PL RMC M-40 grade RMC alongwith 5 Year Maintenance guarantee and 80mm thick paver blocks ISI marked from Tiwari Communication to Nain chowk in Ward No.7 NIT Faridabad

Amount

P/L in position machine, batched, machine mixed and machine vibrate ready mixed cement concrete (R.M.C) of grade M-40 with cement content not less than 400 kg/cum imparting minimum flexural strength of 40mpa at 28 days. The slump value will be in the range of 80+-15mm for laying on road including the cost of steel from work with sturdy M.S.channel section including cost of admixture in recommended proportions (as per IS 9103) to accelerate, rated - setting of concrete improve workability without imparting strength and durability including pumping concrete with pumps with pumps with required. The RMC is to be procured from plants of A.C.C/L&T/BIRLA at Faridabad & Gurgaon. The finishing of the laid cement concrete with surface vibrator and mechanical trowel including cost of curing 28days, barriers, diversion of traffic and lighting arrangement and chowkidar etc. Complete in all respect as per satisfaction of the engineer-in-charge.

-Extra for making rough surface of concrete pavement for providing non slippery by mechanical cutter for safe plying of vehicles as per entire satisfaction of the

Engineer-in-charge.

-P/L in position separation membrane of 125 micron thick impermeable plastic sheet of make IPCL complete as per specification.

-providing and making saw cut longitudinal joints between two lanes including cost of providing protective coating and bituminous paint for 75mm on each side of joint of tie bar. initially 3-4mm vide cut shall be made upto 1/3depth of slab and sealed temporarily with a jute rope. at the time of sealing the joint 2mm thick compressible de-bounding strips with paperback shall be inserted to the bottom of groove. the groove shall be filled with poly sulphide /silicon sealant. the sealant shall be applied slightly to a lower level than the slab with a tolerance of 2+1mm complete in all respect as per approved drawing to the entire satisfaction of the engineer-in-charge.

-Providing and making saw cut transverse joint .constructions joint as per approved drawing provided at a maximum distance of 4.5m including the cost of covering of dowel brass with thin plastic sheath for at least 60% of the length from one end. Initially 3 to 4mm wide cut shall be make after 1 to 2 days up to 1/3ed depth of slab and including cost of scaling temporarily with a jute rope. At the time of sealing of the joint temporary seal shall be taken out and 10 to 12mm wide grooves shall be made upto a depth of 22mm. before sealing the joint 5mm thick compressible de-bounding strips with paperback shell be inserted to the bottom of the groove. The groove shall be filled with poly sulphide / silicon sealant. The sealant shall be applied slightly to a lower level than the slab with a tolerance of 2+1 mm complete in all respect as per approved drawing & entire satisfaction of the engineer in charge.

Bidder Name

Amount

NAVEEN TEWATIA(GSTN-NA)

M/s Hariom Enterprises(GSTN-NA)

M/s Hariom Enterprises

M/s Hariom Enterprises