Construction of Modern Dairy Shed at University Park RAJ Bhawan Jaipur

Amount

Automatic Waterer- Specification:- 1. Automatic water trough is made of stainless steel with automatic valve. 2. The water trough length should be approximate 1 meter compatible to our shed design. Animal facility and floor mounted.

Swinging Cow brush/Grooming Machine- Specification:- 1. Sensor based start and stop automatic with electric motor. 2. Swings freely in all directions, smoothly up, over and alongside the cow to provide the comfort all- round. 3. Brush speed- more then 25 RPM 4. Nylon brush material 5. Bristle length- more then 15 cm long 6. The supplier should supply all kinds of fixture, safety switches etc. to make the brush working

Automatic animal washing system- Specification:- 1. Animal washing system (shower rails) consisting of 10 feet X 3 feet X 6 feet in order to bath the cows before entering the milking Parlor. 2. Pipes should be fitted in both side (upper and lower) and top (three side covering) Total 5X10 feet with made of G.I. pipes. 3. Made of G.I. Pipes 4. Diameter of pipes – 1.25 inch 5. Spray Nozzles – No. 25 6. Electric motor of suitable capacity, plumbing pipes and electrical connections etc. as required.

Cow mat- Specification:- 1. Thickness - 15 mm 2. Sizes (cm) - 120x180 3. Material Rubber

Dairy Fans- Specification:- 1. Propeller diameter : 1000 mm 2. No. of blades:- 06 3. Voltage – 230 V 4. Power consumption – 0.5 to 0.75 KW 5. Air speed – Above 25000 M3/hr 6. Moter protection class – IP 55

Foggers System- Specification:- 1. Complete with Nozzles Spray 2. Digital Timer 3. Half H.P. Electric Motor 4. 500 Liter Water Tank Capacity (Three layer) 5. Length Shed -14 meter 6. Nozzle fitted at 1 meter distance

Milking System- Specification:- 1. Flow controlled based milking system having milking capacity of 2 cows at a time. 2. Milking system with complete accessories including vacuum pump with vacuum tank, vacuum regulator can be run by fitting electric motor. 3. Vacuum tank material – Galvanized and rust resistant. 4. Milking can with Lid – 20 Liter Minimum. 5. Vacuum pump should be direct coupled with motor (No. 1) 6. Vacuum regulator should be spring loaded vacuum 40 to 50 Kpa adjustable (No.1) 7. Pulsator (should be fixed on flow control arrangement only) – Hydraulic pulsator. Pulse rate and ratio should be changeable based on milk flow (No. 2) 8. Flow control Device- Operates automatically low vacuum in stimulation & stripping and Normal vacuum in milking phase based on milk let down in cattle (No. 2) 9. Milking Cluster – Should have air admission hole. Liner should be Non toxic. Food grade comply BIR/FDA standards. 10. No. of milking cluster – (No. 2) 11. No. of milking buckets – (No. 2) 12. Electric motor with cables – at least 1 HP single Phage, 1400 rpm with on off switch and over load protection relay- (No.1)

Bidder Name

Amount

M/s bhati Construction Company