Repair and Renovation of Ayurvedic Dispensary at Parliwand Kathua (Balance work) under 4210- Health.

Amount

Dismantling old plaster or skirting, raking out joints & cleaning the surface for plaster including disposal of rubbish to the dumping ground with all leads & lifts.

Demolishing cement concrete 1 : 3 : 6 or richer mix manually/ by mechanical means including disposal of material, all leads & lifts.

Providing & laying damp-proof Course 40 mm thick with cement concrete 1:2:4 (1 cement:2 coarse sand: 4 graded stone agg 12.5 mm nominal size) and curing complete

Dismantling doors, windows and clerestory windows of area 3 sqm and below (steel or wood) shutter including chowkhats, architrave, holdfasts etc. complete and stacking ,all leads & lifts.Second class deodar wood

12mm cement plaster of mix 1:4( 1 cement : 4 fine sand) including drip course/groove all leads, lifts and carriage of material by MT / H.L.

Providing wood work in frames of Sal wood in doors, windows, clerestory windows and other frames wrought framed and fixed in position with hold fast lugs or with dash fasteners of required dia and length (hold fast lugs or with dash fasteners shall be paid for separately)

Providing and fixing wire gauze shutters using galvanized M.S. wire gauze of average width for aperture 1.4 mm in both directions with wire of dia. 0.63 mm for doors, windows and clerestory windows with ISI marked M.S. pressed butt hinges bright finished of required size with necessary screws as per direction of Engineer-in-charge : 9Second class deodar wood

Providing and fixing glazed shutters for doors, windows and clerestory windows using 4mm thick float glass panes including ISI marked M.S. pressed butt hinges bright finished of required size with necessary screws. Second class deodar wood

Providing and fixing panelled or panelled and glazed shutters for doors, windows and clerestory windows fixing with butt hinges of required size with necessary screws, excluding panelling which will be paid for separately, all complete as per direction of Engineer-in-charge. (Note: -Butt hinges and necessary screws shall be paid separately). Second class deodar wood

Providing and fixing panelling or panelling and glazing in panelled or panelled and glazed shutters for doors, windows and clerestory windows (Area of opening for panel inserts excluding portion inside grooves or rebates to be measured). Panelling for panelled or panelled and glazed shutters 25 mm to 40 mm thick , Particle Board 12 mm thick plain particle board flat pressed, three layer or graded wood particle board medium density grade IS: 3087 marked.

Providing 40x 5 mm flat iron hold fast 40cm long incl. fixing to frame with 10mm diameter bolts nuts and wooden plugs with embeddings in cement concrete blocks 30x10x15 cm 1:3:6 mix ( 1 cement: 3 coarse sand: 6 Graded stone aggregate 20mm nominal size including all leads, lifts and carriage of material by MT / H.L.

Providing and fixing aluminium tower bolts ISI marked(anodized anodic coating not less than gradeAC 10 as per IS: 1868 transparent or dyed to required colour or shade with necessary screws etc.complete

Providing and fixing aluminium handles ISI marked anodised (anodic coating not less than grade AC10 as per IS:1868) transparent or dyed to required colour or shade with necessary screws etc complete

Providing and fixing aluminium hanging floor door stopper ISI marked anodised(anodic coating not less than grade AC 10 as per IS : 1868) transparent or dyed to required colour or shade with necessary screws etc. complete: Single rubber stopper

Providing and fixing aluminum sliding door bolts 300 x 16 mm ISI marked anodised (anodic coating not less than grade AC 10 as per IS: 1868) transparent or dyed to required colour or shade with nuts and screws etc. complete:

Finishing walls with water proofing cement paint of required shade new work (two or more coats applied @ 3.84 Kg/10 Sqm).

Painting with synthetic enamel paint of approved brand and manufacture to give an even shade.Two or more coats on new work.

Applying priming coat with ready mixed pink or grey primer of approved brand and manufacture on wood work ( hard and soft wood)

Providing and fixing M.S. grills of required pattern in frames of windows etc. with M.S. flats, square or round bars etc including priming coat with approved steel primer all complete Fixed to openings / wooden frames with rawl plugs screws etc.

Providing & laying 400 micron thick transparent Poly Vinyl Chloride sheet on the roof under mud phaska cutting placing complete job.

