Repair /maint to UG Cable of Tennis and Badminton court incl flood lights of Officers Mess 39 GTC at Varanasi Cantt

Amount

M&L excavation in trenches soft/loose soil n exc 1.5m wide and n exc 1.5m in depth and getting out including filling bottom surface to required or level or slope laying of pipes/cables out complete all as specified and directed. 59 Cum

M&L returning filling in including spreading, levelling, watering and well ramming in layers not exceeding 25 cm in soft soil complete all as specified and directed. 34 Cum

M&L removing of surplus excavated soil to a distance not exceeding 50 mtr and deposited where directed at a level not exceeding 1.5m above the starting point in soil complete all as specified and directed. 25 Cum

Supply and laying dry local sand for sand cushioning for protecting underground cable (8cm below and 15 cm after laying cable) laying in trenches including punning the sand upto 18cm thick and consolidated complete all as specified and directed. 23 Cum

Supply and laying dry well burnt locally available brick sub class ‘B’ modular bricks laid flat with width equal to the length of whole bricks over cable as cable protection complete all as specified and directed. 2.4 Per 1000 Nos

Supply and fix GI pipe 40mm, light grade ISI marked including all fittings such as bends, Tees, Sockets etc fixed on walls/poles or laid in trenches under road crossing / hard standing including taking down Old / unserviceable existing pipe complete all as specified and directed. 20 RM Make : TATA, Jindal, Utkarsh, Nezone, Surya Prakash or equivalent.

M&L for dismantling of old/unserviceable LT cable including supply and lay cable XLPE insulated, screened PVC bedded, galvanised steel strip or wire armoured, electric power, LT (heavy duty) 1100 volts grade with stranded aluminium conductor of size 50 sqmm 3.5 core including taking down old/unserviceable LT cable complete all as specified and directed. 90 RM Make : Havells, Asian cables, Gloster, KEI or equivalent. Note : Excavation will be measured and paid separately.

M&L for dismantling of old/unserviceable LT cable including supply and lay cable XLPE insulated, screened PVC bedded, galvanised steel strip or wire armoured, electric power cable, LT (heavy duty) 1100 volts grade with stranded aluminium conductor of size 6 sqmm 2 core including taking down old/unserviceable LT cable complete all as specified and directed. 240 RM Make : Havells, Asian cables, Gloster, KEI or equivalent. Note : Excavation will be measured and paid separately.

M&L for bore hole for passing cable through / insertion of 80/50/40 mm dia GI pipe under PCC road/taxi track/run way/hard standing not less than 600 mm deep complete all as directed by Engineer-in-Charge. 10 RM Note :- (i) Cost of equipments, tools & plants, material required for boring shall be deemed to be included in unit quoted rates above. (ii) GI pipe shall be measured and paid separately

M&L for GI bracket for street light fittings fabricated with GI tubing 40mm dia “medium grade” 1.2m long including and bending to angle of 120 degree fixed in repair complete all as specified and directed. 4 Each

M&L for mild steel clamp fabricated with mild steel flat iron 50 x 6 mm including nut and bolts with washer suitable for fixing of GI bracket on PCC/steel poles fixed in repair complete all as specified and directed. 8 Each

S&F LED street light luminaries 90 watt with pressure die cast aluminium housing with heat resistant toughened glass and IP66 protection complete including connection on pole or building including taking down of old / unserviceable street light fitting complete all as specified and directed. 4 Each Make – Crompton Greaves cat No – LSTO-90-CDL/Philips/Bajaj/C&S/Wipro/Havells

S&F LED integral flood light luminaries 150 watt iin powder coated with aluminium die cast housing and frame, high efficiency, long life LEDs, loop in loop out connector, 10A G.F.P for each wiring heat resistant toughened Lear glass cover and IP66 protection complete assembly with LEDs, driver and accessories pre wired upto terminal block in control gear compartment including connection on pole or building including taking down of old / unserviceable street light fitting complete all as specified and directed. 6 Each Make : Wipro cat No LR18-971-XX-57-XX/Philips/Bajaj/C&S/Havells.

M&L for hot pressed moulded SMC junction box of size 230x170x105mm, width 2 Nos aluminium insulated bus bar rating 30 Amp mounted on insulator including 01 No of MCB, SP, 6 Amp, 240 volt fixable twin core copper cable PVC insulated 2.5 Sqmm from junction box to the light fittings and flat iron clamp of size 25x3mm with hinged cover & locking arrangement fixed in repair including taking down old / unserviceable junction box complete all as specified and directed. 10 Each Make : Sintex

M&L for taking out old unserviceable bus bar panel and supply and fix factory made double door outdoor type feeder pillar box made out of 3.15mm thick CRCA sheet epoxy powder coated hinged cover with locking arrangement including angle iron stand made out of 50x6 painted with two coats of black bituminous paint over a coat of red oxide primer and embedded in PCC 1:2:4 using 20mm graded stone aggregate 30cm below and 60 cm above the normal ground level painted with two coat of synthetic enamelled paint over a coat of red oxide primer suitable for housing the following accessories :- 1 Each

TPN 415V Aluminium bus bar 200A - 1 No

MCCB 415V TPN 100A, 25KA of make ABB/Havells/Legrand - 1 No

MCB SPN 63 Amp, 10 KA ABB/Havells/Legrand - 4 Nos

Astronomical programmable timer switch 6KW single phase 220 V with suitable contactor of make - ABB/Havells/Legrand - 1 No

M&L for taking out old unserviceable / damaged LT pole and supply and errection in true vertical position steel tubular pole swaged type 410-SP 31(9.0m long pole) as per IS:2713 (part I to III ) 1980 complete with cast iron base plate, pole cap, mild steel bolt, nuts and screws complete including dismantling of existing pole all as specified including consisting of following works :- 3 Each Job

Excavation in trenches not exceeding 1.5 mtr wide & 1.57 mtr deep for pole foundation & getting out in soft / loose soil, returning filling in the excavated of soil after fixing the pole in foundation ramming earth around in layer not exceeding 25 cm thick and disposal of surplus soil to a distance not exceeding 50 mtrs complete all as specified and directed.

M&L for PCC 1:4:8, type D2 (using 40mm graded crushed stone aggregate) in foundation 900mm x 600mm cross section and planting depth 1.5mtr for concrete encasing the pole upto GL complete all as specified and directed.

M&L for providing PCC 1:3:6, type C-1 (using 20mm graded crushed stone aggregate) for plinth block/collar above GL 500mm high and 450mm dia complete all as specified and directed.

M&L for painting of pole externally with one coat of black bituminous paint (upto planting depth) and above plinth block concrete collar with two coat of aluminium paint over a coat of red oxide primer including preparation of surface including painting of 30cm wide bands 3 Nos with synthetic enamel paint of appropriate colour in alternate layer upto the height of 1.5mm above plinth block.

M&L for writing letter or figures (Block Roman, Italic as Indian) with thick synthetic enamel paint of apprised shade not exceeding 5 cm height including numbering of pole complete all as specified and directed. Note : Manufacture’s test certificate will be produced before execution of work. Make : National tubing Co Kanpur or BCW Kanpur or M/s Sohan Lal & Sons or United Engineers, Kanpur

V K ENTERPRISES

TECH-NIG COMPUTERS

PANDEY ENTERPRISES

SHAKTI TRADING CORPORATION