Renovation work at Mayor Room,Depty Mayor Room,AC room partition work,AEE room partition work,Tiles work and Electrical arrangements including name board culvert in Avadi City Municipal Corporation Office in Ward no 41

Amount

Dismantling, clearing away and carefully stacking materials useful for re-use for any thickness of wall Flat & Pan Tiles or Manglore Tile over Flat Tiles without roof timbers

Brick Partition Walls using II class ground moulded chamber bricks of size 9"X43/8"X 23/4" in C.M 1:3 (One part of Cement and Three part of Crushed Stone Sand (M- Sand)) using hoop iron reinforcement,if found necessary standard specification including finishing, curing,etc., complete complying with standard specification - 10 sqm

Plastering with cement mortar 1:5 (One part of Cement and Five part of Plastering Sand (P- Sand)) 12mm, thick in all floors including cost and conveyance of all materilas to site and labour charges etc,complete as per standard specifications

Paving the floor with design Antiskirt ceramic tiles (colour and shade as directed) of size 305 mm x 305mm x 6 mm in all floors over a base layer of cement mortar 1:3 (One part of Cement and Three part of Plastering Sand (P- Sand)), 20mm thick laid in-situ and pointed with same coloured cement

Dadooing walls with Glazed tiles of sizes 305mm X 200mm X 6mm size of approved make and quality and colour Set in cement mortar 1:2 (One part of Cement and two part of Plastering Sand (P- Sand)) over 10 mm base layer plastering and pointing with white cement neatly as directed.

Supplying and fixing in position White Glazed European Water Closet of best quality and approved make with 100mm 'P' os 'S'' trap with Double flapped rigit P.V.C. seat cover with C.P. brass hinges with 12.5 litres PVC Low Level Flushing Tank with all internal fittings etc., complete complying with standard spoecifications,labor inclusive of fixing lowlevel flushing tank.

Painting two coats for Interior surface with approved Interior Plastic Emulsion paint approved quality and colour over a priming coat, including thorough scrapping, clean removal of dirt, etc complete and including necessary plaster of paris, putty, wherever required etc, complete as per standard specification.

Providing Table with Partition wall & wall panel Using wood with Various Size tongued and grooved planks including cost of all mterials and labour charges etc.,complete

Supplying and fixing in position of Alu. Anodised Partition with 62x38x2mm extruded box section at bottom vertical and horizontal members. The vertical member are spaced at 90 cm c/c and to horizontal members are spaced at 1.2M, 2.1M and 2.4M height the bottom panels should be covered with 12 mm thick PLB exterior grade and the top and middle panels should be fixed at 4mm thick glass thick glass with necessary glassing clips.rubber beading, etc., including necessary dismantling holes in RCC columns, beams masonry wherever necessary with power power drill ti the extent required and made good to the original conditions after fixing as directed by the departmental officers. All the Aluminium sections should be anodised to 1.5microns as per ISI specification 1868/1962.

SINGLE TYPE STREET LIGHT FLUORESCENT FITTING SUITABLE FOR THE ONE No. FLUORESCENT TUBE WITH COPPER CHOKE & CONDENSOR COMPLETE (4 Ft. 40 Watts Type)

LED INDOOR FITTINGS (LIGHT EMITTING DIODE) HIGHER END (24W LED 4000K 2 x 2 Square Type Recessed Fitting with LED)

Supply and fixing of Stone culvert Name board including cost of all materials and labour charges etc.,complete

Supplying and fixing of Ornamental Type White Glazed Porcelain Corner 'L' Type Wash Hand Basin of size 350mm

Wiring with 2 x 1.5 sq.mm. (22 / 0.3 ) PVC insulated single core unsheathed copper conductor cable of 1100V grade in suitable heavy gauge MS conduit pipe on wall and ceiling with MS accessories with MS switch Box and 5A FT switch with painting of suitable colour continuous earth wire connection of 14 SWG TC wire for light point / fan point (for electronic regulator)

J.Azaruddin (BID ID -1256058)