Supply, Installation, Testing and Commissioning of submersible Pumping unit and NRV for WSS Khadermoh under Capex UT.

Amount

Supply, Installation, Testing & Commissioning of Submersible Pumping of Motor Rating: 15 HP Unit as per IS 8034 with following specification are as under : Discharge: 6000 GPH Head:-110 M PUMP : Efficiency = Not less than 50% Speed = 2900 Rpm Type of pump = Mixed flow. Type of fluid to be handled = Clear Water MATERIAL OF CONSTRUCTION: IMPELLER: - Impeller is of Stainless Steel the enclosed or semi – enclosed type and properly balanced. Enclosed Impellers equipped with seal rings on their hubs. Pump Shaft = Stainless Steel SS 410. Pump Casing = Cast Iron/Stainless steel COUPLING: A suitable coupling arrangement provided with pump set. Non Return Valve: - Non Return Valve of the suitable size provided above the pump discharge case. MOTOR:- Method of starting = Star – Delta/DOL (as specified) Speed = 3000 (Sync). Frequency = 50 ± 3 % Hz Working Voltage = 380-415 ± 15% V, 03 phase Efficiency = Not less than 90% Class of insulation = F/Suitable for above parameters Submersible motor should be water filled water lubricated squirrel cage type having capacity for above pumping parameters and working on 3 phase; AC supply ranging from 380 to 415 volts, 50Hz. The motor should be sealed by radial rings to avoid mixing of well water with motor filled water. a) The job includes providing and fitting of interlocking arrangement against any failure of coupling. It must be fabricated out of MS strips of suitable size and length. b) The job includes providing and fitting of appropriate size MS nipple 2 feet long threaded on one end and welded to same size MS flange of thickness (as per Table-17) at other end for column pipe as per site requirement. The threaded portion should be as per size of pumping out let for proper fixing. The job includes providing and fitting of R. I. cloth joints/rubber washers with nuts, bolts and washers for all joints of column pipe. The job also includes lowering of pumping unit in the well then proper testing and commissioning of pumping unit on full load at site. Note: Providing of test certificate & Characteristic Curve of pumping equipment is compulsory and pumping unit is to be approved from the concerned Sub Divisional office before procuring. (OEM) Original Equipment Manufacturer's Test Certificates in Original to be provided with the material before installation. The following test certificates of original manufacturer shall be furnished with puming equipment. 1. Performance Test Certificate 2. Laboratory Test 3. Overload Test 4. Insulation Resistance Test.

Providing fitting and testing of 80mm dia DI Non Return valves along with PN 16 rating flanges including transportation up to the site at site. The job includes providing of 02 number MS flanges perfectly adaptable to the in built flanges and welded to rising main as per the site requirement. The job includes P/F of nuts, bolts and gasket required for the job.

S T ELECTRICAL ENG WORKS PEERNAR TRAL

M/S AAMIR TRADERS

Rayees Electric Engineering Works