Procurement of The LAN extender should support data rate as given in the specification on a single twisted pair & double twisted pair 0.5 mm or higher dia.. i.e. LAN extender should support 2W and 4 W etc.

Special Eligibility Criteria

1. 1

   The Railways reserves the right to order entire or bulk quantity from firms having satisfactory past performance for same or similar items as per clause no. 16.4 of General Tender Conditions (Section- 2) of Eastern Railway, available in IREPS website.

   Document optionalConfirmation required
2. 2

   In terms of Railway Board letter no. 2015/RS(G)/779/5(Vol.III) dated 22.06.2020 and in keeping with the Public Procurement (Preference to Make in India) Order 2017 as amended time to time, it has been found that there is sufficient local capacity and competition in supply of the tendered item of required quality and therefore, public procurement of this tendered item is restricted to Class-I local suppliers only (Class-I local supplier means a supplier having local content equal to or more than 50%).The vendors who do not qualify to be Class-I local suppliers should not quote in the tender as their offers shall not be considered for any ordering. In case any vendor who does not qualify to be a Class-I local supplier for the tendered item, participates in the tender, it does so at its own risk and cost and Railway shall not be liable for any loss or damage caused to the vendors.

   Confirmation required
3. 3

   Keeping in view with the Public Procurement (Preference to Make in India) order 2017 as amended time to time , this tendered item is restricted to be procured from Class 1 Local Supplier and Class-II Local Supplier only (Class-1 Local Supplier means a supplier quoting local content equal to or more than 50% and Class-II Local Supplier means a Supplier quoting local content equal to 20% or more but less than 50%). Procurement will not be made from Non-Local Supplier having local content less than 20%.

   Confirmation required
4. 4

   Bidders may please note that, DPIIT vide their OM No. P-45021/102/2019- BE-I1-Part(1)E-503 10) dated 04-03- 2021 has clarified following: It is clarified that the bidders offering imported products will fall under the category of Non-local suppliers. They cannot claim themselves as Class-I local suppliers/Class-II local suppliers by claiming the services such as transportation, insurance, installation, commissioning, training and after sales service support like AMC/CMC etc. as local value addition

   Confirmation required
5. 5

   NOTE: Eligibility Criteria: Bidder should upload Clause-wise compliance of given RDSO s Specification along with offer. This may be incorporated along with Special Eligibility Criteria

   Confirmation required

Check List

1. 1

   The bidder should go through the Tender Documents consisting of Instructions to Tenders, General Tender Conditions and Special Conditions of Tender, and agree and confirm to abide by the Instructions to Tenders, General Tender Conditions, IRS Conditions of Contract and Special Conditions of Tender.
2. 2

   The bidder agrees to supply the tendered stores at the rates quoted by him in accordance with the IRS Conditions of Contract and [or] special Conditions and [or] other Conditions specified/attached with the tender.
3. 3

   The offer must be kept valid for 120 days.
4. 4

   The bidder must agree to the guarantee/warranty as per specification, and, in case specification does not contain GC/WC, the bidder must agree GC/WC as per IRS conditions of contract.
5. 5

   The bidder have you gone through the clause No. 8.0 for deposition of Earnest Money and 9.0 for Security Deposit (SD) as indicated in Instruction to Tenderer for E-Tender of current General Tender Conditions of ER uploaded in IREPS website.
6. 6

   The bidder have uploaded the Performance Statement supported by copies by Purchase Orders, Receipt Notes, and Inspection Certificate as the case may be

Commercial-Compliance

1. 1

   Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.

   Document optionalConfirmation required
2. 2

   Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.

   Document optional

1. 1

   Firm will have to submit quotation with a validity for a minimum period of 90 [ninety] days otherwise their offer will be summarily rejected.