Loading…
Loading…
Tender Value
₹3.5 Cr
EMD Value
₹7.1 L
Closing Date
12 May 2026, 12:00 pmClosed
No
No
Single Packet System
Normal Tender
No
Not Applicable
Lowest to Highest
60 days
Expenditure
Capital (Works)
S AND T
14 conditions · 2 needing a document upload
Financial Eligibility Criteria ( para 10.2 of GCC 2022 )The tenderer must have minimum average annual contractual turnover of V/N or V whichever is less, where V= Advertised value of the tender in crores of Rupees N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per Annexure-VIB, along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/ Certificate from Chartered Accountant duly supported by Audited Balance Sheet. (Ref:GOI, Ministry of Railways, Railway Board, New Delhi. Advance Correction Slip No.1 of IRGCC ,April 2022 Lr.No.2022/CE- I/CT/GCC-2022/Policy Dt:14.07.2022 )
Technical Eligibility Criteria ( 10.1 part 1 of GCC 2022) (a)The tenderer must have successfully completed or substantially completed any one of the following categories of work(s) during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: (i)Three similar works each costing not less than the amount equal to 30% of advertised value of the tender, or (ii)Two similar works each costing not less than the amount equal to 40% of advertised value of the tender, or (iii)One similar work costing not less than the amount equal to 60% of advertised value of the tender. (b)(1) In case of tenders for composite works (e.g. works involving more than one distinct component, such as Civil Engineering works, S&T works, Electrical works, OHE works etc. and in the case of major bridges - substructure, superstructure etc.), tenderer must have successfully completed or substantially completed any one of the following categories of work(s) during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: (i)Three similar works each costing not less than the amount equal to 30% of advertised value of each component of tender, or (ii)Two similar works each costing not less than the amount equal to 40% of advertised value of each component of tender, or (iii)One similar work each costing not less than the amount equal to 60% of advertised value of each component of tender. Note for b(1): Separate completed works of minimum required values shall also be considered for fulfillment of technical eligibility criteria for different components. (b)(2)In such cases, what constitutes a component in a composite work shall be clearly pre- defined with estimated tender cost of it, as part of the tender documents without any ambiguity. (b) (3) To evaluate the technical eligibility of tenderer, only components of work as stipulated in tender documents for evaluation of technical eligibility, shall be considered. The scope of work covered in other remaining components shall be either executed by tenderer himself if he has work experience as mentioned in clause 7 of the Standard General Conditions of Contractor through subcontractor fulfilling the requirements as per clause 7 of the Standard General Conditions of Contract or jointly i.e., partly himself and remaining through subcontractor, with prior approval of Chief Engineer in writing. However, if required in tender documents by way of Special Conditions, a formal agreement duly notarised, legally enforceable in the court of law, shall be executed by the main contractor with the subcontractor for the component(s) of work proposed to be executed by the subcontractor(s), and shall be submitted along with the offer for considering subletting of that scope of work towards fulfilment of technical eligibility. Such subcontractor must fulfill technical eligibility criteria as follows: The subcontractor shall have successfully completed at least one work similar to work proposed for subcontract, costing not less than 35% value of work to be sub letted, in last 5 years, ending last day of month previous to the one in which tender is invited through a works contract.
Defination of Similar Work :- Any work involving supply, installation, testing & commissioning of CCTV Surveillance system or Audio video conferencing system in Railways , Airports, any Central/State government offices or Central/State Public sector undertakings
14 conditions · 6 needing a document upload
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.
I/We have visited the works site and I/ We am/ are aware of the site conditions and IRGCC 2022,Correction slips of the GCC.
