8220 SPL REPAIRS TO CHAIN LINK FENCING AND ALLIED WKS AND SPL REPAIRS TO BOUNDARY WALL IN FAFA ACCN AT NEW GOLIBAR MAIDAN AND SPL REPAIRS TO ROOF TREATMENT AND WINDOWS TO PBOR QTRS BLOCK No. 12 AT DCA COMPLEX UNDER GE SOUTH PUNE

Amount

Excavation in trenches n.exc 1.5mtr wide and n.exc. 1.5m in depth for foundation and getting out in soft/loose soil complete all as specified and as directed.

Returning filling in soil including spreading, levelling, watering and well ramming in layers not exc. 25cm complete all as specified and as directed.

Removing excavated material not exceeding 50mtr and depositing where directed at a level n.exc 1.5 mtr above the starting point all as specified and directed.

Demolition of cement concrete in ground floors and paving not exc 15cm thick (below or above ground level) un-reinforced complete all as specified and as directed.

M&L for PCC 1:4:8 type D-2 (using 40mm graded stone aggregate) as in foundations filling and mass concrete complete all as specified and as directed.

M&L for PCC (1:3:6) type C-1 using 20mm graded stone agg as in coping on top of wall and the like including weathering, slightly rounded or chamfered angles and throating as directed by Engr-in-Charge including use of necessary form work complete all as specified and as directed.

Demolition of brick/precast block walling built in cement mortar complete all as specified and as directed.

M & L for solid block masonary exc. 10 cm width blocks of PCC design mix Gde C-5 set in CM (1:6) complete all as specified & directed.

M&L for Walling of Random rubble masonry uncourse well bonded bedded and solidly hearted built in cement mortar (1:6) complete all as specified and as directed.

Raking out joints/pointing to stone massonery wall complete all as specified and as directed.

M&L for flush pointing to random rubble stone masonery in CM 1:4 complete all as specified and as directed.

Rendering 12mm thick in CM (1:4) on fair faces of PCC block walling, finishing the plaster surfaces even & fair complete all as specified and as directed.

Preparation of new plastered surfaces and applying two coats of cement base paint complete all as specified and as directed.

Dismantling posts or struts any section complete all as specified and as directed.

Dismantling fencing wire mesh any type complete all as specified and as directed.

S&F Hand rail, half round or other stock section, fencing post including cutting notching for wire etc flat iron fillets incl all necessary drilling bolting or riveting etc and similar work conforming to Fe-290 Ged E-165 complete all as specified and directed.

Fixing only chain link fencing including line wires any mesh size and type to any type of standards rails straining bolts including provision of binding wire complete all as specified and directed.

Supply only chain link MS galvanised fencing any size of shape complete all as specified and directed.

S&F in repir galvanised 2 strand steel barbed wire 2.24mm, dia barbed with 2mm dia brbs at 75mm spacing and straining and fixing to any type of standard rails straining bolts, incl securing or tying at crossings with and provn of galvanised mild steel wire staples or steel pins complete all as specified and as directed. (Note :- Each line wire to be measured)

M & L for preparation of new steel surface & applying two coats of synthetic enamel to steel surface of any description over 10 cm in width or girth not otherwise described over a coat of red oxide primer complete all as specified and as directed.

Demolition of stone slabs and tiles of any description or thickness in floors etc laid, bedded and painted in any mortar complete all as specified and as directed.

M&L for 75mm thick PCC (1:4:8) type D-2 (using 40mm graded stone aggregate) as in sub base / foundation complete all as specified and as directed.

M&L for coloured precast cement concrete interlocking tiles 60mm thick, of any size, conforming to IS-15658-2006 glossy finish as in floor/pavement laid on 40mm thick stone dust cushioning, laid dry to the profile over sub base/hard core filling complete all as specified and as directed.

M&L for PCC (1:2:4) type B-1 using 20mm graded stone agg as in coping and the like including weathering, slightly rounded or chamfered angles and throating including use of necessary form work complete all as specified and as directed.

Demolition of cement concrete of any description in any position in sunken floor and roof slab padding & like etc including removal of debris outside MD land and dumping ground will be sorted out by contractor at their own arrangement complete all as specified and as directed.

