REPAIR/REPLACEMENT OF ELECTRICAL FITTINGS/FIXTURES, REWIRING AND CONNECTED ITEMS OF WORKS AT NAMKUM/KHOJATOLI AREA UNDER GE RANCHI

Amount

Taking down carefully aluminium point wiring any type including battens if any except for ceiling or where not feasible for light/ fan//bell/socket or power and including unscrewing from board, fitting and fixure such as switches,socket, ceiling rose,lamp holder,pendants, bracket and regulator etc and removing material from site including making good disturbed surface to match with the existing surface complete all as specified and directed

Taking down Aluminium sub main wiring including GI earth wire and making good disturbed surfaces to match with the existing surface roof/wall/floor complete all as specified and as directed.

M&L for sub main wiring with two single core FR 6 Sqmm copper conductor PVC unsheathed cable medium grade including PVC conduit (Appropriate size) concealed in wall for sub main connection including FR 4 Sqmm PVC insulated multistraded unsheathed copper conductor used as a earth wire to common earth and connection to earth dolly all complete all as specified and directed. (Note :- Two runs of 6 Sqmm and one run of 4 Sqmm copper conductor shall be measured as one unit lenght i.e Phase, Neutral, Earth)

M&L point wiring with FR 1.5 Sqmm multi strand PVC insulated and unsheathed copper conductor cable in and including surface caping and casing complete with 1.60mm thick pressed steel concealed terminal boxes and with top cover 2.80mm thick ISI marked plastic laminated hylum sheet of reqd colour fixed with brass screws and cup washers , painting terminal boxes inside and out side with one coat red oxide primer complete with all accessories and all as specified including FRLS1.5 Sqmm PVC insulated unsheathed multistranded copper conductor to common earth and connected to earth dolly for following. Note : (I) All wiring cable shall be multi stranded FR copper conductor of approved made duly approved by accepting officer before incorporting. (II) Colour Code as per IS to be follow for wiring. (III) Same size of conducor use in any type of wiring(Phase/nutral/earth conductor should be of same size

One light/fan/bell/exhaust fan point controlled by one switch.

One 5 pin 5 Amp switch socket out let point on same board.

All as per item No 4 above but for one 5 Amp 5 Pin switch socket out let independent with 2.5 Sqmm FR (Nominal Area) PVC unsheathed copper conductor single core multistranded complete all as specified and directed.

All as per item No 4 above but for one 15 Amp 6 Pin switch socket out let independent with 4 Sqmm FR (Nominal Area) PVC unsheathed copper conductor single core multistranded complete all as specified and directed

S&F sheet metal enclosure for double door DBs for using MCBs single pole and neutral 8 way with 200 Amps rated busbar 240 Volt complete all as specified and directed

S&F sheet metal enclosure for double door DBs for using MCBs single pole and neutral 4 way with 200 Amps rated busbar 240 Volt complete all as specified and directed

S&F Isolator doble pole 40 Amp 240 volt.

S&F MCB single pole 6 to 32 Amp 240 Volt 'B' curve 10 KA complete all as specified and directed .

S&F switch piano flush type 5 Amp single pole one way.

S&F switch socket combinations 2 in 1 flush 5 Amp 5 Pin complete all as specified and directed

S&F switch socket combination out let 6 Pin 2 in 1, 5/15 Amp flush type 240 Volt complete.

Supply and fixing socket out let 2 in 1,3 pin, 5 Amp flush type

S&F ceiling rose surface bakelite 65x50mm three terminal AC 230 volts complete all as specified and directed.

S&F of flexible wire twin core copper conductor of size 23/.0076 for flourescent tube light fitting/ fan up to 1.00 mtr complete all as specified and directed.

S&F electronic stepped type electronic fan regulator flush typeon the existing laminated sheet step type 450 watt 230 Volt 50 C/S.

S&F in replacement of decorative wall mounting luminaries light suitable for LED bulb 9/11 watt with all accessories like lamp holders etc complete with pre-wired complete all as specified and directedMake - Philips/Wipro/ Bajaj/Havells.

Taking down the existing ceiling fan and Refixing the same complete all as specified and directed .

S & F in replacement LED Tube light with aluminium body fitting 1 x 18 W Energy efficient. box type epoxy powder coated CRCA sheet housing with reflector cover Chanel, without electronic ballast, bipin holder, connector block, etc complete LED tube rod & excluding connecting up with twin core twisted flexible copper conductor cable of suitable size complete all as specified and directed. Cat part No-LT5RT1-18-CDL Make-Crompton/Bajaj/Philips.

Supply and fixing bell push flush type AC 230 Volt

Supply and fixing call bell ding-dong type AC 230 Volt

S&F LED Mirror Light 9 Watt 600mm long with lux output 900 lumins i.e 100 lumins/per watt complete all as specified and directed

S&F angle holder with LED Lamp of 9 watt Watt complete all as specified & directed.

M & L Earthing complete with galvanized GI earth plate electrode of size 600 x 600 x 6.00 mm ,buried directly in ground (earth pit not less than 2.25 mtrs below normal ground level)with top edge of earth plate not less than 1.5 mtr below normal ground level, connected to galvanized earth lead wire 4.0 mm dia by means of bolts ,nuts ,check nuts of galvanized iron or steel including excavation and earth work in any type of soil, charcoal salt filling 15 cm around the earth plate as shown in electrical plate no 3 of SSR part-I 2004, 20 mm bore, GI watering pipe medium grade 1.50 mtr long & GI protection pipe light grade 15 mm dia from earth pit to main board including making pit with PCC 1:3:6 type C1 and pre cast RCC cover 40 mm thick, reinforced with 8mm dia deformed bars @ 100 mm c/c both ways with lifting handles and funnel etc including testing complete all as specified and directed.

S&F in replacement of electronic chock 36/40 Watt ISI marked Make - Philips/ Bajaj/Havells

S&F in replacement of 5 Amp socket out let 5 pin ISI marked Make - Philips/ Bajaj/Havells/Anchor

S&F in replacement of switch socket combinations flush 5 Amp 5 pin compete, ISI marked Make - Philips/ Bajaj/Havells/Anchor

S&F in replacement of switch socket combination 15 Amp, ISI marked Make - Philips/ Bajaj/Havells/Anchor

S&F switch piano flush type 5 Amp single pole one way.

Supply and fixing regulator step type 450 watt 230 Volt 50 C/S

Supply and fixing call bell ding-dong type AC 230 Volt

S&F in replacement of electronic chock 36/40 Watt ISI marked Make - Philips/ Bajaj/Havells

S&F in replacement of tube rod LED type of 18 watt Make- Philips/Bajaj/Havells

S&F LED bollard light 10 Watt in spherical shape polycarbonate diffuser and IP 65 protection Make Bajaj/Cormptom

M&L for replacement of unserviceable 36 W recess mounting LED low glare luminiaries 2 x 2 with paralite powder coated CRCA sheet steel housing perforated metalic frame Make : Crompton/Bajaj/HPL/CG/Syska

S&F in replacement PVC insulated PVC sheathed 1100 volts grade heavy duty cable with insulated stranded aluminium conductor of cross section area 10 Sqmm 2 Core as in services connection suspended by insulating hanger not more than 1 mtr apart including 4mm galvanised suspension wire including making connection from pole to main DB board complete all as specified and directed

Raj Construction

M/s Dwarika Nath Singh

M/S JAI MATA DEE CONTRUCTION CO.

M K Enterprises

M/S ABDHESH CONSTRUCTION

M/S mahabirsahu

M/S Sahib N Sahiba Enterprises

jai maavindwashni sales & supply