Construction of Science Lab, Art Craft Room and Library Room at Govt. Higher Secondary School Damnote, Zone Panchari, District Udhampur

Amount

Earth work in excavation by manual means over areas (Exceeding 30 em and upto 1.5 mtr in depth , 1.5 mtr in width as well as 10 sqm on plan) including disposal of excavated earth upto 1 mtr from cutting edge , disposed earth to be levelled and neatly dressed in All kinds of soils (including all carriages lead and lift if any)

Earth work in excavation by manual means in trenches for foundations, drains, pipes, cables etc. (Not exceeding 1.5 mtr in width) and for shafts, wells, cesspits and the like not exceeding 10 sqm on plan, depth upto 1.5mtr. including disposal of excavated earth upto 1 mtr from cutting edge, disposed earth is to be levelled and neatly dressed in: 80%. All kinds of soils and 20% ordinary rock (including all carriages lead and lift if any)

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering , all works upto plinth level ( 1 : 5 : 10) 1 cement 5 coasre sand 10 stone aggregate grade, with 40mm nominal size . crushed (including all carriages lead and lift if any)

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering , all works upto plinth level ( 1 : 3 : 6)1 cement 3 coasre sand 6 stone aggregate grade , with 20mm nominal size . crushed with 20% boulders. (including all carriages lead and lift if any)

Providing and laying in position reinforeced cement concrete of specified grade excluding the cost of centering and shuttering , all works upto plinth level ( 1 : 1.5 : 3)1 cement 1.5 coasre sand 3 stone aggregate grade , with 20mm nominal size . crushed (including all carriages lead and lift if any)

Reinforced cement concrete work in wall (any thickness) including attached pilasters 'buttresses'plinth and string courses'fillet ,column pillar'piers ,abutment 'post and sturts etc upto floor five level excluding the cost of centering and shuttering ,finishing and reinforement ( 1 : 1.5 : 3 )1 cement 1.5 coasre sand 3 stone aggregate grade , with 20mm nominal size . crushed (including all carriages lead and lift if any)

Brick work with common burnt clay F.P.S (Non-modular) brick of class designation 75 in foundation and plinth in 1:6 (1 cement : 6 coarse sand) (including all carriages lead and lift if any)

Extra for brick work in Super structure above plinth level upto floor V level (By manual means) (including all carriages lead and lift if any)

Reinforcement of RCC work in Plinth band incl straightening, cutting, bending, placing in position and binding all complete. (including all carriages lead and lift if any)

Centering and shittering including strutting propping etc and removal of form work Foundation footing bases of columns etc (including all carriages lead and lift if any)

Centering and shuttering incl. struting, proping ,etc.and removal of form work for; lintel beam ,plinth beam ,girders,bressumers and cantilevers (including all carriages lead and lift if any)

Centering and shuttering incl. struting, proping ,etc.and removal of form work for;columns ,pillars,piers,abutments,posts and struts (including all carriages lead and lift if any)

15 mm cement plaster on the rough side of single or half brick wall of mix 1:6 ( 1 cement : 6 fine sand ) (including all carriages lead and lift if any)

12 mm cement plaster on wall of mix 1:6( 1 cement 6 fine sand ) (including all carriages lead and lift if any)

Providing wood work in frames of doors, windows, clerestory windows and other frames, wrought framed and fixed in position with hold fast lugs or with dash fasteners of required dia and length (hold fast lugs or with dash asteners shall be paid for separately): 2 nd class Kail wood (including all carriages lead and lift if any)

Providing and fixing paneled or glazed shutters for doors and windows and clestory windows using 10 kg /sqm (4mm thick) float glass panes including ISI marked black enameled M.S. butt hinges bright finished of requried size with necessary screws, (35mm thick of 2nd class kail wood). (including all carriages lead and lift if any)

Providing and fixing fly M S wire steel grade 304 wire gauge,to windows and clerestory windows using wire gauge with average width of aperture 1.4mm in both direction with wire of dia 0.50 mm all complete with 2nd class Teak wood beading 62x19 mm (including all carriages lead and lift if any)

Providing and fixing panelled or panelled and glazed shutters for doors, windows and clerestory windows including lSI marked M.S. pressed Butt hinges bright finished of required size with necessary screws excluding panelling which will be paid for separately,al! complete as per direction of engineer- in charge. Second class kail wood (including all carriages lead and lift if any)

Providing and providing panelling or panelling anf glazing in panelled and glazed shutter for door .window (area of opening for panel insert ecluding portion inside grooves or rebates to be measured ) panelling for panelled or panelled and glazed shutters 25to 40 mm thick ply wood 9 mm thick/ plain particle board flat pressed 3 layer or graded wood particle board medium density grade (including all carriages lead and lift if any)