Proposed works for Godavari Pushkarams -2027 : 1)Crowd control measures and creation of additional holding area at Bhadrachalam Road.2)Infrastructure development works: Proposed improvements to Circulating area, parking on 2nd entry side, Approach Roads, provision of temporary staff accommodation duly utilizing as additional passenger interface/amenity assets at Bhadrachalam Road.3) Improvements to water supply arrangements by construction of Overhead water storage tank 1lakh litres capacity (2No.s), GLR (500KL capacity), Provision of booking office towards 2nd entry, Additional booking office at main entry, PF shelter (3bay ) on PF -2 , Vehicle parking area, sheds for passengers in holding area water pedestals at Bhadrachalam Road.4) Telecom Proposal for Provision of divyangjan amenities to meet short term targets in Sr.DEN /South section Section. 5) Proposed improvements to circulating area & PF-1 surface, station building Facade, construction of New block for Dormitory & Retiring,CCI & HI Rooms, TTE Rest Rooms at Bhadrachalam Road station under Amrit Stations Phase-I (Additional work) 6)Telecom Proposal for Provision of left over divyangjan facilities (Accessible route with tactile guidance, Tactile flooring for platform zoning, Contrasting Colour Scheme for structural elements & Platform edge Strips ) to meet short term target under Sr.DEN/North/SC section.
C_SG_36_599
C_SG_36_599
Open
Works - General
12 Months
Hyderabad, Telangana
₹0
₹7.1 L
12 May 2026
20 Apr 2026
28 Apr 2026
147 items across 4 schedules · ₹3,54,54,689.31 total
| # | Description | Unit | Qty | Rate | Amount |
|---|---|---|---|---|---|
| 1 | Supply of Permanently lubricated HDPE Duct with outer diameter of 40mm and inner diameter of 33mm as per specification RDSO/SPN/TC/45/2013 Revision 2.0. The length of the duct shall be 1km. Two end plugs shall be provided along with the drum. ( TO BE INSPECTED BY CONSIGNEE) | Kilometre | 7.00 | 66,223 | 4,63,561 |
| 2 | "Supply of Cable Route Locator set consisting of receiver withactive line trace frequency, passive line trace and depthmeasurement on active line tracing with 5 watts cable line transmitter with frequency indicator, power indicator, frequencymode sheet, power 'ON' & 'OFF' indicator mode toggle.induction mode. High voltage warning and suitablerechargeable cells for both transmitter and receiver withsuitable charger with carrying case. Make RIDGID SeeklechSR-201 Stanlay ST- Loc 10 or equivalent or better as approved by Engineer In charge.( TO BE INSPECTED BY CONSIGNEE) | Numbers | 1.00 | 3,77,600 | 3,77,600 |
| 3 | Supply of 50 pair 0.5 mm Dia Polythene insulated, polythene sheathed, jelly filled under ground telephone cable with poly alluminium moisture barrier, anneled copper conductor double steel tape armoured with polythene jacketed as RDSO specn, No.IRSTC:41/97 with amendment No.2 or latest. Length should be 500 meters per Drum.( TO BE INSPECTED BY CONSIGNEE) | Metre | 500.00 | 304 | 1,52,000 |
| 4 | Supply of GKP type Location Boxes (a) Full size as per drg. No. S&T/MFT/T.2378( TO BE INSPECTED BY CONSIGNEE) | Numbers | 6.00 | 16,216 | 97,296 |
| 5 | Supply of 'E'type lock of specified ward as per requirement with one key E-type lock to DRG. No.SA3376/M or latest and specification IRS: S30-64 or latest( TO BE INSPECTED BY RDSO) | Numbers | 6.00 | 1,051 | 6,306 |
