Development of Canteen complex at BSF campus Yelahanka under STC BSF Bangalore.

Earth work in surface excavation not exceeding 30 cm in depth but exceeding 1.5 m in width as well as 10 sqm on plan including getting out and disposal of excavated earth upto 50 m and lift upto 1.5 m, as directed by Engineer-in- Charge:All kinds of soil

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level :1:2:4 (1 cement : 2 coarse sand (zone-III) derived from natural sources : 4 graded stone aggregate 20 mm nominal size derived from natural sources)

Providing and fixing stainless steel ( Grade 304) railing made of Hollow tubes, channels, plates etc., including welding, grinding, buffing, polishing and making curvature (wherever required) and fitting the same with necessary stainless steel nuts and bolts complete, i/c fixing the railing with necessary accessories & stainless steel dash fasteners , stainless steel bolts etc., of required size, on the top of the floor or the side of waist slab with suitable arrangement as per approval of Engineer-in charge, (for payment purpose only weight of stainless steel members shall be considered excluding fixing accessories such as nuts, bolts, fasteners etc.).

Providing and laying Vitrified tiles in floor in different sizes (thickness to be specified by the manufacturer) with water absorption less than 0.08% and conforming to IS:15622, of approved brand & manufacturer, in all colours and shade, laid on 20 mm thick cement mortar 1:4 (1 cement: 4 coarse sand) jointing with grey cement slurry @3.3 kg/sqm including grouting the joints with white cement and matching pigments etc. The tiles must be cut with the zero chipping diamond cutter only . Laying of tiles will be done with the notch trowel, plier, wedge, clips of required thickness, leveling system and rubber mallet for placing the tiles gently and easily.Glazed Vitrified tiles Matt/Antiskid finish of size Size of Tile 600 x 600 mm

12 mm cement plaster of mix :1:6 (1 cement: 6 fine sand)

Providing and fixing cupboard/counter with required size as per condition of site using 19 mm thick plywood for supporting and facing. Exposed surface of cupboard to be laminated with 1 mm thick premium make and approved quality veener lamination or equivalent of approved shade and pattern fixed with fevicol etc and all inside surfaces to be laminated with off white veener lamination of 1 mm thick (premium quality). Each cupboard to be provided with fittings and fixtures like 4 Nos SS CABINET (concealed) hinges for shutters, 2 Nos 100mm SS handles all as per directions of the Engineer-in-charge. (All plywood members to be used shall be of BWP grade of premium make and approved quality.) Note: Front surface area i.e., width x height shall only be measured for payment purpose