REPAIR TO ROOF OF SHEDS FLOOR, TILING, BIRD PROOFING AND CERTAIN MISC WORK IN TECH AREA AT AF STN UTARLAI

Amount

S & F Pre- painted galvatume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws including dismantling the old sheeting complete all as specified and directed.

S & F Pre-painted galvalume aluminum zinc coating GI based Plain steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws including dismantling the old sheeting complete all as specified and directed.

S & F Hand rails, half round or other steel section or core for wooden hand-rail straight portion, drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embeding in concrete and screwing etc. wind ties for roof including securing bolts; posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 and including dismantling Complete all as specified and directed

S&F Rolled sections as in main and cross beams, hip and jack rafters purlins where connected to common rafters and running rails and guides for sliding doors; fixed with angle cleats or other connecting plates Fe-410- W(Gde- E-250) quality- B, and including dismantling, Complete all as specified and directed

M & L for preparation of new steel surfaces of any description, exc 10cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified.

M & L for preparation of new steel surfaces of any description, n.exc 10cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified.

Demolition of reinforced cement concrete (reinforcement cut as required to facilitate demolition) as in Roofs, floors (other than ground floors), beams, staircases, landing, chajjas and similar suspended work , Complete all as specified and directed.

M&L for reinforced cement concrete design mix M-25 (20mm graded aggregates) in Slabs supported on walls, beams and columns in floors, roofs, landings, balconies, canopies, deck slabs and in shelves and the like, complete all as specified and directed.

Formwork to (rough finished flat surfaces of concrete ) soffits of suspended slabs such as roof slabs, floor slabs, landings and similar work; not exceeding 200mm thick (Horizontal or sloping). complete all as specified and directed.

Formwork to (rough finished flat surfaces of concrete ) sides and soffits of floor or roof beams, beam haunchings, girders, bressummers, lintels, cantilevers, shelves including sup- ports, overhangs, etc. also splays between floors and beams, etc.

Formwork to (rough finished flat surfaces of concrete ) edges of concrete flats, treads, breaks in floors, window cills, concrete railings, openings in concrete walls, floor and roofs n exc 20 cm wide and sides of RCC/ PCC bands in walls, horizontal or sloping and similar work exc 10cm but n exc 20cm wide . complete all as specified and directed.

M & L for ms deformed or twisted ,TMT bars 10 mm dia and above , cut to length, bent to shape required, including cranking, bending spirally for hooping, hooking ends and binding with MS wire (annealed) not less than 0.90 mm dia or securing with clips quality conforming to Fe-410-S or Fe-410 -0 ,complete all as specified and as directed.

M & L for 5 mm thick rendering in CM 1:3, finished even and smooth as in ceiling including applying three coats of white wash complete all as specified and directed.

Demolition of cement Concrete of any description and in any position not otherwise specifically provided for, complete all as specified and directed.

M & L PCC1:2:4 type B-1 (using 20 mm graded stone aggregate) as in coping or similar work etc including necessary form work complete all as specified and directed.

Taking down roof treatment any type any description on top of roof not exceeding 10cm thick including removal of rubbish out side MD and complete all as specified and directed

M&L for 40mm thick cement concrete (1:2:4) type B-0 using 12.5mm stone aggregate as in roof padding including 10mm thick screed bedding in CM 1:6 on roof slab and demolition of cement concrete of any discription complete all as specified and directed

M&L for applying roof treatment on top of roof with APP modified membrane with non woven polyester reinforcement (centre core) shall be laid by torch application method with overlap 100mm on length side and 100mm on width side including a coat of bituminous oil based primer ( IS : 3884) @ 250gm / Sqm weight not less than 3 kg/Sqm complete all as specified and directed

M&L for 15 mm thick rendering with cement mortar 1:6 finished even and smooth with out using extra cement and applying three coats of white wash including taking down old plaster complete all as specified and directed

M&L for non Skid ceramic coloured tiles 7 to 8mm thick (square/rectangular) area of each tile exceeding 0.11 but not exceeding 0.18 sqm, in floors and set and jointed in neat cement slurry and pointed in white or coloured cement to match etc. and including 15mm thick screed bed in CM 1:6 complete including dismantling old tiling all as specified and directed

M&L for glazed ceramic coloured joint free tiles of size (450x300 mm) x 7mm thick in dados skirting etc set and jointed in neat cement slurry and pointed in white or coloured cement to match and including 10mm thick plaster in CM 1:6 including dismantling old tiling complete all as specified and directed

Demolition of cement concrete ( unreinforced) ) in ground floors and pavings n exc 15 cm thickness (below or above ground level) , Complete all as specified and directed.

M & L for cement concrete 1:4:8 type D2 using (40mm graded stone aggregate) as in sub base floor concrete complete all as specified

Demolition of pre-cast PCC block walling / brick work or stone / boulder masonry including all quoins, arches, pillars, etc. built in cement mortar or cement lime mortar complete all as specified and directed

M&L for stone walling of squared rubble, regular coursed, well bonded, bedded and solidly hearted,built in cement mortar 1: 6 and including complete all as specified and directed

M & L for block masonry with solid pre-cast cement concrete blocks made out of cement concrete 1: 3: 6 type C-1, using 20 mm graded crushed stone aggregate, exc. 10 cm in width and setting in cement mortar 1 : 6 complete all as specified and directed

M&L for Rendering 15mm thick in cement mortar (1:4) on brick walls or concrete/stone walling surfaces, finished even and smooth without using extra cement and applying applying two coats of cement base paint over a coat of primer , complete all as specified and directed.

M&L for 15 mm thick rendering on fair faces of brick work or concrete surfaces with cement mortar 1:6 finished even and smooth with out using extra cement and applying three coats of white wash complete all as specified and directed.

S & F in repair high strength polythene mesh of aperture not more than 20 mm and nylon thread not less than 1.2 mm of any colour for bird proof netting to existing truss/purlin/hanger gate etc including cotton cloth border stitching, fixing arrangement like washer, clamp, fasteners, pulley etc all as specified and directed. (Note :- Rate deemed to be included by contractor for mechanical arrangements for fixing bird proofing net above 10 m height of bldgs/hangers).

M/S TANUSHREE CONSTRUCTION COMPANY

M/s Sati Jasnath Enterprises

Devi Engineeing

M.D. CONSTRUCTION CO.

Rasam Engg Co.

National Rewinding Works

Lalit and Brothers

M/s Malinath Electricals

M/S PRASHANT BENIWAL