REPAIR TO COMPOUND WALL FENCING GATE AND OTHER MISC WORKS IN TECHNICAL AREA AT AF STN SIRSA

Amount

Taking down Cement Plaster including raking out Joints, hacking for Key, scrubbing down with Water and removing Debris, etc. to Outside MD/AF Land, complete all as specified and as directed.

Taking down existing barbed wire fencing of any description and from any position, complete all as specified and as directed.

Taking down old concertina coil fencing of any description and from any position, complete all as specified and as directed.

Dismantling Structural Steel or Mild Steel Work of any description including frame, truss,etc complete all as specified and as directed.

S&F for Rolled Mild steel Joist, channel, angle, or tee sections, fixed independently, without connecting Plates, etc. Confirming to Fe-410-W (Gde-E-250) quality B (cut to ordinary lengths i.e. within 20mm of the length indicated), complete all as specified and directed.

M&L for preparing New or previously untreated Steel and Iron Surfaces of any description, over 10 Cm width or girth and applying Two Coats of Synthetic Enamel Paint (First quality) over a Red Oxide Zinc Chrome Primer, complete all as specified and as directed.

S&F Galvanised 2 strand, Steel Barbed Wire 2.24mm dia Barbed with 2.0mm dia Barbs at 75mm spacings and straining and fixing to any type of Standard Rails, Straining Bolts, including securing or tying at Crossings with and provision of Galvanised Mild Steel Wire, Staples or Steel Pins, fixed in repairs, etc., complete all as specified and as directed. NOTE : Each Line of Barbed Wire will be Measured for Payment.

Fixing Steel Barbed Wire of any description (serviceable barbed Wire obtained from Item No 02 above) in the same or new location, securing or tying with and including Galvinised Iron Mild Steel wire with Angle Iron posts after Restraining including making good Staples etc , complete all as specified and as directed. NOTE : Each Line of Barbed Wire will be Measured for Payment.

S&F Concertina Coil Fencing with punched Tape Concertina Coil 900mm dia, 5 Metre Openable length, having 250mm spacing between One Round to another (Weight of 5 METRE Coil shall be 11.00 KILOGRAM), securing or tying with and including Galvanised Iron Mild Steel Wire with Barbed Wire and/or ‘Y’ shaped Angle Iron and placed at 3.00 Metre height on Boundary Walls, complete all as specified and as directed. NOTE : Unit Length of Concertina Coil will be considered for Payment after fixing in Position.

Fixing Concertina Coil of any description (obtained from item No 3 above) in the same or new location , securing or tying with and including Galvanised Iron Mild Steel Wire with Barbed Wire and/or ‘Y’ shaped Angle Iron and placed at 3.00 Metre height on Boundary Walls and along the base of boundary wall at same position or at same location, complete all as specified and as directed. NOTE : Unit Length of Concertina Coil will be considered for Payment after fixing in Position.

Demolition Cement Concrete (un-reinforced) of in Ground & Pavings. not exc. 150mm thickness (below or above Ground Level) and removing debris, etc. to Outside MD/AF Land, complete all as specified and as directed.

M&L for Rendering 10mm thick in Cement Mortar 1:4 on Brick Walls/Concrete Surfaces , plastered surfaces finished Even and Smooth without using Extra Cement, complete all as specified and as directed.

M&L for Preparing New Plastered Surfaces of Walls and applying Two Coats of Weather Coat Exterior Paint (in Camouflage pattern ) with approved Tint over a coat of Primer as per manufacturer's instructions, complete all as specified and as directed.

M&L for Rough Cast Plaster on Brick Walls consisting Under Coat of Cement and Sand Mortar 1:3 not less than 10mm thick and while it is still in Plastic state the Rough Cast Mixture consisting of Crushed Stone or Fine Gravel mixed with Coarse Sand and Cement in the ratio 1:1:1 shall be applied and finish Even, complete all as specified and as directed.

M&L for Preparing New Rough Cast Plastered Surfaces of Walls by applying Two Coats of Weather Coat Exterior Paint (in Camouflage pattern as directed ) with approved Tint over a coat of primer as per manufacturer's instructions, complete all as specified and as directed.

M&L for Preparing Old Treated/Painted (Rusted) Steel and Iron Surfaces of any description, and applying One Coat of Synthetic Enamel Paint (First quality) for Y shape Mild steel Angle Frame fixed on boundary walls (Straining /Supported to barbed Wire and Concertina Coil) with approved tint complete all as specified and as directed. NOTE: Rates quoted by the tenderer shall included with following aplications :- (a) The surfaces shall be cleaned to remove loose dirt ,paint by use of sand paper washed with alkaline soap solution in case of oil and grease,or with the help of paint removing chemicals as per manufacturers instructions.

M&L for Cement Concrete 1:2:4 (20mm graded stone aggregate), in walls or retaining walls,any thickness, size or shape including pilasters, buttresses columns, pillars, boundary pillars and posts(including caps and bases), complete all as specified and as directed.

VIVEK CONSTRUCTION CO

M/s Sheoran Brothers Builders And Engineers

Ajay Enterprises

YESH BUILDERS

shiv shanker enterprises

BS BUILDERS

DCM ENTERPRISES

Sethi Builders