SPECIAL REPAIR TO BOUNDARY WALL AT CERTAIN PLACES OF INHS ASVINI

Amount

Excavating in trenches n exc 1.5m wide & n exc 1.5m in depth; for foundation, etc. or for manholes n.exc.10 Sqm on plan and n.exc.1.5m in depth and getting out in hard/ dense soil complete all as specified.

Returning filling in , including spreading, leveling, watering and well ramming in layers not exc 25 cm.

Removing excavated materials (soils) outside MD land complete all as specified. Note: The place of disposal shall be find out by the contractor.

Surface excavation n exc 30cm deep and averaging15cm deep and getting our in any type of soil.

Excavating over areas, n exc 1.5 m deep and getting out in Hard / dense soil complete all as specified and directed by Engr-in-charge. Note :- This excavation is for internal area of perimeter wall which was filled upto the height of boundary wall and need to excavated to resist the earth pressure on boundry wall contractor is requested to visit the site and rate should be quoted accordingly.

Material & labour for PCC 1:3:6 type C2 using (40 mm graded stone aggregate) as in foundation, filling and mass concrete complete all as specified.

Material & labour for 40 mm thick damp proof course to horizontal or vertical surfaces in cement concrete 1:2:4 type B0 (using 12.5 mm graded stone aggregate) mixed with and including WPC @ 3% by weight of cement including neccessary formwork complete all as specified.

Demolition of brick work or stone/boulder masonry, built in cement mortar, including all quoins, arches, pillars etc, but excluding ashlar facings, dressed stone work & precast concrete articles including copings etc.and removing debris outside MD land complete all as specified Note: The place of disposal shall be find out by the contractor.

Material & labour for brick work with sub class 'B' bricks straight or curved on plan exc 6m mean radius built in cement mortar (1:4) complete all as specified.

Material & labour for PCC 1:2:4 type B-1 (using 20mm graded stone aggregate) as in coping, bed plates, bed blocks, kerbs etc. and similar work including weathring slightly rounded or chamfered angles and throating and necessary formwork complete all as specified & directed

Taking down cement plaster of any description on brick or stone walls etc including raking out joints, hacking for key, scrubbing down with water etc and removing debris outside MD land. Note: The place of disposal shall be find out by the contractor.

Material & labour for rendering 15 mm thick on fair faces of brick work or concrete surfaces in CM (1:4) and finished even & smooth without using extra cement complete all as specified.

Material & labour for TMT bars (CRS) 10 mm dia and over cut to length, bent to shape required, including cranking, bending, spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9 mm dia or securing with the clips complete all as specified .

Ditto- all as per item No 13.00 above but 5 mm dia and over upto and including 10 mm dia in stirrups, spacers and binders.

Material & labour for formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams etc, vertical or to batter for rough finished surfaces of concrete flat.

Material & labour for use and waste of formwork to sides of square, rectangular or polygonal pillars, posts, struts, piers, columns and stanchions for rough finished surfaces of concrete flat.

Material & labour for use and waste of formwork for sides and soffits of floor or roof beams, beam haunchings , girders, bressummers, lintels, cantilevers, shelves including supports overhangs, etc also splays between floors and beams etc for rough finished surface of concrete flat complete all as specified.

Material & labour for Reinforced cement concrete (Design Mix) M-30 grade (using 20mm graded stone aggregate) as in foundations, including rafts, footings, foundation beams; plinth beam; bases of coloumn, etc; basement slabs, under-reamed piles and mass concrete complete all as specified and directed by Engr-in-charge.

Material & labour for Reinforced cement concrete (Design Mix) M-30 grade (using 20mm graded stone aggregate) as in beams, cantilevers, bressumers, lintels over 1.5 m span complete all as specified.

Material & labour for Reinforced cement concrete (Design Mix) M-30 grade (using 20mm graded stone aggregate) as in columns, pillars, piers, posts and struts and the like complete all as specified and directed by Engr-in-charge.

Material & labour for preparing new plastered surfaces of wall and applying two coats of weather proof acrylic exterior paint (100% Acrylic) over a coat of self primer including necessary scaffolding and safety arrangement complete all as specified.

Material & labour for taking down carefully existing electric wire fencing fixed above boundry wall and after repairing of boundary wall fix it properly on existing position using necessary new clamps, bolts, nuts etc without making any damage to fence and testing after completion complete all as specified and directed by Engr-in-charge. Note :- Above quoted rates are deemed to secure opening area after demolition of wall during construction of the boundary wall with barbed wire, concertina coils etc with the satisfication of Users security Norms and conditions and as directed by the Engr-in-charge

Bob Enterprises (BID ID -3164170)

Anil Industrial Corporation (BID ID -3158781)

Unitech Enterprises (BID ID -3158658)

N F ENTERPRISES (BID ID -3159037)

satguruenterprises (BID ID -3158485)

GANGAJAL (BID ID -3155745)

SN CONSTRUCTION (BID ID -3158161)