PROVN OF 10 SECURITY LIGHTS ALONGWITH POLES, WIRING AT T-16andT-18 (JCO MESS), LIGHTING CONDUCTOR OF BN MAGAZINE AT OLD ILP LOC OF 82 ARMD REGT, 11 GEYSERS FOR SINGLE OFFR ACCN OF 124 INF BDE CAMP AND 01 SHADOWLESS LIGHT OF OPERATION THEATRE AT MH

Amount

Taking down carefully aluminium point wiring any type including battens if any except for ceiling or where not feasible for light/Fan/Bell/Socket or power and including unscrewing from board, fitting and fixure such as switches, socket, ceiling rose, lamp holder, pendants, bracket and regulator etc and removing material from site including making good disturbed surface to match with the existing surface complete all as specified and directed.

Taking down Aluminuum sub main wiring including GI earth wire and making good disturbed surfaces to match with the existing surface roof/wall/floor complete all as specified and as directed.

M&L for sub main wiring with two single core FR 6 Sqmm copper conductor PVC unsheathed cable medium grade including PVC conduit (Appropriate size) concealed in wall for sub main connection including FR 2.5 Sqmm PVC insulated multistraded unsheathed copper conductor used as a earth wire to common earth and connection to earth dolly all as specified. (Note :- Two runs of 6 Sqmm and one run of 2.5 Sqmm copper conductor shall be measured as one unit lenght i.e Phase, Neutral, Earth)

M&L point wiring with FR 1.5 Sqmm multi strande PVC insulated and unsheathed copper conductor cable in and including surface caping and casing complete with 1.60 mm thick pressed steel concealed terminal boxes and with top cover 2.80mm thick ISI markded plastic laminated hylum sheet of reqd colour fixed with brass screws and cup washers painting terminal boxes inside and out side with one coat red oxide primer complete with all accessories and all as specified including FRLS1.5 Sqmm PVC insulated unsheathed multistranded copper conductor to common earth and connected to earth dolly for following. Note : (i) All wiring cable shall be multi sttranded FR Copper Conductor of approved make duly approved by accepting officer before incorporting. (ii) Colour Code as per IS to be follow for wiring. (iii) Same size of conducor use in any type of wiring (Phase/nutral/earth conductor should be of same size.

(a) One light/fan/bell/exhaust fan point controlled by one switch.

(b) One 5 Pin 5 Amp switch socket out let point on same board.

All as per serial item No 4 here in before but for one 5 Amp 5 Pin switch socket out let independent with 2.5 Sqmm FR (Nominal Area) PVC unsheathed copper conductor single core multistranded complete all as specified.

All as per serial item No 4 here in before but for one 15 Amp 6 Pin switch socket out let independent with 4 Sqmm FR (Nominal Area) PVC unsheathed copper conductor single core multistranded, complete all as specified and directed.

S&F sheet metal enclosure for double door DBs for using MCBs single pole and neutral 8 way with 200 Amps rated busbar 240 Volt all as specified and directed.

S&F Isolator double pole 40 Amp 240 Volt

S&F MCB single pole 6 to 32 Amp 240 Volt 'B' curve 10 KA complete all as specified and directed

S&F switch piano flush type 5 Amp single pole one way complete all as specified and directed.

S&F switch socket combinations flush 5 Amp 5 Pin complete all as specified and directed.

S&F switch socket combination out let 6 Pin 2 in 1 5/15Amp flush type 240 Volt complete.

S&F socket out let 2 in 1, 3 Pin, 5Amp flush type

S&F ceiling rose surface bakelite 65x50mm three terminal AC 230 volts complete all as specified and directed.

S&F flexible wire twin core copper conductor of size 23/.0076 for flourescent tube light fitting/fan up to 1.00 mtr all as specified and directed

S&F Electronic regulator step type 450 watt 230 volt 50 C/S/ complete all as specified and directed.

T/D the existing ceiling fan and Refixing the same complete all as directed.

S&F in replacement LED Tube Light fitting 18 W Energyefficient. Box type Epoxy powder coated CRCA sheet housing, electronic ballast, Bipin Holder, connector Block, etc complete tube rod & including connecting up with twin core twisted flexible copper conductor cable of suitable size all as directed. Make Havells/Bajaj/Philips.

S&F PVC condiut of size 20 mm dia

Supplying and fixing 1100 Volts grade heavy duty cable PVC insulated aluminium conductor served with inner sheathing of PVC tape and overall PVC sheathed in service connecion suspended by insulating hangers not more than 1 mtr apart including 4 mm suspension wire, one twin core cable flator with stranded conductor using 6 Sqmm of size aluminium conductor in 2 mm.

