Loading
Loading…
Loading…
Tender Value
₹7.1 Cr
EMD Value
₹14.1 L
Closing Date
1 Jun 2026, 3:00 pmClosed
No
No
Single Packet System
Normal Tender
No
Not Applicable
Lowest to Highest
60 days
Expenditure
Revenue
FRTENHM
13 conditions · 2 needing a document upload
The tenderer must have minimum average annual contractual turnover of V/N or 'V' whichever is less; where V= Advertised value of the tender in crores of Rupees N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover.
The tenderer must have successfully completed or substantially completed any of the following during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: Three similar works each costing not less than the amount equal to 30% of advertised value of the tender, or Two similar works each costing not less than the amount equal to 40% of advertised value of the tender, or One similar work each costing not less than the amount equal to 60% of advertised value of the tender. Definition of similar Work: "Providing any electrical welding services similar to coach/wagon body repairs OR Fabrication and installation works involving welding on rolling stock in workshops, Production units, Diesel/Electric sheds in Indian Railways OR Fabrication and installation works involving welding in public sector under takings like BHEL, APSRTC, CONCOR etc."
6 conditions · 4 needing a document upload
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.
(1)Tenderers should attach self attested copy of PAN CARD & Photo Identification in Support of their IDENTITY. (2)The documents attached to the tender document should be clear and legible for evaluation of tenders. Proper care to be taken in this regard.
The rates quoted against Item Nos. 47 & Item No. 48 of Annexure H (Schedule of Estimated Rates & Quantities) shall not be less than the minimum wages, inclusive of PF and ESIC contributions, payable for the prescribed manpower, i.e. 03 unskilled and 02 unskilled staff, as per the latest minimum wages notified by the Chief Labour Commissioner (Central) from time to time. Any quoted rate found to be less than the applicable minimum wages shall render the bid liable for rejection / disqualification.
Repair, Maintenance and Housekeeping activity at Gonda Sickline & Freight Yard for two year.
01-2026-Mech-FRT-DM
01-2026-Mech-FRT-DM
Open
Works - General
24 Months
Lucknow, Uttar Pradesh
₹0
₹14.1 L
1 Jun 2026
8 May 2026
18 May 2026
97 items across 1 schedule
| # | Description | Unit | Qty | Rate | Amount |
|---|---|---|---|---|---|
| — | — | — | 7,06,84,393.41 | ||
| — | — | — | 33,46,000 | ||
| Cutting / Welding / Repair / fitment of body panel, roof patch / floor | — | 20000.00 | — | — | |
| — | — | — | 2,34,91,863.15 | ||
| Repair of wagon body doors (LH/RH/FD) | — | 279965.00 | — | — | |
| — | — | — | 1,36,346.73 | ||
| Stripping and Fitment of wagon body doors(LH/RH) | — | 533.00 | — | — | |
| — | — | — | 1,10,134.64 | ||
| Fitment of new wagon body doors Flap on need basis | — | 266.00 | — | — | |
| — | — | — | 3,11,109.12 | ||
| Dismantling & fitting of draft gears and CBCs of all types of wagon including Huck bolting / riveting in support plates. [1 Nos. Wagon = 2 Sets] | — | 504.00 | — | — | |
| — | — | — | 2,68,992 | ||
| Dismantling and fitting of Centre pivot of all types of wagon in Numbers | — | 900.00 | — | — | |
| — | — | — | 10,07,988.96 | ||
| Making water tight with Putty / Epoxy Sealant on wagon roof, side wall, end wall; gaps, Welding joint etc. in Metre | — | 6728.00 | — | — | |
| — | — | — | 13,25,096 | ||
| Welding of Wagon under frame safety brackets & minor welding | — | 58400.00 | — | — | |
| — | — | — | 1,28,648.52 | ||
| Knuckle pin replacement with APD | — | 3276.00 | — | — | |
| — | — | — | 43,000.65 | ||
| Striker casting wear plate replacement | — | 1095.00 | — | — | |
| — | — | — | 22,776.6 | ||
| Side bearer pad replacement | — | 580.00 | — | — | |
| — | — | — | 8,02,416 | ||
| EM pad changing | — | 23360.00 | — | — | |
| — | — | — | 10,35,936 | ||
| Brake Block attention (involving brake block replacement, key replacement etc.) in Set | — | 52800.00 | — | — | |
| — | — | — | 1,29,21,156 | ||
| Door opening/closing & Securing [1 Door = 2 Swing + 1 flap] | — | 877200.00 | — | — | |
| — | — | — | 4,02,748.3 | ||
| Retro-fitment of twin pipe system in BCN Wagons (Material scope- Railway) | — | 365.00 Per | Wagon | — | |
| — | — | — | 75,267 | ||
| Replacement of Distributor Valve, Common Pipe Bracket, Control Reservoir | — | 180.00 | — | — | |
| — | — | — | 16,884 | ||
