PROVISION OF WATER STORAGE TANK AND ADDITION / ALTERATION AND IMPROVEMENT TO SHUTTERS OF CERTAIN STORE HOUSES AT MO (MB) GHATKOPAR UNDER GE (NW) BHANDUP

Amount

Dismantling wrought iron or milt steel work of any description not other wise provided for complete all as specified and directed..

Demolition of concrete in ground floors (un re-inforced) and paving n.exc. 15 cm thickness (below or above ground level) and removal of rubbish/ demolished materials out of MD land complete all as specified and directed.

M&L PCC 1:2:4 B-2 (using 20mm graded crushed stone aggregate) as in sub base of floor ( 100mm thick ) finished even and fair cmplete all as specified.

Chipping, removing carefully loose/damaged concrete from surfaces of RCC members, in any location by low impact Hammer/Breakar without damaging the structure & cleaning the surfaces with wire brush etc and disposal of debris out side MOD land complete all as specified and directed. Note : 1) Hard concrete shall not be removed by force

M&L for cleaning existing reinforcement with wire/ rotary wire brush to a shining bright finish, making the surfaces free from loose material, dirt etc complete and applying two coats of alkaline rust converting primer conforming to ASTM-B-117 of approved make on rebars with time interval of 1 hour between the coats, complete all as specified and directed. (Note :- Mode of measurement: superficial area of concrete will be measured.)

M&L for carry out application of Bi -polar migratory corrosion inhibitor of approved make on RCC surfaces , complete all as spd and directed .( Note: Mode of measurment superficial area of concrete will be measured.)

M&L for Anticorrosive Treatment to Reinforcement using primer of approved make by application on exposed reinforcement in two coats with time interval of minimum 4 hours between each coat. The application shall be done by brush after cleaning/wire brushing to the exposed steel surfaces complete all as specified and directed . Note :- Mode of measurement: superficial area of concrete will be measured.

M&L for Epoxy bond coat of approved make over exposed concrete surfaces prior to application of any type of mortar / concrete to ensure bond between old concrete & new concrete/ new mortar by brush application, complete all as specified and directed.

M&L for building up the profile of structural members using polymer modified mortar while the bonding agent is still tacking upto 40mm thickness, including levelling, profiling etc, complete all as specified and directed.

S&F motorised rolling shutter of size 4m x3.8m motorised type of Model RS78GI of curtain made of single skinned galvanised steel laths with natural finish and pressed galvanised steel hood and motor cover with natural finish , CE certified CRS Compact Gear P.R.C Make: Indirect Drive Operator and three station push botton with dead man control at outside and inside complete all as specified and directed. Note:variation in size of shutter occured during site condition after repair of structural members. Note: Electrical wiring for providing single/three phase AC supply through a seperate MCB upto point of installation will be done by contractor. Cable, conduit and cable tray required for installtion of accossories will be supply and fixed by the contractor included the above quoted rates.

S&F motorised rolling shutter of size 4.20 x4.70m motorised type of Model RS78GI of curtain made of single skinned galvanised steel laths with natural finish and pressed galvanised steel hood and motor cover with natural finish , CE certified CRS Compact Gear P.R.C Make: Indirect Drive Operator and three station push botton with dead man control at outside and inside. Note:variation in size of shutter occured during site condition after repair of structural members complete all as specified and directed. Note: Electrical wiring for providing single/three phase AC supply through a seperate MCB upto point of installation will be done by contractor. Cable, conduit and cable tray required for installtion of accossories will be supply and fixed by the contractor included the above quoted rates.

S&F motorised rolling shutter of size 6.20m x 4.60m motorised type of Model RS78GI of curtain made of single skinned galvanised steel laths with natural finish and pressed galvanised steel hood and motor cover with natural finish , CE certified CRS Compact Gear P.R.C Make: Indirect Drive Operator and three station push botton with dead man control at outside and inside. Note:variation in size of shutter occured during site condition after repair of structural members complete all as specified and directed. Note: Electrical wiring for providing single/three phase AC supply through a seperate MCB upto point of installation will be done by contractor. Cable, conduit and cable tray required for installtion of accossories will be supply and fixed by the contractor included the above quoted rates.