S&F LED post top Lantran for 1x35 W Cat Part No HPLLEDPCR35W Clear acrylic cover mounted on castaluminium capsule finished in powder coated black crompton/Bajaj/HPL.

Excavation in tranches not exceeding 1.5 Mtrs wide and not exceeding 1.5 Mtrs in depth for laying of cables including gettingout in any kind of soil complete all as specified and directed.

Returning filling in including spreading, leveling, and well ramming in layers not exceeding 25 Cm each layers of any kind of Soil.

Removing surplus excavated material from site not exceeding 50 Mtrs starting point and depositing at level not exceeding 1.5 Mtr above the starting point.

Supplying spreading punning sand for cushioning to cable 8 cm below and 15 cm above the cable in trenches complete all as specified and directed. Note :- Punnedthichness will only be measured.

S&F for old size brick well burnt laid flat for cable protection complete all as specified and directed.

S&F galvanised iron, tubes medium grade ISI marked 32 mm dia make Jindal/Tata or equivalent.

S&F XLPE cable insulated, armoured heavy duty electric cable with aluminium conductor, 1100 Volts grade, cross sectional area 10 Sq mm 2 Core

S&F in replacement of unserviceable recess surface mountin LED CRCA Surface Panel Light 2' x 2' (600mm x 600mm) CW, 36 Watt coated CRCA sheet steel housing metllic frame Make Bajai/Philips/HPL.

Supply and fix steel tubular swaged poles type 410 SP-31 (9.0 Mtr long) swan neck type complete with CL base plate and final and single swan neck including foundation and coping.

Supply and fix LED street light 60 Watt IP 65

Supply laying and testing cable X LPE insulated screened, PVC bedded galvanized steel strip or wire armoured electric power cable (Heavy duty) 1100 volts grade with stranded aluminum conductor of size 10 Sqmm 4 Core

M&L for wiring for electrical circuit/submain wiring alongwith earth wire with the following sizes of FR PVC insulated copper conductor single core cable in steel Tubular poles for making electric connection from PVC junction box and upto street light on top of the pole using 2 x 1.5 Sqmm + 1 x 1.0 Sqmm as earth wire

M&L for fixing along poles for making electrical termination (Incoming armoured cable and outgoing PVC insulated copper conducts cable) FRP based junction/termination box comprising of SPN type AI busbar of suitable rating and one Nos MCB SP 2.5 Amp. The junction Termination box should be fixed along pole above 1.5 Mtr from clear ground level using two Nos of MS Clamps necessary nuts bolts and washers etc complete.

Supply and fix time switch 415 volts three phase of 20 Amp rating with contactor fitted inside steel enclosure.

M&L earthing complete with galvanized GI earth plate electrode of size 600 x 600 x 6.00 mm, buried directly in ground earth pit not less than 2.25 mtrs below normal ground level) with top edge of earth plate not less than 1.5 mtr below normal ground level, connected to galvanized earth lead wire 4.0 mm dia by means of bolts, nuts, check nuts of galvanized iron or steel including excavation and earth work in any type of soil, charcoal salt filling 15 cm around the earth plate as shown in electrical plate No. 3 of SSR Part-I 2004, 20mm bore, GI watering pipe medium grade 1.50 mtr long & GI protection pipe light grade 15mm dia fromearth pit to main board including making pit with PCC 1:3:6 type C1 and pre cast RCC cover 40mm thick, reinforced with 8mm dia deformed bars @ 100mm c/c both ways with lifting handles and funnel etc including testing as directed.

M&L Air termination, Single pointed copper rod 12 mm and 300 mm long

M&L Copper strip 20x3.15 mm with saddles and fixing screws etc for roof conductors and condutors above ground

M&L for Earthing complete with super power galvanised earth electrode GI pipe medium grade of size 300 mm x 110 mm dia filled with chemicals burried directly in ground by means of bolt, nuts, check nuts of galvanized iron or steel with GI protection pipe light grade 40 mm dia from earth pit to testpoint including making pit with PCC1:3:6 type C1 and per cast RCC cover 40 mm thick reinforced with 8 mm deformed bars @ 100 mm c/c both ways with lifting handles etc including testing as directed.

S&F 240V Single pole and neutral enclosure with a two pin and earth plug and socket complete with one single pole MCB 20A

M&L for wiring for circuit/submain wiring alongwith earth wire with the following sizes for FR PVC insulated copper conductor, single core cable in surface/recessed as required in PVC Casing and caping with 2 x 4.0 Sqmm + 1 x 2.5 Sqmm earth wire

Supplying, installing & testing of Water heater storage type, electric supplied and installed complete of capacity 25 litres

S&F Galvanised steel tubes, medium grade of 20mm dia

Supply and lay Galvanised steel tubes, medium grade of 15mm dia, complete all as specified and directed.