10 cm thick mud phaska of damped brick earth on roofs laid to slope consolidated and plastered with 25 mm thick mud mortar mixed with bhusa at 35 kg/cum of earth and gobri leaping with mix 1 : 1 ( 1 clay : 1 cow dung) and covered with flat tile bricks of class designation 100 grouted with cement mortar 1:3 mixed with 2% of integral water proofing compound by weight of cement & finished neat with hand moulded F.P.S. brick tiles incl. all leads, lifts & carriage of material by MT/ H.L.

Providing gola 75 x 75 mm in cement concrete 1:2:4 ( 1 cement : 2 coarse sand : 4 graded stone aggregate 10mm down gauge) including finishing with cement mortar 1:3 ( 1 cement : 3 fine sand) as per standard design in 75 x 75 mm deep chase including all leads, lifts and carriage of material by MT / H.L.

Making Khurras 45 x 45 cm with average minimum thickness of 5 cm cement concrete 1:2:4 ( 1 cement : 2 Coarse sand : 4 graded stone aggregate of 20 mm nominal size) over PVC sheet 1 m x 1m x 400 micron, finished with 12 mm cement plaster 1:3 ( 1 cement : 3 coarse sand) and a coat of neat cement, rounding the edges, making and finishing the outlet complete incl. all leads, lifts & carriage of material by MT/ H.L.

Providing and fixing on wall face un- plasticized 110 mm diameter rigid PVC rain water pipes conforming to IS:13592 Type -A including jointing with seal ring conforming to IS:5382 leaving 10 mm gap for thermal expansion single socketed pipes

Providing and laying vitrified floor tiles in different sizes (thickness to be specified by the manufacturer) with water absorption less than 0.08% and conforming to IS:15622 of approved make, in all colours and shades, laid on 20mm thick cement mortar 1:4 (1cement :4 coarse sand) including grouting the joints with white cement and matching pigments etc. complete Size of tile 600x600 mm

Providing and laying Ceramic glazed floor tiles 300x300 mm (thickness to be specified by the manufacturers) of 1st quality conforming to IS: 15622 of approved make, laid on 20 mm thick bed of cement mortar 1: 4 ( 1 cement : 4 coarse sand) including pointing the joints with white cement and matching pigment etc., complete. In colour such as White, Ivory, Grey, Fume Red Brown

Providing and fixing G.I. pipes complete with G.I. fittings and clamps, including cutting and making good the walls etc.Internal Work-Exposed on wall.

15 mm dia nominal bore Medium

20 mm dia nominal bore Medium

Providing and fixing 15 mm nominal bore C.P. brass angle valve for basin mixer and geyser points of approved make conforming to IS : 8931

Providing and fixing C.P brass bib cock of approved quality conforming to IS: 8931. 15 mm nominal bore complete job.

Providing and fixing wash basin with C.I / M.S brackets 15mm C.P brass pillar taps, 32mm C.P brass waste of standard pattern, including painting of fittings and brackets, cutting and making good the walls wherever required. White Vitreous China. Flat back Wash basin size 450 x 300 mm with single 15mm C.P brass pillar tap

Providing and fixing P.V.C waste pipe for sink or wash basin including PVC waste fitting complete semi rigid pipe 32 mm dia

Supply and fixing C.P. grating 100 mm dia

Providing and fixing ball valve (brass) of approved quality complete, high or low pressure with plastic floats 20 mm nominal bore

Providing and Fixing G.I. Union in G.I. pipes including cutting and threading the pipe and making long screws etc. complete(new work).20 mm dia nominal bore

Providing and fixing PVC Waste/sewerage pipe of 4 kg Pressure/sqm of Supreme/Prince/finolex make on wall face unplasticised rigid PVC rain water pipe conforming to IS: 13592 Type-A including jointing with seal ring conforming to IS: 155382 laving 10 mm gag for thermal expansion of approved quality 110 mm dia

Providing and fixing Aquaguard of Kent,Havells etc. of 8 litres capacity including installation ( complete job).

SHIV KUMAR

M/S Anirudh Dutt

ABHILASH KOUSHAL

Rajesh Kumar

GAGAN SINGH GOVT CONTRACTOR