M & L Water proofing treatment to RCC roof slab, walls, chhajjas etc, shall be carried out as specified below including Removing of existing bitumenous tarfelt including cement screed bed and clean the surface with wire brush and washing with water to achieve the original surface of slab including removing of bitumen primer applied on slab all as spd and as directed by Engineer-in-Charge. (a) Preparing plastered surfaces of roof slab, walls, chhajjas etc, by brooming with broom sweeping free from dirt dust etc & evenly applying a coat of ShaliTex primer (solvent based bituminous primer) conforms to IS: 3384-1986 coat of ShaliTex primer @ 0.3 Kg/Sqm shall be applied on the prepared and cleaned roof surface and parapet. Ensure not to apply when temperature is less than 5° C or during foggy period. Primer shall be allowed to dry for overnight. (b) Providing and laying APP (Atactic Polypropylene polymer) 3mm thick SuperThermolay Spun bonded non woven polyester reinforced APP modified water proofing membrane, black finished reinforced with non woven polyester matt weight not less than 3.5 Kg/Sqm manufactured by STP Ltd. The laying of membrane with a 75 mm longitudinal and 100mm transverse direction overlap shall be provided.

(c) Apply SuperThermolay APP 3mm and weight not less than 3.50 Kg/Sqm thick membrane on primer, membrane shall be laid using LPG torch and sealing all joints etc . and preparing surface complete. (d) Finally applying a coat of Super Silver Shield confirmed to IS: solar reflective bituminous aluminium paint @ 0.15 ltr/Sqm on the top of membrane surfaces complete all as specified & as directed by Engr in Charge. (Make: STP Ltd or equivalent in Supremo/ Pidilite/ Fosroc) [Note : i) Work should be done by STP Ltd (OEM) /fosroc /Pidilite /Suprimo (OEM) respective applicator & work should be able to furnish stagewise on site technical reports from concerned company technologist during currency of work and entire completion of work. ii) Contractor shall submitt 10 year OEM guaranttee for water proof treatment.]

M&L for two coats of bond coat @ 0.42 Kg/Sqm for two coats to exposed concrete surface/exposed steel surface for receving concrete/plaster etc complete including cleaning of existing concrete surface and steel reinforcement if any throughly by wire brushing or using compressor air to remove dust and laitance to free from oil to receive further treatment complete all as specified and as directed. [Make : Araldite, STP Ltd (Shalibond Concrete), Fosroc as approved by Garrison Engineer ]

M&L for 10 mm thick ready mix plaster/screed bed layer in CM 1:3 on concrete surfaces including WPC & plasticizer as per manufacturer instruction ) complete all as specified and as directed. [Note : (i) Using only clean dry river sand shall be inculded in quoted rate. (ii) WPC/plasticizer will be measured & paid seperatly]

M&L for PCC 1:2:4 type B1 using 20 mm graded agg as in PCC padding in roof kerbs or mud stops, rounded and chamfered on edges and on chajjas laid over RCC surface finished even and smooth without using extra cement includng necessary water proofing chemicals complete all as specified and directed. (Note : WPC shall be measured and paid separately)

Supply only intergral water profing compound complete all as specified and as directed.

M & L for scrapping and removing old paint stains, loose material and algae- fungus growth then cleaning of surface with water using pressure washer machine then crack filling with acrylic based textured crack filler an application of one coat of primero-primer cum sealer having alkali resistence prpoperty diluted with water and mixed with bio block in ratio 5:4:1 follwed by application of two coats of modified acrylic Apex exterior emulsion paint of approved shade having silicon addditive in paint which gives five year of performance warranty complete all as specified and as diurected [Note:- (i) The work should be done by Asian paints recommended applicator and the bidder should be able to furnish stage wise on site technical reports from the concerened company technologist. (ii) rate quoted shall inclusive to carry out repair of plaster in CM 1:4 to match the existing thickness of surfaces including taking down plaster in patches not exc 1.00 sqm as directed. (iii) Rate quoted shall deemed to be inclusive of necessary scaffolding / security measures as the work is to be carried out for elevated height up to 12 Mtr height building.]

