Remaining Repair and Maintenance work in 6 USQ and 34 LSQ at police thana Bajaj Nagar Jaipur East Commissionerate Jaipur.

Carriage of Earth, Sand, Lime, Morrum manure or sludge etc. including loading and unloading complete with all lead (G-4/4.1.9)

Surface dressing of the ground including removing vegetation and inequalities not exceeding 15cm deep and disposal of rubbish lead up to 50 Mtr. and lift up to 1.5 Mtr.: All kinds of soil (B-1/1.28)

Plaster on new surface on walls in cement sand mortar 1:6 including racking of joint etc. complete fine finish : 25mm thick (B-12/12 .3.1)

Plaster on new surface on walls in cement sand mortar 1:4 including racking of joint etc. complete fine finish : 20mm thick

Repairs to plaster of thickness 12mm to 20mm in patches of area 2.5 sq. metres and under including cutting the patch in proper shape, raking out joints and preparing and plastering the surface of the walls complete including disposal of rubbish to the dumping ground within 50 m lead With cement mortar 1 :4 ( 1 cement : 4 coarse sand) (B-13/13.1)

Dismantling old plaster or skirting, raking out joints and cleaning the surface for plaster including disposal of rubbish to the dumping ground within 50 meter lead. (B-14/14.55)

Cement, Concrete flooring/ cement plaster/ Cement Concret Road, Plain or RCC work & water retaining works providing and mixing Additive of Synthetic polypropylene Fibrillated mesh fibers free form any reprocess Olefins &comfirming to ASTM C 1116 Type III 4.1.3 Having grade 6mm/12mm /18mm melting point of 165 deg.C., strength> 600 mpa Sp. Gravity:0.92g/cc, diameter 10-70 microns. It is required in specified ratio @ 0.25% (125 Gm. Fibers in 50 Kg. cement) for use. Mix it directly with contents in rotating site rmxer direction of Engineer m charge with all leads and lifts. (B- 3/3.9)

Supply of wire mesh expended metal size 20-25mm 18 SWG(G-1220)

Repair to damaged RCC slabs, beams and columns etc for strengthening with cement mortar 1 : 2 in following steps i) Chopping lose and cracked concrete to required depth, cleaning the exposed surface of steel and concrete with wire brush and sand papenng , cleaning of concrete surface with water as necessary and getting dried. ii) Applying Epoxy pnmer on the exposed steel bars. iii) Applying Epoxy hardener and resin mix (as per manufacture's specification) on concrete and steel bars with brush. iv) Spreading dry cement mortar 1 : 2 mix over epoxy treated wet surface and allow it to dry for one day. v) Plastering the surface with cement sand mortar 1 : 3 upto depth of 30mm complete. vi) Cure the plastered surface for 15 days All work including scaffolding etc. complete in all respect. (B-13/13.29)

Providing and fabricating reinforcement for R.C.C. work including straightening, cutting, bending, placing m position and binding (including cost of binding wire) all complete up to floor five level. ('Original producers' who manufacture billet directly from iron ores and roll the bilets to produce steel conforming to IS: 1786) Thermo-mechanically Treated bars (Conforming of relevent IS code) (B-4/4.13.3)