Construction of compound wall around the library building at Raja Nagar, Orleanpet constituency, Puducherry

Amount

Code No.15.7.4:- Demolishing brick work manually / by mechanical means including stacking of serviceable material and disposal of unserviceable material within 50 metres lead - in cement mortar

Code No.2.8.1:- Earthwork in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5m in width or 10 sqm on plan),including dressing of sides and ramming of bottoms, lift upto 1.5m, including getting out the excavated soil and disposal of surplus excavated soil as directed , with in a lead of 50m - all kinds of soil

Code No.20.2.1.2:- Boring , providing and installing bored cast -in-situ reinforced cement concrete piles of grade M-25 of specified diameter and length below the pile cap, to carry a safe working load not less than specified, excluding the cost of steel reinforcement but including the cost of boring , with bentonite solution and temporary casing of appropriate lenghth for setting out and removal of same and the lenghth of the pile to be embedded in the pile cap etc. all complete , including removal of excavated earth with all lifts and leads (length of pile for payment shall be measured upto bottom of pile cap) - 300 mm dia piles -Using Portland Slag Cement

Code No.2.27A.1:- Supplying and filling with gravel (excluding rock ) in trenches, plinth,sides of foundations etc.in layers not exceeding 20cm in depth consolidating each deposited layers by ramming and watering etc.complete including all lead and lift.

code no.4.1.10. Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work upto plith level - 1:5:10 (1 cement : 5 coarse sand : 10 graded stone aggregate 40mm nominal size)

Code No:11.3.1:- Cement concrete flooring 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate) finished with a floating coat of neat cement, including cement slurry, but excluding the cost of nosing of steps etc .complete - 40mm thick with 20mm nominal size stone aggregate

Code No.5.9.5:-Centring and shuttering including strutting, propping etc. and removal of form for: lintels, beams, plinth beams,girders, bressumers and cantilevers.- Using steel sheet with M.S.frames

Code No.5.9.6:- Centering shuttering including struttings,Propping etc. and removal of form work for:Columns, piers, abutments, pillars, posts and struts.- Using steel sheet withM.S.frames

Code No.5.2.2:- Reinforced cement concrete work in walls (any thickness) including attachedpilasters, buttresses, plinth and stringcourses, fillets, columns, pillars,piers,abutme nts,post sand struts etc. upto floor fivelevel excluding cost of centering,shuttering,finishingandreinforcement:1:1.5:3(1cement :1.5coarsesand:3stone aggregate 20mm nominal size)

Code No.5.22.6:-Reinforcement for R.C.C work including straightening , cutting , bending , placing in position and binding all complete - Thermo - Mechanically treated bars (TISCON/ VIZAG / IISCO /SAIL / JSW) including placing the M30 grade Athees make cover block @ 60cm centre to centre

Code No:-6.4.2:- Brick work with common burnt clay F.P.S (non modular ) bricks of class designation 7.5 in superstructure above plinth level upto floor five level in all shapes and sizes in - cement mortar 1:6 ( 1 cement : 6 coarse sand)

Code No. 10.25.2:- Steel work welded in built up sections / framed work , including cutting,hoisting,fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required - in gratings, frames, guard bar, ladder,railings, brackets,gates and similar works

Code No.13.9.2A 15mm cement plaster on the rough side of single or half brick wall of mix 1:5 (1cement : 5 fine sand)

Code no. 13.8.3 12 mm cement plaster of mix 1:5 (1 cement : 5 fine sand)

Code No.13.48.1:- Finishing with deluxe multi surface paint system for interiors and exteriors using primer as per manufacture's specification -Two or more coats applied on walls @ 1.25 ltr / 10 sqm over and including one coat of special primer applied @ 0.75 ltr / 10 sqm

Code No.13.50.3 Applying priming coat: with eadymixed redoxide zinc chromate primer of approvedbrand and manufacture on steel galvanisediron/steel works.

Code No.13.61.1 Painting with synthetic enamel paint of approved brand and manufacture to give an even shade - Two or more coats on new work.

Code No.14.54.1 Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade - One or more coats on old work

Code No.2.35.5 Diluting and injecting chemical emulsion for POST - CONSTRUCTIONAL anti-termite treatment (excluding the cost of chemical emulsion) - treatment at points of contact of wood work by chemical emulsion Chlorpyriphos / Lindane ( in oil or kerosene based solution) @ 0.5 litres per hole by drilling 6mm dia holes at downward angle of 45 degree at 150mm centre to centre and sealing the same.

Code No.2.35.2.1 Diluting and injecting chemical emulsion for POST - CONSTRUCTIONAL anti-termite treatment (excluding the cost of chemical emulsion) - along the external wall below concrete or masonry apron using chemical emulsion @ 2.25 litres per linear metre including drilling and plugging holes etc. - with chlorpyriphosl lindane E.C.20% with 1% concentration.

Code No.16.100 Acid cleaning for the existing Mosaic floors , glazed tiles work and removing the stains and decays to give a glassy look etc complte (The Acid used shall be 32% concentrated hydrochloric acid after taking on the precautionary measures)

Code no: 9.165.1A Providing and fixing of 65mm Godrej Navatal lock of 6 levers etc complete