Bodinayakkanur/ SIUS 25-26 / Kundalnayakkanpatty PU MIddle School Renovation / Pkg - 1

Amount

1) Renovation of PU Middle School Building East Side in Kundalnayakkanpatty Village at Uppukottai Panchayat

Dismantling Pressed Tiles & Weathering Course including all cost etc..,

Dismantling Wooden Windows including removal of frames, hinges and fastenings including all cost etc..,

Weathering course in brick jelly lime concrete using broken brick jelly of size 20mm uniform gauge in pure slaked lime (no crushed stone M.Sand to be used) to the proportion of brick jelly to lime being 32:12.5 by volume and laid over the RCC roof slab in a single layer of required slope and finished by beating the concrete with wooden beaters of approved pattern, keeping the surface constantly wet by sprinkling lime jaggery water, etc., complete as per standard specification and as directed by the deparmental officers.

Finishing the top of roof with one course of machine pressed tiles of size 230mm x 230mm x 20mm of approved quality set in Cement Mortar 1:3 (One Cement and Three Crushed stone M.Sand) 12mm thick mixed with water proofing compound conforming to ISS at 2% by weight of cement used and the joints pointed neatly to full depth of tiles with the same cement mortar mixed with red oxide and water proofing compound including curing etc., complete complying with standard specification and as directed by the departmental officers

Paving the floor with best approved quality fine polished Kota stone slabs of size 600 x 600 of 18 / 20mm with machine cut edges and matching marble slab not less than 100mm width other than Adanga Marbles as border laid over a cement mortar bed of 20mm thick using cement mortar 1:3 (One cement and three M.Sand) fixing the slabs in true right angles with minimum possible width of joints and pointing the joints with white cement mixed with mathcing colouring pigments and polishing with floor polisher to a high degree of finish etc., The kota stone slabs and other materials to be used shall be got approved by the Executive Engineer concerned before use on work, etc., complete as per standard speicification.

Brick work using country bricks of size 83/4"x41/4"x23/4" in cement mortar 1:5 (One cement and five M.Sand) including curing neat finishing, etc., complete complying with standard specifiction.

Plastering in CEMENT MORTAR 1:3 10mm thick in Including cost and conveyance of materials to site and all other labour charges including etc., as per standard specification.

Supply and Fixing of Cudappah Slab 50mm thick including all cost and conveynce etc.,

Paving the floor with pre-polished concrete anti-skid tiles (Required shape and design) of 20mm thick of approved quality and colour laid in Cement Mortar 1:3 (One Cement and Three crushed stone M.Sand) 20mm thick and pointed with white cement mixed with colouring pigment at the rate of 0.40 Kg. / sq.m., curing, etc., complete complying with standard specification and as directed by the departmental officers. (The make and brand of the tiles should be got approved by Executive Engineer before use on works) Using anti-skid tiles (Observed Data)

Plastering in CEMENT MORTAR 1:5 12mm thick in Including cost and conveyance of materials to site and all other labour charges including etc., as per standard specification.

supply and Delivery of steel door and Window inculuding cost and conveyance of all matrialse to site etc

Window 1.50 x 1.30

Labour charge for fixing door and window with frame in position etc. complete (finished work) and as directed by departmental officers

Window 1.50 x 1.30

Painting two coat over old wall surface with approved quality of Oil bound distember with colour mover okne coat of white cement for priming coat for base including preparation of old colour washing surface and all materials, labour charges etc

Painting two coat over old wall surface with approved quality of Plasitic Emulsion with colour mover okne coat of white cement for priming coat for base including preparation of old colour washing surface and all materials, labour charges etc

Painting two coat over old wall surface with approved quality of Old Black Board painting with colour mover okne coat of white cement for priming coat for base including preparation of old colour washing surface and all materials, labour charges etc

Painting TWO coat of enamal paint Old Iron works such as steel doors, windows, ventilators, window bars, balustrades etc., with best approved first quality of synthetic enamel paint of approved first quality of synthetic enamel paint of approved colour over the existing priming coats, etc., complete complying with standard specification. (The paint should be got approved by the departmental officers before use on works)

Electrical Arrangements

Wiring with 2x1.5sqmm(22/0.3) PVC insulated unsheathed SC. Cu.Conductor of 1100V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories with TW switch box with 5A F.T. switch inflush with wall,covered with hylum sheet of 3mm thick with painting of suitable colour for open PVC light / fan point (For electronic regulator) (5 Points Per Coil)(S.D.No.20)

