Construction of Academic Te...

Amount

[11.5.4]12 mm cement plaster of mix : 4. 1:6 (1 cement: 6 fine sand)

[23.5.6.2]COPPER WIRING IN EXISTING PVC/MS CONDUIT PIPE SURFACE/RECESSED FOR ELECTRICAL POINTS 6.2. Wiring main and sub mains in two single core for phase and neutral wire and one single core for earth wire PVC insulated Copper conductor cable 1100 Volts grade in existing MS/PVC Conduit etc as required. 1 run of Size 2.50 Sqmm(1.1.80mm)

[23.7.6.2]PVC CONDUIT PIPE ONLY (SURFACE OR RECESSED) FOR ELECTRICAL POINTS 6.2. Supply and erection of PVC CONDUIT ISI marked (Medium) recessed in wall/ceiling etc. including the cost of PVC bends, inspection boxes, iron hooks and cement concrete etc. complete in all respect up to the entire satisfaction of Engineer-in-Charge of work. PVC pipe of 25 mm dia.

[4.32]Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundations etc. in layers not exceeding 20cm in depth, consolidating each deposited layer by ramming and watering, lead up to 50 m and lift up to 1.5 m.

[6.1.1]Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work below plinth level and up to Floor IV level: 1. 1:1½:3 (1 Cement: 1½ coarse sand (zone-III) : 3 graded stone aggregate 20 mm nominal size)

[6.30.1]Centering and shuttering including strutting, propping etc. and removal of form for 1. Foundations, footings, bases of columns, etc. for mass concrete

[7.21.2]Brick work with common burnt clay non-modular bricks of class designation 10.5 in foundation and plinth in: 2. Cement mortar 1:6 (1 cement : 6 coarse sand)

Provinding and fixing of wire mesh jali (completly painted) around the transformer made out of 75x25x rectangular sqm mesh with 3.25 mm dia wire fixed with angle iron frame made out of MS angle 50x50x6mm support of MS flat 50x6mm and fixed in CC block (excluding CC rates) including cutting, welding etc. Complete in all respect upto the entire satisfaction of the Engineer-in-charge.

Supply, installation, testing commissioning, of MS support structure with febrication and GI perforated sheet installation for for DG set and substation (area 30ftx30ft). The details are given below. 1.Minimum height of over head structure 7ft-10 ft

Supply, installation, testing commissioning, of MS support structure with febrication and GI perforated sheet installation for for metering panel (area 12ftx12ft). The details are given below. 1.Minimum height of over head structure 7ft

Supply and erection of 3 pin top 15Amp. For AC point complete with in all respect.

Agri Care Enterprises