M&L Gun-metal globe or gate valves, with iron wheel head, 20mm screwed both ends for iron pipe and fixed, complete all as specified and directed.

S&F Bib taps, cast copper alloy with crutch or butterfly handle, screwed down, screwed for iron pipe or for brass ferrule and fixed fancy type of 15mm dia, complete all as specified and directed.

Supply and fix shadow less light fittings complete with emergency power unit and battery back up for 30 minutes (3 KVA) having following specifications : Aerodynamically designed ceiling suspended surgical light based on LED technology . The light head consists of several symmetrically arranged light emitting modules, using multitudinous - 02 or 3 colour LED'S to form a multi-lens matrix for a shadow free and homogeneous illumination of the surgical field. Surgical light consisting of : Central axis horizontal extension arm, height adjustable spring arm, vertical and horizontal bow and the one point suspended light head (minimum two domes required). Suspension system : Main light on lower most axis operation range : 2000 mm or more. All arms are freely rotatable (without stop) at all vertical joints. lighting intensity and homogeneous large area and in-depth illumination of the surgical field through multi lens matrix technology. There should be a sterilized handle in the centre of the light head for manipulation of the light head dome. The control panel should be attached to the light dome handle for ease of use it should have the adjustments for brightness control, colour temperature and field size diameter adjustments all in various steps. The light domes should have an endo function controlled from a single switch on the control panel, so as to have bare minimum lighting in the OT to facilitate certain procedures.

It should also be possible to control the intensity colour temperature and field size diameter adjustment all in various steps. The light dome should have endo function controlled from a single switch on the control panel so as to have bare minimum lighting in the OT to facilitate certain procedure it should also be possible to control the intensity colour temperature and field size with a cord less remote control hand set so as not to disturb the sterile area. The colour temperature of the light should remain be constant in all dimming levels and not subject to unwanted charges. It should have a colour temperature ranging from 3500-5000 Kelvin, adjustable in various steps. Each light dome should have at least 2 yoke handles for ease of maneuverability. Minimum size of the light dome should be 810 mm Light intensity at 1 mtr distance : At least 160000 lux on each dome. Size of the light field at 1 mtr distance : At least 150 mm to 300 mm illumination depth : Should be minimum 1200mm Colour Rendering index (Ra) : Minimum 94 Temperature increase at surgeon head and surgical site : max 1o C life span of LED’S > 30000 hours Supply voltage : 220-240 volts AC it should be possible to integrate the light control with the central control console of the operation theater if need arises in future.

HD Camera comprising the following specifications : The camera should be fitted in the center of the light domewith sterilizable handle the camera should be a HD (High Definition) camera having the following specifications: (i) Image sensor : ½.5” CMOS (ii) Effective number of Pixels : 2 Million Pixels (iii) Colour Temperature : A-4300 B-3500,4000,4500,5000 (iv) Single system : 1080 i (V) Resolution : 1920 X 1080 (vi) Lens : 10 X (Digital Zoom) (vii) Focal : F-6.3-63mm (viii) Opening : F=1.8-2.5 (ix) Automatic Focal : Integrated (x) Sensitivity : 0.1 Lux (xi) White balance :ATW/AWC/MWB/Outdoor/indoor/ flourocerst light / MWB model RB Single adjustable (xii) Minimum Object Distance : 800mm distance (xiii) Signal/noise ratio : > 50 dB (xiv) Output Connection : 1.5 DI, 2DIV, 3 HDMI (xv) Control box : Wired control (xvi) Monitor : 32” LED monitor wall mounted (xvii) Recording system : Recording system for the above with the facility to record in DVD Make for LED based shadow less light fittings as under :- M/s Philips, siemens or equipment in specifications

M&L for wiring (sub main wiring) for circuit / Sub main wiring along with earth wire the following size of FR PVC insulated copper conductor single core cable in surface / recessed as required in PVC conduit using 2 X 2.5 Sqmm + 1 X 1.5 Sqmm earth wire, complete all as specified and directed.

M & L for sheet metal enclosure with socket plug top and MCB single pole and neutral enclosure with a two pin and earth plug and socket complete with one single pole MCB of rating 20 AMP, complete all as specified and directed.

india trading company

M/S ABDHESH CONSTRUCTION

BHARATI ENTERPRISES