| Replacement of Brake Cylinder | — | 120.00 | — | — | |
| — | — | — | 3,32,947.06 | ||
| Replacement of Cut off Angle Cock & Hose Coupling | — | 2491.00 | — | — | |
| — | — | — | 35,778 | ||
| Replacement of Slack Adjuster Barrel | — | 150.00 | — | — | |
| — | — | — | 3,814.5 | ||
| Replacement of Automatic Pressure Modification | — | 30.00 | — | — | |
| — | — | — | 2,504 | ||
| Replacement of Isolating cock with/without vent | — | 50.00 | — | — | |
| — | — | — | 2,03,061.6 | ||
| Replacement of Double foot step | — | 2160.00 | — | — | |
| — | — | — | 2,18,052 | ||
| Cost for Lock Bolting of Draft gear/CBC support plate, C.P.Top/Bottom, door check spring, Striker casting/ Back stopper | — | 10800.00 | — | — | |
| — | — | — | 5,31,900 | ||
| Riveting (Quantity unit "per Unit " is treated as per rivet) | — | 3600.00 | — | — | |
| — | — | — | 94,105.2 | ||
| Replacement & fitment of Door check spring @ 2 per wagon | — | 2040.00 | — | — | |
| — | — | — | 52,104 | ||
| Replacement & Fitment of door Hinge Foot with door hinge pin For Flap Door of wagon @ 20% | — | 240.00 | — | — | |
| — | — | — | 85,900.32 | ||
| Replacement of striker casting (i) Cutting of yoke pin support plate lock bolts (ii) Dropping of yoke pin support plate (iii)Removing yoke pin & Dropping of coupler body N(iv) Cutting of lock bolts of striker casting and dropping of striker casting (v) Fitment of new striker casting with lock bolting (vi) Re-fitting of coupler body & yoke pin (vii) Lock bolting in yoke pin support plate (viii)Replacement /repair of Operating handle /bearing piece/ bracket. Note-Striker casting and lock bolts will be supplied by railways. | — | 48.00 | — | — | |
| — | — | — | 28,97,749.6 | ||
| Lifting of Wagon body and Stripping of bogie components (Body lifting, Trolley shifting, Wheel shifting) as per detail scope of work wagon | — | 2920.00 Per | Wagon | — | |
| — | — | — | 17,38,976.8 | ||
| Lowering of wagon body over trolley (After repair work) (Body lowering, Trolley shifting, Wheel shifting & fitting of shackle lock, CP Washer, lock pins & APD) | — | 2920.00 Per | Wagon | — | |
| — | — | — | 8,54,187.6 | ||
| Side bearer wear plate changing | — | 2190.00 | — | — | |
| — | — | — | 1,91,960.8 | ||
| Push rod and brake beam safety bracket | — | 1460.00 | — | — | |
| — | — | — | 81,567.36 | ||
| Fitment of deficient hopper doors in BOBYN wagons | — | 96.00 | — | — | |
| — | — | — | 23,990.4 | ||
| Minor door repairs of BOBYN wagon | — | 240.00 | — | — | |
| — | — | — | 14,98,799.5 | ||
| Brake van side looking glass replacement | — | 3650.00 | — | — | |
| — | — | — | 46,128 | ||
| Changing of western commode in brake van | — | 200.00 | — | — | |
| — | — | — | 21,13,291.6 | ||
| Wheel changing work (Removal of wheel from wagon and fitting of turned wheel in wagon ) | — | 2920.00 | — | — | |
| — | — | — | 8,56,656 | ||
| Fitment of shackle lock "Quantity treated as per unit set" | — | 10800.00 | — | — | |
| — | — | — | 2,11,100 | ||
| Fitment of side frame key "Quantity treated as per unit set" | — | 10000.00 | — | — | |
| — | — | — | 21,17,000 | ||
| Garden development (Sub Head CPWD 2.0/2@ 46'41 (IN sqm.) | — | 1460000.0 0 | — | — | |
| — | — | — | 2,59,128 | ||
| Supply of RIVIT GUN MACHINE | — | 2.00 | — | — | |
| — | — | — | 16,49,640 | ||
| Supply of HUCK BOLT MACHINE make -AVLOCK , CRIMPWELL | — | 2.00 | — | — | |
| — | — | — | 35,21,520 | ||
| Cleaning of ROH shed and adjoining Area (36000 Sq.Meter per day) | — | 730.00 | — | — | |
| — | — | — | 2,33,600 | ||
| Cleaning of offices and rooms (2000 Sq. Meter per day) | — | 730.00 | — | — | |
| — | — | — | 85,410 | ||
| Cleaning of Toilets ( approx 300 Sq.Meter per day) | — | 730.00 | — | — | |
| — | — | — | 5,89,110 | ||
| Rag Picking, Grass Cutting ,Scrap Collection in Bins at Yard (16140 Sq.Meter per day) | — | 730.00 | — | — | |
| — | — | — | 19,60,488 | ||
| Stencilling of wagon details on both side of wagons as per scope of work. (Item Qty. is number of wagons) | — | 14600.00 | — | — | |
| — | — | — | 16,48,537.1 | ||
| Assistance in Air brake testing & repair work. (Required @ 03 Staff) | — | 730.00 | — | — | |
| — | — | — | 10,99,022.3 | ||
| Assistance for scrap removal & warranty segregation work in number (Required @ 02 Staff) | — | 730.00 | — | — |
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
HTML
nit.pdf
NIT
TDGondaSicklineyardmaintenance.pdf tender docuemnt
ATTACHMENT
TDGondaSicklineyardmaintenance.pdf
ATTACHMENT
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .