PROVISION OF COVERED SHED NEAR COMMUNITY HALL BUILDING NO P 55 AT KADAMBA VANAM NAVAL BASE KARWAR UNDER GE SB KARWAR

Amount

SCHEDULE 'A'-PART I (B/R WORKS)

Excavating in trenches, not exceeding 1.5 m wide and not exceeding 1.5m in depth for foundation, etc. or for shafts, wells, cesspits, manholes, pier holes, etc. not exceeding 10 sqm on plan and getting out in hard/dense soil complete all as specified and as directed.

Returning, filling in soil, including spreading, levelling, watering and well ramming in layers not exceeding 25 cm complete all as specified and as directed.

Removing excavated materials not exceeding 50m and depositing where directed at a level not exceeding 1.5m above the starting point complete all as specified and as directed.

M & L for hardcore of gauge not exceeding 63 mm of broken stone/boulders, deposited, spread and levelled in layers not exceeding 15 cm thick, watered and rammed to a true surface.

M&L for plain cement concrete 1:4:8 type D2 using 40mm graded stone aggregate as in foundation & filling in Mass concrete complete all as specified and as directed.

M&L for plain cement concrete M-15, 1:2:4 type B2 using 40mm graded stone aggregate as in foundation & filling in Mass concrete complete all as specified and as directed.

M&L RCC design mix M-30 (using 20 mm graded aggregate) foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc, basement slabs, under-reamed piles and mass concrete complete all as specified and as directed.

M&L for mild steel TMT (CRS) bars 10mm dia and over, cut length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips quality conforming to complete all as specified and as directed.

All as per Item No.8 here in before but 5mm dia and over upto and including 10mm dia in stirrups, spacers and binders complete all as specified and as directed.

M&L for formwork to sides of concrete foundations, footings, bases of col umns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; rough finished surfaces of conrete flat complete all as specified and as directed.

S&F Rolled sections as in main and cross beams, hip and jack rafters, purlins where connected to common rafters and running rails and guides fixed with angle cleats or other connecting plates conf to Fe-410-w or E-250 quality A complete all as specified and as directed.

S&F Joist, channel, angle, or tee sections in vertical posts, fixed independently, with/without connecting plates, etc. conf to Fe-410-w or E-250 quality A complete all as specified and as directed.

S&F Framed work such as grills, gratings, etc.. with ends of bars shouldered and/or riveted, or forged into spikes, framed guard barss barred iron doors, ladders, framed balusters, walk ways, railings, framework of water tanks and similar work conforming to Fe.290.Gde-E-165 complete all as specified and as directed.

M&L for pre-cast cement concrete block masonry , type C-5 using 20mm graded stone aggregate using solid block exceeding 10 cm in width and set in cement mortar 1:6 complete all as specified and as directed.

M& L for rendering 15 mm thick in cm 1:4 on fair faces of concrete surfaces and finished even and smooth without using extra cement and mixed with waterproofing compound @3% by weight of cement complete all as specified and as directed.

Supply only Integral Water proofing compound complete all as specified and as directed.

M&L for applying two coats of oil bound distemper over a coat of primer and wall care putty including preparation of new plaster surface complete all as specified and as directed.

M&L for glazed ceramic tiles (Ist quality) in vertical surface 350x 250x 7mm/ 450X 300X 7mm thick including 10mm thick cement plaster in cement mortar 1:3 set and jointed in neat cement slurry and pointed in white or colour cement to match the colour of tiles complete all as specified and as directed.

M&L for pre-painted galvalume aluminium zinc coated GI based corrugated steel sheet 0.5 mm thick of an colour having tensile strength of 550 mpa as in roof covering/cladding to wall, fixed with self tapping screws complete all as specified and as directed.

M&L pre-painted galvalume aluminium zinc coated GI based plain steel sheet 0.5 mm thick of an colour having tensile strength of 550 Mpa as in ridge, roof covering/cladding to wall, fixed with self tapping screws complete all as specified and directed

M&L for applying two coats of synthetic enamel paint over a coat of red oxide zinc chrome primer including preparation of new steel surfaces of any description exceeding 10cm in width or girth complete all as specified and as directed.

S&F 110mm dia PVC (SWR) pipes single socketed in any length with rubber rings joints fixed to walls/vertical posts as rain water pipes complete all as specified and as directed.

S&F 110mm dia PVC (SWR) bends complete all as specified and as directed.

SCHEDULE 'A'-PART II (E/M WORKS)

M&L for point wining complete with 1.5 Sq mm two single core PVC insulated, unsheathed 1100volts a grade cable with stranded copper conductor FR-LHS grade conforming to 15-694 part II with SI mark FR-LHS grade drawn through and including suitable size rigid non metallic PVC conduit concealed with all accessories, including suitable size sunk presses steel or cast iron terminal box with 3mm thick plastic laminated sheet top cover fixed flush with wall surface by means of brass screw and sunk cup washers for mounting of switches, sockets, fan regulators etc including providing 1.5 Sq mm PVC insulated unsheathed solid copper conductor cable as earth wire connected to metallic bodies of luminaries/fan etc at one end and to common earth dolly at other end all as specified for fan/light point for following

All as per item No.24 One 5 Amps socket point on independent board complete all as specified and as directed.

All as per item No.24 here in before but for using 2.5 sq mm copper conductor multi stranded for power points on independent board complete all as specified and as directed.

S&F Decorative ultra slim aluminium square profile LED lighting fixture with high lumen output, environmental friendly, energy efficient ready to use is a complete range of for upto 1x24 watts LED tube light complete all as specified and as directed.

S&F Ceiling fan 1200 mm sweep including electric connection from ceiling rose to connector with flexible cord twin core twisted copper of size 23/0.0076 and testing complete all as specified and as directed.

S & F Ceiling rose, 3 phase/ PVC / polycarbonate, isolated body complete all as specified and as directed.

S&F Switch piano 5 Amps one way flush type, ISI marked complete all as specified and as directed.

S&F Switch socket combination 2 in 1, 5 pin, 5 Amps flush type, ISI marked complete all as specified and as directed.

S&F Switch socket combination 5 Amps/16 Amp. 5 in 1 flush type, multi purpose, ISI marked complete all as specified and as directed.

M&L for sub main wiring with two runs of single core PVC FRLS insulated cable with copper conductor multi stranded 1100 volts grade 4.0 sq mm through and including with suitable size of PVC conduit and its accessories, concealed in wall surface in ceiling along with fixing arrangement etc including one run of 4.0 sq mm PVC insulated multi stranded copper earth continuity conductor and connected to common earth dolly complete all as specified and as directed. Notes: (i) Three runs of 4 sqmm cable and one run of PVC conduit shall be measured as one unit length.

S&F Sheet metal enclosure MCB DB SPN 8 ways double door type with suitable bus bar complete all as specified and as directed

S&F MCB SP single pole 'C' series 5 to 40 Amps 230 volts 10 KA rupturing capacity complete all as specified and as directed.

S&F MCB DP 'C' series 5 to 40 Amps 230 volts 10 KA rupturing capacity complete all as specified and as directed.

shrilaxminarayan constructions

K.G.SHANKER

M/S G.N.POWAR

Sweet Home Constructions

KVL CONSTRUCTION

LEKSHMI ENGINEERS