Wiring with 2x1.5sqmm (22/0.3) PVC insulated SC unsheathed Cu.Conductor of 1100 V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories with 150 x l00 x 113 mm TW switch box for 5 A 3 pin non inter locking CS plug with painting of suitable colour with continuous earth wire connection of 14 SWG TC wire for open PVC plug point.(S.D.No.36)

Supply and fixing of Tube Light fitting ( LED ) complete with guard suitable for lamp with 40 W bulb with PVC unsheated leads from terminal to the fitting (S.D.No.87)

Supply and Fixing of Fan including all cost etc..,SD106

2) Renovation of PU Middle School Building West Side G+1 in Kundalnayakkanpatty Village at Uppukottai Panchayat

Paving the floor with best approved quality fine polished Kota stone slabs of size 600 x 600 of 18 / 20mm with machine cut edges and matching marble slab not less than 100mm width other than Adanga Marbles as border laid over a cement mortar bed of 20mm thick using cement mortar 1:3 (One cement and three M.Sand) fixing the slabs in true right angles with minimum possible width of joints and pointing the joints with white cement mixed with mathcing colouring pigments and polishing with floor polisher to a high degree of finish etc., The kota stone slabs and other materials to be used shall be got approved by the Executive Engineer concerned before use on work, etc., complete as per standard speicification.

Brick work using country bricks of size 83/4"x41/4"x23/4" in cement mortar 1:5 (One cement and five M.Sand) including curing neat finishing, etc., complete complying with standard specifiction.

Finishing the top of roof with one course of machine pressed tiles of size 230mm x 230mm x 20mm of approved quality set in Cement Mortar 1:3 (One Cement and Three Crushed stone M.Sand) 12mm thick mixed with water proofing compound conforming to ISS at 2% by weight of cement used and the joints pointed neatly to full depth of tiles with the same cement mortar mixed with red oxide and water proofing compound including curing etc., complete complying with standard specification and as directed by the departmental officers

Supply and Fixing of Cudappah Slab 50mm thick including all cost and conveynce etc.,

Plastering in CEMENT MORTAR 1:5 12mm thick in Including cost and conveyance of materials to site and all other labour charges including etc., as per standard specification.

Painting two coat over old wall surface with approved quality of Oil bound distember with colour mover okne coat of white cement for priming coat for base including preparation of old colour washing surface and all materials, labour charges etc

Painting two coat over old wall surface with approved quality of Plasitic Emulsion with colour mover okne coat of white cement for priming coat for base including preparation of old colour washing surface and all materials, labour charges etc

Painting two coat over old wall surface with approved quality of Old Black Board painting with colour mover okne coat of white cement for priming coat for base including preparation of old colour washing surface and all materials, labour charges etc

Painting TWO coat of enamal paint Old Iron works such as steel doors, windows, ventilators, window bars, balustrades etc., with best approved first quality of synthetic enamel paint of approved first quality of synthetic enamel paint of approved colour over the existing priming coats, etc., complete complying with standard specification. (The paint should be got approved by the departmental officers before use on works)

Electrical Arrangements

Wiring with 2x1.5sqmm(22/0.3) PVC insulated unsheathed SC. Cu.Conductor of 1100V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories with TW switch box with 5A F.T. switch inflush with wall,covered with hylum sheet of 3mm thick with painting of suitable colour for open PVC light / fan point (For electronic regulator) (5 Points Per Coil)(S.D.No.20)

Wiring with 2x1.5sqmm (22/0.3) PVC insulated SC unsheathed Cu.Conductor of 1100 V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories with 150 x l00 x 113 mm TW switch box for 5 A 3 pin non inter locking CS plug with painting of suitable colour with continuous earth wire connection of 14 SWG TC wire for open PVC plug point.(S.D.No.36)

Supply and fixing of Tube Light fitting ( LED ) complete with guard suitable for lamp with 40 W bulb with PVC unsheated leads from terminal to the fitting (S.D.No.87)

Supply and Fixing of Fan including all cost etc..,SD106

GST Amount for providing Service to Government Contract Works for the above Construction Works. { GST Amount is the Total GST Amount for total overall quoted amount above this row in column "BB" for all works in this package}

Kannan N (BID ID -1405398)