Installation of Solar Power...

Amount

NS Item -Providing and fixing 12 Watt LED Street Lighting of 75 watt solar panel, 12.8 volt 30 Ah Lithium Ferro Phosphatebattery, 12 Watt White LED Luminaire and Pole of 5 Meter above ground level with dusk todawn operation {first 4 hoursfull light Systemding, fixing and testing of Solar light including battery: min. 24 lux) , rest ofthe time at lower light (50% Min.12 lux) level} and 3 days or minimum 36 operating hours autonomy or as per direction ofengineer-in-charge

NS Item -Hydrant assembly for Nakka in fields, Rates are including rates of Tee, riser pipe, butterfly valve, Flange and labour for fixing butter fly valve should be as per IS 13095- 2020

NS Item -Providing and fixing of three phase motor, frequency 415V ± 3% rated motor voltage, with constant motor flux control, (Submersible motors shall conform to all the requirements of IS 9283) Solar A.C. Agricultural Pumps alongwith Universal Solar Pump Controller (USPC) all external part of motor used in open well submersible pump having casing of Alloy steel confirming to IS 3444 including all PVC insulated polymer sheathed 3 core flat type cabling in conduit, required from solar plant to solar pump through control room required to connect, including cost of and as per IS code 14220-2018 including third party inspection. Duly installed on the suitable foundation. Actual pump set`s parameters will be finalized after approval of design and drawing. Solar Pumping Sets should be of the make: KSB / Shakti/ Kirloskar /CRI/Lubi/ Crompton/ WPIL, Quantities are total sum of various pumps capacity in HP may vary as per design requirement for site.

NS Item -Providing and fixing Tank Type (Make of Metal) Fertilizer and Chemical Injector System confirming to IS 14483 (Part 3) of 2018 for demonstration and guiding the farmers regarding fertilization and chemicalisation of system. (rates include ventury with manifold 1.0`=1300 and 60 liter fertilizer tank= 4400 ) rate approved by whorthy Administrator

NS Item -Providing fixing of Header Assembly/Manifold 3` (loose) Rates approved vide memo No.MICADA/2021/3068-70 dated 07.06.2021

NS Item -Providing, fixing,testing and commissioning of pressure gauge 2` dial with Glycerin filled to be fixed before and after filtration unit ( Rates approved in TAC,MICADA Haryana meeting on 09.02.2022)

S Item -Providing and lowering of HDPE floater manufactured with 225 mm dia PE pipe having PE-80 and PN-10 to float the submersible open well pump/motor

NS Item -Supply Installation testing commissioning of Solar Photovoltaic Stand alone Plant conforming to MNRE cations as amended, consisting of Mono Crystalline silicon solar cells, necessary protections, earthing, mounted on Aluminum/GI structure of suitable strength. Including lightning and surge voltage protection, Fixing of Array junction box and Main junction box with IP 65 protection and termination arrangement for incoming and outgoing cable along with glands, lugs and other accessories etc. as required, built in metering system to monitor plant performance (Amp-meter, Volt-meter, Frequency meter, Energy meter, Watt-meter, and other instrument/equipment as required) Note:- PV modules used must qualify to the latest edition of IEC PV module qualification test or equivalent BIS standards Mono Crystalline Silicon Solar Cell Modules IEC 61215/IS14286. In addition, the modules must conform to IEC 61730 Part-1- requirements for construction and Part 2 – requirements for testing, for safety qualification or equivalent IS and be mounted on fixed Aluminum/GI structure of adequate strength and design as per IEC/IS specification. Including field-based electroluminescence (EL) study be performed after receiving the modules at site and after installation. Module mounting structure (MMS) design and drawing shall be duly vetted from government institute Including third party inspection Actual meters/capacity willbe finalized after approval of design and drawing.

NS Item -Galvanizes steel chain link both end twisted fence fabric having opening size 7.5x7.5 cm and 3.15 mm dia wire, 2.2 meter height of mesh,with 2.8 meter ht of MS Angle50x50x5 mm supports fixing at spacing of 3 meter centre to centre, supports with MS Flat35x5 mm. Fencing supportedwith MS Angle 35x35x5 at top and bottom. The M.S Angle supports shall be anchored in cement concrete (1:3:6) blocks 45x45x60 cm additional razor barbed wire fencing shall beprovided at the top of mesh, fencing including gate.

NS Item -Horizontal directional drilling with micro tunneling methods, for pipe laying under pucca rasta/road crossing

NS Item -Supply and jointing of 110mm 6Kg/Cm2 HDPE pipe (For jointing floater, all filters, PRV etc

Providing, laying, aligning, and jointing with uPVC heavy body solvent at all level/ depths ISI marked PVC pipe of pressure as per design for raw water supply as per IS 4985 (amended up to date) in trenches in complete, including cost of all Specials, labour, and commissioning as per Technical Specifications and approved make as per direction of Engineer. (Make Duraline,Reliance, jain Irrigation, Nimbus, Finolex, Hasti, or equivalent) (Rate analysed with rate approved by worthy Administrator) PVC 4 Kg/Cm2, 90 mm dia Pipe

Bidder Name

Amount

THE RAMGARH PANDWAN COOP L/C SOCIETY LTD(GSTN-NA)

The Tirupati Co-Op L/C Society Ltd(GSTN-NA)

The Tirupati Co-Op L/C Society Ltd

The Tirupati Co-Op L/C Society Ltd