REPAIR TO CERTAIN FOOTPATH, CULVERTS, FENCING AMD MISC WKS UNDER AGE B/R-II AT BB CANTT, SRINAGAR

Amount

M&L for dismantling posts or struts (wood, steel or RCC), any section, including taking out embedded portion and making good disturbed ground; posts embedded in concrete, brick work, masonary complete all as specified and directed.

M&L for dismantling fencing wire mesh, any type complete all as specified and as directed.

M&L for cement concrete 1:2:4 type B-2 using 40mm graded stone aggregate in foundations, filling and mass concrete complete all as specified and directed.

M&L for mild steel work conforming to Fe-290-0 GdeE-165 complete. in nosing to steps including embeding in concrete and screwing etc, wind ties for roof including securing bolts, posts & struts in fencing including cutting top to shape as directed, drilling holes, notching for wire, etc; flat iron fillets (for securing wire mesh etc) including all necessary drilling, bolting or riveting complete all as specified and directed.

Supply only Chain link MS galvanisd fencing, any size or type complete all as specified and directed.

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provision of binding wire complete all as specified and directed.

M&L for Mild steel bolts, purpose made, with hexagonal or square head at one end and screwed the other, or screwed both ends; each screwed end to be fitted with washers and one hexagonal or square nut, exceeding 30 cm long and dia of neck exceeding 12 but not exceeding 20mm complete all as specified and as directed.

M&L for Galvanised, 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm to 80mm spacing and straining and fixing to any type of standard rails straining bolts, including securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins complete all as specified and directed.

M&L for Preparation of newly steel surface exc 10 cm width or girth and applying two coats of synethic enamel paint over a coat of red oxide primer complete all as specified and directed.

M&L for Mild steel round bars conforming to Gde I (IS: 432 part-I) 10mm dia and over as reinforcement for concrete, cut to length, bent to shape required, including cranking, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia complete all as specified and as directed.

M&L for RCC ( 1:2:4) type B-1 using 20mm graded stone aggregate in slabs supported on walls, beams & columns in floor roof, landing complete all as specified and directed. (reinforcement to be measured separately).

M&L for Form work to soffits of suspended slabs such as roof slabs, floor slabs, landings and similar work; not exceeding 200mm thick, for rough finished flat surfaces of concrete complete all as specified and as directed.

M&L for Mild steel TMT bars 10mm dia and over as reinforcement for concrete, cut to length, bent to shape required, including cranking, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia complete all as specified and directed.

M&L for Demolition of brickwork/stone boulder masonery built in cement or cement lime mortar complete all as specified and as directed.

M&L for brick work with sub class - B bricks , straight or curved on plan exc 6m mean radius built in C M 1:6 complete all as specified and as directed.

All as per ser item No 15 above but except brick complete all as specified and as directed.

M&L for walling of random rubble masonry built in cement mortar 1:6, uncoursed, well bonded, bedded and solidly hearted and pointed flush the surface in contact with earth in the same mortar as the work proceeds including necessary weep holes at 2 metre centre to centre (Staggered) as in retaining wall, complete all as specified and directed.

All as per ser item No 17 above but except stone complete all as specified and directed.

M&L for demolition of cement concrete (unreinforced) in ground floors and paving not exceeding 15cm thickness (below or above ground level) complete all as specified and as directed.

M&L for cement concrete 1:4:8 type D-2 using 40mm graded stone aggregate in foundations, filling and mass concrete including sub base of floors complete all as specified and directed.

M&L for Chequered cement concrete tiles with grey cement and pigments 200mm x200mm x 25mm thick, set, jointed and pointed in neat cement slurry in floors incl 15mm thick screed bed in cm 1:4 complete all as specified and directed.

M&L for machine pressed precast concrete with grey cement and no pigment interlocking paver block any shape and size conforming to IS 15658-2006 of 60mm thickness M-35 Grade incl 50mm thick sand cushioning for laying of paver tile complete all as specified and directed.

M&L for taking down cement plaster of any description on brick or stone walls etc including racking out joints hacking for key scrubbing down with water etc complete all as specified and directed.

M&L for rendering 15mm thick plaster in cement mortar 1: 4 with water proofing compound on other than fair faces of brick work or concrete surfaces with water proofing compound,finished even and smooth without using extra cement finished fair and even complete all as specified and directed.

M&L for repration of new plaster surfaces of wall and applying two coats of cement based paint over a coat of alkali resistant cement base primer on wall surfaces complete all as specified and directed.

M&L for cement concrete 1:2:4 type B-1 using 20mm graded stone aggregate in cills, seismic and other similar bands, plinth courses, copings, bed plates, bond stones, etc including weathering, slightly rounded or chamfered angles and throating as directed including necessary form work complete all as specified and as directed.

M&L for raking out joints/pointing to random ruble masonry in cement mortar 1:4 complete all as specified and directed.

M&L for extra over stone walling for hammer dressing to face stones and dressing of face beds and joints, as specified, of random rubble walling, uncoursed or brought upto courses complete all as specified and directed.

M&L for precast reinforced cement concrete 1:2:4 type B-1 using 20mm graded stone aggregate in cover slabs (for manholes etc), shelves and similar articles with plain faces including necessary moulds and setting in cement mortar 1:4 complete all as specified and directed. (reinforcement to be measured separately)

M&L for cement concrete 1:2:4 type B-0 using 12.5mm graded stone aggregate in cills, seismic and other similar bands, plinth courses, copings, bed plates, bond stones, etc including weathering, slightly rounded or chamfered angles and throating as directed including necessary form work complete all as specified and directed.

M/S NORTHERN ELECTRICAL WORKS

M/S MIRCO CONSTRUCTION CO

M/S Ghulam Mohammad Shalla

M/S PARVEZ AHMAD LONE

M/S Vivek Gupta and Co

M/S Shah Raouf

M/S Paradise Constructions