| 6 | Supply of Thermo shrink jointing kit for jointing underground 0.9mm dia conductor 6 quad cable as per specification IRS: TC 77- 2012 Rev. 3 (Amd. ito Amd. 3) or latest. ( TO BE INSPECTED BY CONSIGNEE) | Numbers | 10.00 | 3,715 | 37,150 |
| 7 | Supply of VF Transformer 2T assembly of type 2 with impedance ratio 470: 1120 ohms as per specification IRS: TO 76 -2000 with Amd. 1 or latest.( TO BE INSPECTED BY RITES) | Numbers | 10.00 | 999 | 9,990 |
| 8 | Supply of following type of Terminal block of Wago Make or Similar (with lever type disconnection & reconnection facility) duly fitted in C.T. box of approved quality, suitable for termination of cable from 0.4mm to 0.9mm conductor. 24 pair( TO BE INSPECTED BY CONSIGNEE) | Numbers | 14.00 | 3,240 | 45,360 |
| 9 | Supply of Godrej PCH 5002T model or similar ( TO BE INSPECTED BY CONSIGNEE) | Numbers | 2.00 | 10,671 | 21,342 |
| 10 | Supply of Push button corded auto telephone with Caller ID facility of a) Volume c o n t r o l , b )Incoming & outgoing call memory, c) music on hold, d) selectable ringer melodies. Make : BEETEL, Model : M77/ BPL/ PANASONIC or similar ( TO BE INSPECTED BY CONSIGNEE) | Numbers | 20.00 | 1,495 | 29,900 |
| 11 | Supply of network 8 port Ethernet switch with SFP and loaded with SFP modules rj 45 10m network interface, D-Link or similar. From TTP approved vendor. ( TO BE INSPECTED BY CONSIGNEE) | Numbers | 21.00 | 2,300 | 48,300 |
| 12 | Supply of Rotary duct cutter suitable for cutting HDPE ducts of diameter 20mm to 42mm. The duct cutter shall have a facility of replaceable blades. The blades shall be of high carbon steel ( TO BE INSPECTED BY CONSIGNEE) | Numbers | 20.00 | 1,046 | 20,920 |
| 13 | Supply of Plastic couplers - Slip fit / push type for permanently lubricated HDPE duct. ( TO BE INSPECTED BY CONSIGNEE) | Numbers | 30.00 | 85 | 2,550 |
| 14 | Supply of Four Wire DTMF way station equipment' to RDSO spec. No. TC- 60 / 2007-Amdt-1 (or latest) with telephone to RDSO spec. No.TC-38 /97 (or latest).( TO BE INSPECTED BY RDSO) | Numbers | 20.00 | 5,617 | 1,12,340 |
| 15 | "Desk type 2 wire, 12 way DTMF selective calling group telephone (Selective Calling I Group Telephone) complete as per specification IRS: TO 80-2000 Amd. I or latest with suitable power supply unit." ( TO BE INSPECTED BY RITES) | Numbers | 20.00 | 6,282 | 1,25,640 |
| 16 | Supply of Power Supply Unit for telecom installations of 2A output capacity as per specification IRS: TC 72-97 Amd. I or latest with 12V / 7AH maintenance free battery.( TO BE INSPECTED BY RDSO) | Numbers | 10.00 | 4,265 | 42,650 |
| 17 | Supply of Maintenance Free Batteries of 12V/100AH AMARAJA/ EXIDE/ Panasonic or equivalent brand. ( TO BE INSPECTED BY CONSIGNEE) | Numbers | 20.00 | 11,167 | 2,23,340 |
| 18 | Supply o f C o r e Alignment Fusion Splicing Machine o f model Fujikura 88S+ o r Similar T E C S p e c TEC/GR/OSM-01/04/SEP- 1 2 or latest.( TO BE INSPECTED BY RITES) | Numbers | 4.00 | 2,59,600 | 10,38,400 |
| Schedule total | ₹28,54,645 | ||||
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
HTML
nit.pdf
NIT
MAKEININDIA1_compressed1.pdf MAKE IN INDIA I
ATTACHMENT
ListofAnnexures.pdf
ATTACHMENT
MAKEININDIA2.pdf
ATTACHMENT
DRAWINGS.pdf
ATTACHMENT
Correctionslips.pdf
ATTACHMENT
GCC_April-2022__1.pdf
ATTACHMENT
MAKEININDIA1_compressed1.pdf
ATTACHMENT
Tele_Cir_9-2023.pdf
ATTACHMENT
TenderDocument599.pdf
ATTACHMENT
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .