Repairing and Oil bound distempring work of 1st floor Lift/Entrance Lobby at Dr. Ram Manohar Lohiya Parikalp Bhawan, Telibagh, Lucknow. (Lot-4)

Amount

Dismantling exiting plaster including disposal of refuse as directed by Engineer-in-charge withing a distance of 60 Mtr.

Repairs to plaster of thickness 12 mm to 20 mm in patches of area 2.5 sq.meters and under, including cutting the patch in proper shape, raking out joints and preparing and plastering the surface of the walls complete, including disposal as per direction of Engineer-in-Charge. With cement mortar 1:4 (1 cement : 4 fine sand)

Scraping old white or colour wash including disposal of refuse as directed by the Engineer-in-charge with in a distance of 60 meters (P.W.D.chapter-7 item no.708 )

Providing and applying white cement based putty of average thickness 1mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete.

Wall Painting with Plastic emulson paint of Approved brand and Manufacture to give an even shado : one or more coat on old work(royal silk) asian/berger

Polishing in high gloss/matt finish melamine clear polish on wood work in required color/wooden shade texture with following process in the sequence as detailed below:

The surface to be polished is rubbed with sand paper 80/120 no. and then with sand paper of 160/180 nos.

Applying two coats of sealer with spray gun and allowing sufficient drying time for 1st coat and 2nd coat is allowed to dry for 8 to 12 hrs.

On drying of sealer coat, wet rubbing with emery cloth of finer grading with ample water to remove excess sealer layer and make the surface further smooth after this wet rubbing, then surface is applied with special grade melamine fillers to fill all the small and big holes/grooves etc. Filler coat to be allowed to dry for 4 to 6 hrs on which again a light wet rubbing is done this surface is further allowed to dry for 12 hrs.

On this, 1st coat of melamine polish is applied with spray gun using melamine clear polish and melamine thinner in required proportion. This 1st coat is allowed to dry for 24 hrs then this dry surface is again fine wet rubbed smooth, which is further allowed to dry for 12 hrs. The final melamine polish is applied with compressor pressure spray gun using melamine clear polish and melamine thinner mixed in required proportion complete as per direction of Engineer-in-Charge. (Final coat to be done in 1 or 2 layers without gap of time.)

M/S ASHOKA ENTERPRISES