Pruning of vegetation and plants growth on the external wall surfaces/roofs and applying Hydrochloric acid on the left over root portion and making good disturbed portion with CM 1:4 or PCC 1:2:4 grouting and finished with two coats of cement base paint to match the existing colour shade complete all as specified and as directed. (Note : Rates to be inclusive of necessary scaffolding up to G+3 height.)

Taking up or down carefully steel tubing and connection s including cleaning for refixing or removal to store of following size :-

15mm bore

20mm bore

Refixing old steel tubing and connections (concealed) in new or old postion (wall/floor/ceilings etc) of following size:-

15mm bore

20mm bore

S&F GI tubing "medium grade" galvanized with all fittings and fixed complete to walls and ceiling or laid in floors etc (concealed type) of following size :-

15mm bore

20mm bore

Taking down /cutting steel windows shutter by means of gas cutter without disturbing of soffit / jambs / cills etc of any description not exc 1.5 sqm (without taking off Guard bar) complete all as specified and as directed.

S & F glass ventilators louver type using 4 mm thick plain/tinted glass, and using following aluminium powder coated sections conforming to catalogue of 'JINDAL' or of equivalent make and rubber beading etc complete all as specified and directed. SP 20048 Glazing Clips 19352

S & F three track sliding window with two or more shutter with 4 mm thick tinted as approved glass, one shutter using stainless steel wire cloth 0.36mm nominal dia & 1.18mm width aperture for mosquito proofing with good quality bearing, handle, lock, rubber beading and glazing clips etc using following aluminium powder coated sections conforming to catalogue of 'JINDAL' or of equivalent make complete all as specified and directed by Engr-in-Charge:- (a) Bottom frame 20620 (b) Top frame & vertical 20621 (c) Handle (side) 20606 (d) Shutter inter lock 20724 (e) Shutter top & bottom 20844 (f) Glazing Clip 19352

Dismantling floor, hearth or wall tiling incl cement mortar bedding but not backing removing rubbish off the premises complete all as specified and as directed.

M&L for coloured Ceramics tiles 450x300x7to8mm thick in vertical surfaces such as skirting dado set & jointed in neat cement slurry and pointed in white or coloured cement to match the colour of tiles over and including 15mm thick rendering in cement mortar 1:4 on stone / brick/ concrete masonry surfaces complete all as specified and as directed.

M&L Non skid ceramic colored tiles 7 to 8mm thick, (square/ rectangular) area of each tile exceeding 0.18 Sqm but not exceeding 0.38 Sqm in floor etc.set and jointed in neat cement slurry & pointed in white or coloured cement to match including 15mm thick screed bed or bedding layer as in CM 1:6 complete all as specified and as directed.

Dismantling water tanks of capacity exc. 250 Ltrs and not exc. 500 ltrs removing to stores complete all as specified and as directed.

S&F rotational three layer moulded polythylene water storage tanks of (cylindrical vertical with colsed top) hoisted and fixed in postion all as spd and directed of 500 ltrs capacity incl 15 mm dia brass float incl tank nipple complete set of ISI marked complete all as specified and as directed. (Make : Polycon / Leader / Ashish)

Taking down cement plaster including hacking down etc complete all as specified and as directed.

M&L for rendering 15mm thick cement plaster 1:4 on concrete surfaces using water proofing compound of 3% by weight of cement with sponge finish complete all as specified and as directed. (Note :- WPC shall be measured and paid separately)

M&L for 5mm thick plastering in CM 1:3 on concrete surfaces of ceiling finished even smooth without using extra cement complete all as specified and directed.

M&L for 10mm thick plastering in CM 1:6 on concrete on fiar faces of bricks or concrete surfaces finished even smooth with thin layer of sagol finish complete all as specified and directed.

M&L for new palstered surface of wall and applying two coats of oil bound distember over a coat of primer including applying 3mm thick wall care putty complete all as specified and as directed.

M&L for new plastered surface of ceiling and applying two coats of white wash complete all as specified and as directed.

Anand Trading Co

M/s.BAJRANG CONSTRUCTION

Raj Construction Company

M/S Sandeep Enterprises

Gauri Associates

TAKSHASHILA ELECTRICALS

M/S DSSK ENGINEERING AN DCONSTRUCTION

MANISH VEDPRAKASH ARORA