible pumpset in the Borewell including fixing and jointing submersible cable with proper clamps upto the starter to required depth and also fixing of riser pipes to the required depth walls errection clamps pressure gauges up to the exterior wall of pumping room and errection of panel board consisting of DPICN switches starter volt meter ammeter, Three Pilot ( Indicating ) lamps capacitor single phasing preventer water level guard and laying and jointing the cable s and twin earthing as per IE rules etc complete and testing to the pumpset and trial run for 10 Days.

Supplying and fixing of pipe and accessories ISI make including cutting and threading cost and conveyance of all charges etc complete as per standard specification.

UPVC 80mm pipe PWD Schedule of rates

Supply and fixing of TNEB meter board suitable for 32A three phase service connection with 3Nos.32A fuse unit(500V)32A neutrallink and earth link(1"x1/8"copperflat) onTWplank of size 600mmx450mmx19mm with supporting TWreepers of 1"thick an either side with painting with suitable bolt and nuts for fixing the TWplank on wall with earth connection and interconnection with7/20PVC insulated copper wire from EBmeter to fuse unit (SD 127)

Earth work excavation in all classes of soils such as hard stiff clay, stiff black cotton, hard red earth, shales, murram, ordinary earth, earth mix with 50% fair sized boulders etc., with initial lead and lifts including laying, spreading, leveling, sect

Column

Plinth Beam

Supply delivery and filling of M.Sand in layer of not more than 15 cm thick including watering with all layers and consolidation complying with standard specification including cost and conveyence of sand to Site and all labour charges and all other incidential charges etc,. complete as per Standard Specification TNDSS NO. 24 &25 NBC Part VI (S2) 8

Plain Cement concrete of mix 1:4:8 (One cement four M-sand and eight aggregates) using 40mm gauge hard broken including cost conveyance of all materials to site including labour charges, transporting and placing in position including shoring, strutting

Supplying & Erecting centering for sides & soffiots including necessary supports & strutting upto 3.29m height for plane surfaces in all floors with all cross bracings using mild steel sheets of size 90 x 60cm & 10 gauge stiffened, welded with steel

For Column

For Plinth Beam

For Slab

Providing and laying in position, Standardised Concrete Mix M-20 Grade in accordance with IS:456-2000, using 20mm and down graded hard broken granite stone jelly for all RCC items of works with minimum cement content of 325 kg/mᶾ and maximum water cement ratio of 0.55, including admixture (plasticiser / super plasticiser) in recommended proportions as per IS:9103 to accelerate, retard setting of concrete, improve workability without impairing strength and durability with about (5 cu.m.) 7730 kg. of 20mm machine crushed stone jelly and with about (3.3 cu.m.) 5156 kg. of 10-12mm machine crushed stone jelly and with about (4.79 cu.m.) 7670 kg. of sand, but excluding cost of reinforcement grill and fabricating charges, centering and shuttering and also including laying, vibrating with mechanical vibrators, finishing, curing, etc. and providing fixtures like fan clamps in the RCC floor/ roof slabs wherever necessary without claiming extra, etc., complete complying with standard specification and as directed by the departmental officers. The coarse and fine aggregates to be used should comply with the requirements of IS Standards.

Supplying and Fabrication of Steel and placing in position TMT rod Grills for RCC works as per design given including cost of steel and GI binding wire in Floors etc,. Complete complying with standard specification in force and as directed by department

Brick Work in CM 1:5 (One part of cement & five parts of M - sand) mix using Third Class Country Brick Kiln Burnt bricks 8 ¾ " x 4 ¼ " x 2 ¾" including cost and conveyance of materials to work site and including all labour charges for mixing, laying, cur

Plastering with CM 1:5 (One part of cement & five parts of sand) mix for 12mm thick including cost and conveyance of all materials to work site and including all labour charges for mixing, laying, curing,finishing etc., complete as per standard specific

Special Ceiling Plastering with CM 1:3 (One part of cement & three parts of sand)mix for 10mm thick including cost and conveyance of materials to work site and including all labour charges for mixing, laying, curing,finishing etc., complete as per standar

Supplying and painting the walls with two coats of cement paint over one coat of cement primer as instructed by the departmental officers including preparation of surface curing, etc., complete in all floors complying with standard specifications (The colour and shade of the cement paint shall be got approved by the Executive Engineer before use of work).

Wiring with 2 x 1.5 sqmm (22/0.3) PVC insulated unshealhed SC.Cu. conductor of 1100V grade in suitable PVC rigid Pipe on wall and ceiling with PVC accessories with TW switch box with 5A F.T. switch inflush with wall, covered with hylum sheet of 3mm t

Supply and fixing of single box type 4feet 18 Crystal Glass LED Tube Light Fitting complete with electronic ballast with TW round blocks on wall or ceiling with led tube with PVC unsheathed Copper leads from terminals to the fitting.

Suppy and fixing of MS door & window incluidng all other material and labour charges etc., complete

Earth work excavation in all types of strata for laying of pipes with the stanard trench width as per Board circular No.28/AE10/P&D /2001/dt 1.10.2001 & JCE (P&D) Lr.No.LM/AE 10/P&D/2001/Dt.22.11.2001

140mm dia

Supply of unplasticised PVC rigid pipes as per BIS 4985-1988 including of all charges etc complete as per standard specification.

140mm PVC 6Ksc pipes

Supply of PVC Specials as per BIS 10124 - 1988 part 1 to 13 including of all charges etc complete as per standard specification.

90mm PVC equal tee

90mm PVC elbow

90mm PVC end cap

90mm PVC Coupler

Conveying the PVC pipes and specials to trench, lowering into the trenches, laying to proper grade and alignment, jointing with PVC coupler and specials fixing with neat cement paste and testing to the required pressure as per IS including conveyance of water from 1Km lead for filling during testing. 90mm dia

90mm dia

Refilling with excavated soil complying with standard specification in layers of 15cm thick well rammed and consolidated after the pipes and specials are laid and tested

90mm dia