1) Work of laying damaged UG cable on 33 KV line Sarsawa 2) Work of replacement of damaged pole in 33 KV line Hussain Basti 3) Work of replacement of cable from 33 KV line Chakwali 4) Strengthening works 33 KV Line of Kishanpura Saharanpur

1. Supply of following material M.S. Earthing Rod

V Type Cross Arm 33 KV

F Bracket for 33 KV

Danger Board with clamp for PCC Pole 9 M + S.T. Pole 11 M long & 13M long

Number Plate with clamp for PCC Pole 9 M + S.T. Pole 11 M long & 13M long

Aluminum Binding wire

Barbed wire

Red Oxide Paint

Aluminium paint

M.S. Bolts Nuts & Washers

Earth wire clamp with Nut & Bolts

Cable rout marker

Concreting of support

Stone pad (300×300×75)mm

Outdoor type cable jointing kit for 33 kv XLPE cable

G.I pipe 150mm dia 3 mtr long .

Laying of HDPE 80 PN 150mm Pipe

2. Safe carriage of with loading & unloading at both ends respectively. (under jurisdiction of PVVNL) a) Steel Tublar Pole SP-72 13M (Bottom Portion Galvanized)

b) 33 KV Pin Isulators (Polymer)

c) 33KV, 3×300mm² XLPE Cable

Erection of Following material A- Erection of support after excavation of foundation pit in mix soil/normal soil/soft & hard rock and its back filling and leveling etc. The size of the pit will be (900×600)mm and having depth of 1/6th of the full length of the support & Erection of support. The work includes carriage and handling of supports from site store to pit site. 13 M Long STP, SP-72 Round Pole

B- Fixing of all clamps, Cross Bracing Sets 3.5 Mtr. from M.S. Angle 65×65×6mm/50×50×6mm & other accessories on the supports as per drawing. Work includes cutting of holes and providing M.S. Bolts of 16×40mm size in the middle of cross bracing with 1 no. spring washer. The work also includes carriage & handling of accessories from sectional store to pit site as well as any fabrication work if required. 13 M Long STP, SP-72 Round Pole

Grouting of supports in CC 1:4:8 (Cement, sand & 40 mm brick ballast) Grouting will be done in the block of size (450×450)mm ×1/6th of full length of the support, up to ground level, 300 mm plinth above the ground level with C.C. 1:3:6 (Cement, Course sand and Stone grit) with muffing as per drawing, work includes back filling and proper ramming. 13 M Long STP, SP-72 Round Pole

Earthing of supports with MS earth Rod of (20×2500)mm long including excavation of pit and driving M.S. Rod 3.0 M apart from support and 0.5m below the ground level and connecting below the earth electrodes with the help of G.I. wire no. 8 SWG and earthing lugs.

Providing & fixing of danger board at each location as per specification of the drawing with clamps etc.

Painting of following supports/structures with 2 coats of synthetic enamel paint after one coat of ready mix primer including cost of all material, as well as rubbing/cleaning of surface as required for proper completion of work. Painting will be done by post office red paint from top to cross arm and remaining by Aluminium paint. (a) All channels, X-Arms and Clamps of 11 Mtr, SP-55 Poles including all channels/X-Arms/Clamps etc (i) Single supports

Wrapping of barbed wire on 33 KV PCC Poles/SP-55 ST & SP-72 ST Poles as anti-climbing device for a length of 0.9 Mtr., wire pitch/gap 13mm and fixing upper and lower end keeping lower end at a height of 2.75 Mtr. from the ground complete with supply and fixing of lower end & upper end clamps made of M.S. Flat 40×5mm complete with nuts & bolts & all other required material.

Numbering of each supports by preparing background with dark yellow paint in the size of 150mm dia and writing support number 100mm high with black paint.

Supply & Fixing of Stone Pad (300×300×75)mm

H.T. Power Cable Laying : i) Digging of trench of size 900x1050 mm for laying of 33KV cable including loops.

ii) Safely laying of 33KV 3x300mmsq XLPE cable in cable trench by laying 2 No. Cables in each trench. (single circuit laying)

iii) Safe laying of 33KV XLPE cable in Air on D/P / F/P.

iv) Laying of Ist class bricks along the length on both sides and stone slab 650x450x40 as a top cover over the XLPE cable in trench. (Single circuit laying) (as per RESPO Norms)

g) safely laying of HDPE 80 PN 150mm Pipe by trienchless methode in double layer tunnel under railway track for laying 33 KV XLPE cable

33 KV XLPE Cable in HDPE Pipe.

v) Filling river sand in side beneath & around cable in the trench.

v) Back filling of excavated earth in the cable trench up to the ground level and remming properly.

vi) Making of 33KV outdoor type Heat shrink XLPE Cable Box of size 3x185mmsq and crimping of proper size Aluminium lugs. Work includes providing insulating tapes etc.

vii) Fixing 150mm dia 3 mtr long G.I pipe over 33KV 3x300 mm2 XLPE cable before mounting the cable on double pole structure. This work includes supply & fixing of clamps, Nut bolt, sealing of top and bottom of pipe and one end of pipe is to be buried under earth about 500mm including laying of cable in Pipe.

Fixing of Cable Route Marker

Dismentaling of STP Scrap From Site and Cartage to Nearest Store

Rishipal Singh Contractor

Saraswati Electricals & Contractors

SHASHI ENTERPRISES