Cement Concrete Flooring in (1:2:4) 1 cement : 2 coarse Sand : 4 stone aggregate finsihing with a floating coat of neat cement including cement slurry but exd. The cost of nosing of step etc. complete 50 mm thick with 20mm nominal size stone aggregates (Crushed) (including all carriages lead and lift if any)

Providing fixing and glass strips in joints to terrazo/ cement concrete floor 40 mm wide x 4mm thick (including all carriages lead and lift if any)

Steel work welded in built up section, trusses and framed works including cutting , hoising, fixing in position and applying a priming coat of approved steel primer incl all carriages complete (including all carriages lead and lift if any)

Providing and fixing precoated galvanised iron profile sheet (size ,shape,and pitch of corrugation as approved by enginner in charge ) 0.50 mm (+0.05%) total coated yhickness with zinc coating 120 gm. per sqm as per IS 277 ,in 240 mpa steel grade ,5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns min. to avoid scratches during transportation and should be supplied in single length upto 12 mt. or as desired by engineer -in-charge .The sheet shall be fixed using self drilling /self tapping screws od size (5.5x55mm) with EPDM seal,complete upto any pitch in horizontal/ verti cal or curved surface, excluding the cost of purlin ,rafter and trusess and including cutting to size and shape wherever reqd. (including all carriages lead and lift if any)

Providing and fixing precoated galvanised iron profile sheet (size ,shape,and pitch of corrugation as approved by enginner in charge ) 0.50 mm (+0.05%) total coated yhickness with zinc coating 120 gm. per sqm as per IS 277 ,in 240 mpa steel grade ,5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns using self drilling / self tapping screw complete Ridge plain (500-600mm) (including all carriages lead and lift if any)

Providing and fixing hard board celing sheet of approved quality with neccesary nails etc. complete 6mm thick including wooden corner moulding of triangle shape. as per requriment ( frame work paid separately) (including all carriages lead and lift if any)

Providing wood work in frames of false ceiling, partitions etc sawn and fixed in position second class kail wood (including all carriages lead and lift if any)

Applying priming coat with ready mixed pink or grey primer of approved brand and manufactures on wood work (hard and soft wood) (including all carriages lead and lift if any)

Painting of doors and windows with ready mixed synthetic enamel paint of approved brand and manufacturers in all shades (two or more coats) on new work

Making plinth protection 50mm thick with cement concrete ( 1 : 3 : 6) 1 cement : 3 Coarse sand: 6 stone aggregate) 20 mm nominal size f stone aggregate over 75 mm bed of dry brick ballast , 40 mm nominal size of well rammed and consolidated and grouted with fine sand including finishing the top smooth. (including all carriages lead and lift if any)

White washing with lime to give an even shade. New Work (three or more coats (including all carriages lead and lift if any)

Finishing walls with water proofing cement paint of required shade. New work (two or more coats) applied @3.84 kg/1O sqm (including all carriages lead and lift if any)

Electric wiring with 1.5 sqmm copper cable including 20 mm dia 2mm thick PVC pipe 5amp with sunken box and connection to the main pole complete as directed by engineer-incharge. (including all carriages lead and lift if any)

Providing and Fxing aluminium tower bolt ISI marked anodized (anodic coating not less than grade AC as per IS 1868) transparent or dyed to required colouur or shade with necessary screws etc. complete 100mm . (including all carriages lead and lift if any)

Providing and Fxing aluminium handle ISI marked anodized (anodic coating not less than grade AC as per IS 1868)transparent or dyed to required colouur or shade with necessary screws etc. complete 100mm (including all carriages lead and lift if any)

Providing and Fxing aluminium handle ISI marked anodized (anodic coating not less than grade AC as per IS 1868)transparent or dyed to required colouur or shade with necessary screws etc. complete 125 mm (including all carriages lead and lift if any)

Providing and fixing lSI marked oxidised M.S. sliding door bolts with nuts (including all carriages lead and lift if any)

Providing and fixing Ms grill of reqd. patter in frame of window etc with M S flat ,square or round bars ,railing;pipe etc all complete fixed to opening/window frame with raw plugs,screw etc (including all carriages lead and lift if any)

Dry random rubble masonary with hard stone in foundation and plinth using nallah stone without bond stone (including all carriages lead and lift if any)

Providing and fixing wooden moulded corner beading of triangular shape tothe junction of panelling etc with iron screw plugs and priming coat on exposed surface etc complete 50x50 mm (baseand height) 2nd class kail wood (including all carriages lead and lift if any)

Irshad Hussain Wani

M/S JAI DEV CONTRACTOR

M/S BALBIR SINGH