M & L for rendering 10 mm thick in CM 1:6 on brick walls, RCC pillars,beams,purlins etc and finishing the surfaces even and smooth complete all as specified and directed.

M&L for preparation of new plastered surfaces on walls, chajjas,filling of hair line cracks with white cement and applying two coats of 100% anti fungal weather resistant acrylic paint over a coat of acrylic primer in approved shade and as per manufacturer's instructions including necessary scaffolding complete all as specified and as directed.

M&L for Excavating in post holes (or similar holes) each n exc 0.5 cu. m, getting out, returning,filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm in soft/ loose soil complete all as specified and as directed.

M&L for cement concrete type B2 1:2:4 (graded) for columns, posts and pillars (including caps and bases) complete all as specified and directed.

S&F MS Framed work (circular shape for ornamental and intricate design) such as grills, gratings, etc.. with ends of bars shouldered and/or riveted, or forged into spikes; framed guard bars; barred iron doors; ladders; framed balusters; walk ways; railings; framework of water tank and similar work conforming to Fe.290.Gde-E-165 complete all as specified and directed.

S&F MS Plates (plain or chequered) channels, square cut or notched (ordinary and counter sunk) forming holes, without any attachment Fe-410W-Gde-E-250 quality A complete all as specified and directed.

S&F 1000 L Rotational moulded polyethylene water storage tanks (cylindrical vertical with closed top) hoisted and fixed in position all as specified in SSR Part I complete all as specified and directed.

S&F 25mm Ball brass valves, high pressure, with polythene float and flynut complete, screwed for iron pipe or brass ferrule and fixed complete all as specified and directed.

M&L preparation of new steel Surfaces of any description and applying two coats of synthetic enamel paint over a coat of red oxide zinc chrome primer complete all as specified and directed.

S&F CP long nose bib tap 15mm bore fancy type with crutch or butterfly handle, screwed for iron pipe or for unions and fixed complete all as specified and directed.

Excavation in trenches not exceeding 1.5m wide and not excceing 1.5m in depth for exposing getting out GI/ CI Pipe in soft / loose soil complete all as specified and directed.

Excavation in trenches not exceeding 1.5m wide and not excceding 1.5m in depth for exposing getting out GI/ CI Pipe in hard dense soil complete all as specified and directed.

Returning filling including speading leveling watering and well ramming line layers not exceeding 25 cm after the pipes have been laid complete all as specified and directed.

Removing excavated material / soil to a distance n.exc 50 m above starting point complete all as specified and directed.

Supply and fixing in trenches for suction pipe jointing GI tubing medium grade 25 mm dia including all fittings such as bends elbows tees union short pieces conncectors check nuts caps plugs etc for the sizes complete all as specified and directed. Note: Excavation and earth work will be measured and paid seperately under relevent items.

Suuply and fix in repairs gun metal gate valve with iron wheel head screwed both ends for iron pipe for 25 mm complete all as specified and directed.

M&L for drilling and taping cast iron water mains (in position) for branch connection of the internal dia 25 mm existing pipe line upto 100 mm GI/CI/DI pipe complete all as specified and directed.

Deduct Credit for Demolished/ Dismantled material Rs. (-) 80,000.00 (Minus) as listed in Schedule of Credit Note1: Tenderers will not quote against this item being a tentative amount to be considered to arrive at the 'Contract Sum' Note 2:- The tenderer must keep in mind when quoting rates against items out in multiple store house having height 4 mts to 7 mts. Necessary scaffolding and saftey measures required during execution of work are including in this items.

Joy builders (BID ID -3231201)

R J ENTERPRISES (BID ID -3234357)

S K ENTERPRISES (BID ID -3234505)