General Fund 2025-26

Supplying and erecting in position of following liters capacity Industrial Model Reverse Osmosis Water-cum- Purifier to deliver Potable Water with World Health Organisation (WHO) Standards with following accessories. (a) MS Skid - 1 No. (b) Media 11054 No. Vessel with 20 nb Multiport Valve (with Media Pubble and Fine Sand and Activated Carbon Filling) set (c) Feed Pump 0.50 HP – 1 No. (d) Vertical Pump 2-9, 2.00 HP / Single Phase – 1 No. (e) Membrane 40 x 40 filmtech (or) equilaents / Osmonic (USA) - 1 No. and Membrane Pressure Vessel 40 x 40 -1 No. & Pressure Gauge - 2 Nos. (f) Flow Meter - 1 No. 20 Filter with Housing - 1 No., Low Pressure Switch - 1 No., Level Switch - 1 No. & Necessary CPVC Pipes and Fittings.The system shall be provide with Two Panel Control System with necessary Stainless Valves and Fittings and Float Control etc. The rate should be inclusive of all civil works, wherever necessary to install the System in position and intact.

Supply,delivery and fixing of Monoblock 1HP motor including all cost etc complete., as directed by department officer

Supply and delivery and fixing of HDPE tank as per IS 12701 / 1996 including loading, unloading, transportation and labour charges for fixing of the GI pipes and specials for pipe connection works including cutting, threading and fixing charges etc.,

Internal Water Supply - P.V.C. Pipes (6Kg/SqCm) Supplying laying and jointing P.V.C pipes (6Kg/SqCm) of approved quality and best variety conforming to I.S.S & with I.S.I mark, of the following sizes including cutting , Fixing to PVC specials using Adhesive but excluding cost of such specials and fixing to wall with necessary teak - Wood Plugs,PVC Clamps and screws,making holes on the wall or drilling holes in roof and making good the dismantled portions to original condition with necessary brick work and plastering wherever necessary with necessary scaffolding charges. 20mm PVC Pipe

20mm PVC Elbow

20mm PVC Tee

32mm pvc pipe

Supply and fixing of MS Chair (3 seat) including all cost etc complete.,

Supply and fixing of 20lit capacity tilting type stainless steel garbage bins in park area as per the site condition and as directed by the departmental officers.

Supplying and fixing of Double Swing of height 2.40m height with 40mm dia M.S. pipes support as legs and top bar is 50mm dia. The seat is 9mm thick reinforced rubber with Antiskid chequred top with heavy ball bearing and the suspension is 7mm dia electro galvanized chain and the cost shall inclusive of all materials, labours and fixing etc, complete as directed by the departmental officers.

Supplying and fixing of Two seater SeeSaw for below 12 years old childrens to a height of 0.50m with 50mm dia leaver and 40mm top bar with M.S. Pipes. The seater is of moulded plastic with heavy duty bush bearing. The cost shall inclusive of all materials, labours and fixing etc, complete as directed by the departmental officers.

Supplying and fixing of Slide for below 12 years old childrens to a length of 3.00m with 80mm dia leaver and 40mm top bar with M.S. Pipes. The seater is of moulded plastic. The ladder frame is made up of 25mm M.S.Pipe, hanrail 20mm dia M.S. Pipe and the centre support is 80mm dia M.S. Pipe The cost shall inclusive of all materials, labours and fixing etc, complete as directed by the departmental officers.

Providing Three Seater arrangements with Ready made Granite benches 20mm thick Slab with 1500mm wide , 600mm height. The cost shall include all labour and materials and as directed by the departmental officers.

Supplying and fixing in position of Alu. Anodised Partition with 62x38x2mm extruded box section at bottom vertical and horizontal members. The vertical member are spaced at 90 cm c/c and to horizontal members are spaced at 1.2M, 2.1M and 2.4M height the bottom panels should be covered with 12 mm thick PLB exterior grade and the top and middle panels should be fixed at 4mm thick glass thick glass with necessary glassing clips.rubber beading, etc., including necessary dismantling holes in RCC columns, beams masonry wherever necessary with power power drill ti the extent required and made good to the original conditions after fixing as directed by the departmental officers. All the Aluminium sections should be anodised to 1.5microns as per ISI specification 1868/1962.

Supplying, fabricating and fixing in position of Alumi.Anod.natural colour matt finish door half glazed and half PLB board using 12 mm thick PLB board and 5.5 mm thick glazed door using rectangular Alu.Box section of following sizes for frame and shutter with necessary accessories such as rubber beading, Al. Clips, Best double action floor springs, Aluminium Handles on both sides,floor stopper,Tower bolt, Locks and glass including all materials, Labour, power consemption charges required for fabrication if necessary chipping, dismantling making necessary holes in RCC Coloums, Beams or Masonry wherever necessary with power drill to the extent required and made good to the original conditions after fixing etc.,complete. The Alumi. surface must be anodised with matt finish under electrically controlled condition in accordance with IS specification 1868 / 1962 of Anodic filthickness of not less than 15 Microns (Fifteen) for all sections.

Supplying and fixing in position White / Colour Glazed Model Floor Mounted European Water Closet of best quality and approved make with 100mm “P” or “S” trap connecting with CI pipe of 100mm dia / PVC pipe of 110mm dia, double flapped rigid PVC black seat and seat cover with CP brass hinges including cost of white cement, cement for packing, spun yarn, teak wood plugs, brass screws, etc., including supplying and fixing 10 litres capacity PVC / 12.5 litres capacity porcelin low level flushing tank with a pair of CI brackets, etc., complete with all fittings, such as, 15mm brass ball valve with polythene float with brass handle, union coupling connected by means of 40mm white PVC flush hand using indian adopter joint including all internal fittings, such as, 15mm bras connections, 15mm GM wheel valve, 15mm brass nipple (2 Nos.), 15mm nylon connection, TW plugs, screws and also giving necessary connection to the PVC pipe and painting the CI brackets with 2 coats of approved paint over one coat of red oxide primer, dismantling the masonry and re-doing the dismantled masonry to original condition, etc., complete complying with standard specifications. (The EWC and flushing tank with all accessories should be got approved by the Executive Engineer before use on works) Floor Fitting

Supply and Erection of CCTV in the following items. Armoured LAN cat-6 cable Armoured LAN cat-6 cable (PWD SOR page no:153)

POE switch for camera - 8 port (PWD SOR page no;154)

Hard disk for NVR 6 TB (PWD SOR page no;155)

Net work video record for CCTV16 Channel - 2 SATA (2 Nos. Hard Disk) (PWD SOR page no;154)

CCTV 6mp Pullet Camera(as per Quatation)

Rack with Accessories 6U Rack (PWD SOR page no;155)

I/O SOKET RJ 45 (PWD SOR page no;155)

I/O SOKET RJ 11 (PWD SOR page no;155)

32" Sony LED TV(as per Quatation)

Supply and Fixing CCTV Camera Outdoor Box(as per Quatation)

Supply and Fixing POE Switch for Outdoor Box(as per Quatation)

Supply and Fixing of CCTV Camera installation ,cable laying and network commsioning charges etc..,Complete including all labour Chargers.(as per Quatation)