Renovation of car parking shed area near General Branch in UHS Rohtak

Amount

Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift up to 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m.:- All kinds of soil. (HSR 4.14.1)

Dismantling roofing including ridges, hips, valleys and gutters etc., and stacking the material within 50 metres lead of:- G.S. Sheet (HSR 5.15.1)

Dismantling steel work in built up sections in angles, tees, flats and channels Including all gusset plates, bolts, nuts, cutting rivets, welding etc. including dismembering and stacking within 50 metres lead.(HSR 5.33)

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work below plinth level and up to Floor IV level:- 1 :2 :4 ( 1 Cement : 2 coarse sand (zone-Ill) : 4 graded stone aggregate 40 mm nominal size) (HSR 6.1.3)

Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length up to 12 metre or as desired by Engineer-in-charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete up to any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.(HSR 9.33)

Providing and fixing on wall face Unplasticised Rigid PVC rain water pipes conforming to IS : 13592 Type A, including jointing with seal ring conforming to IS : 5382, leaving 10 mm gap for thermal expansion, (i) Single socketed pipes.:- 150 mm diameter (HSR 9.57.3)

Cement Concrete 1 :8:16 Flooring:- Cement Concrete 1:8:16 with stone aggregate 40 mm size in foundation and plinth.(HSR 10.100.2)

Steel work welded in built up sections/ framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required:- In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works (HSR 13.29.2)

Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete.:- Hot finished welded type tubes (HSR 13.30.1)

Constructing brick masonry road gully chambers as per standard drawings (as per sizes given below) including dressing of beds and sides of chambers to exact profiles, 15cm thick lime concrete 16:24:100 (as per specified in item No.10.6) in foundations 1st class brick work laid in cement sand mortar 1 :5, 40 mm thick cement concrete 1 :2:4 topping inside the chamber with a floating coat of 1.5mm thick neat cement laid in one operation to the topping, the entire inner surface of the chamber rendered with neat cement not less than 12mm in thickness of 1 :2 cement sand plaster and finished with floating coat of neat cement 1 mm thick left absolutely smooth polished and correct to templates including labour for fixing the C.I. road gully grating and frame including painting with coal tar (as Specified in item No. Item 21.48) complete to the requirement of the Engineer in-charge.(HSR 21.87)

21.87.1:- Single road gully chamber

21.87.1.2:- Size.-610 mmx457 mmx1105mm

N.S Recovery items Civil work

Bidders have to quote rates for recovery items at least or more than reserve price. The rates quoted against recovery items will not be included in the total amount, rather it will be deducted while calculating financial statement of the agency.

Recovery of old steel (pipe, angle etc.) & GS sheet.(N.S) The reserve price of the dismantled material is as under:- @ Rs. 20/- per kilo gram.

The Hardik Co-op L AND C Society Ltd